Variation of Soil Microbial Community and Sterilization to Fusarium oxysporum f. sp. niveum Play Roles in Slightly Acidic Electrolyzed Water-Alleviated Watermelon Continuous Cropping Obstacle.

It is critical to exploit technologies for alleviating watermelon continuous cropping obstacle which frequently occurs and results in the limiting production and economic losses of watermelon. This study aimed to explore the effects of slightly acidic electrolyzed water (SAEW) on watermelon continuous cropping obstacles. The results showed that SAEW significantly improved the growth of watermelon seedlings cultivated in continuous cropping soil and caused a mass of changes to the diversity of the soil microbial community. Compared with Con, SAEW decreased the diversity index of bacteria by 2%, 0.48%, and 3.16%, while it increased the diversity index of fungus by 5.68%, 10.78%, and 7.54% in Shannon, Chao1, and ACE index, respectively. Besides, the enrichment level of Fusarium oxysporum f. sp. niveum (FON) was remarkably downregulated by 50.2% at 14 days of SAEW treatment, which could decrease the incidence of Fusarium wilt disease. The wet and dry weights of FON mycelia in the fluid medium were depressed more than 93%, and the number of FON colonies in continuous cropping soil was reduced by 83.56% with SAEW treatment. Additionally, a strong correlation between watermelon, FON, and SAEW was presented by correlation analysis. Furthermore, the content of endogenous reactive oxygen species (ROS) was over quadruply increased by SAEW, which may contribute to the sterilizing effect of SAEW on FON. Taken together, our findings demonstrated that exogenous SAEW could alter the soil microbial diversity and decrease the accumulation of FON, which improved the growth of watermelon seedlings and finally alleviated continuous cropping obstacles of watermelon.

Rationally Regulating the Mechanical Performance of Porous PDMS Coatings for the Enhanced Icephobicity toward Large-Scale Ice.

Ice accumulation on various surfaces in low-temperature and high-humidity environments is still a major challenge for several engineering applications. Herein, we fabricated a kind of PDMS coating with the introduction of porous structures under the surface by a two-step curing and phase separation method. The coatings with no further surface modification showed good hydrophobicity and icephobicity, and the typical ice adhesion strength was down to 40 kPa with a water contact angle of 116.5°. More than that, the porous PDMS coatings showed extraordinary icephobicity, especially toward large-scale ice (>10 cm2). In this case, the large-scale ice layer can be rapidly removed under a small external deicing force in a form of interface crack propagation rather than whole direct fracture. It was confirmed that by regulating the pore size and porosity of PDMS coatings properly, the stiffness mismatch between coatings and ice can be controlled to induce the initiation of interfacial cracks. On this basis, under the condition of a large-scale icing area, a small external deicing force can cause an increased surface stress concentration, and the formed interface cracks can propagate quickly, resulting in the ice layer falling off easily. In addition, under the influence of the size effect, ice can be removed without an additional force, and the minimum external force (per unit width) can be only 60 N/cm. This paper proposes that prefabricating a large number of microcracks at the interface can significantly weaken the bonding between ice and coatings, that is, reduce the fracture toughness. The new coatings have a remarkable effect toward large-scale icing.