ABSTRACT
The high efficiency of perovskite solar cells strongly depends on the quality of perovskite films and carrier extraction layers. Here, we present the results of an investigation of the photoelectric properties of solar cells based on perovskite films grown on compact and mesoporous titanium dioxide layers. Kinetics of charge carrier transport and their extraction in triple-cation perovskite solar cells were studied by using transient photovoltage and time-resolved photoluminescence decay measurements. X-ray diffraction analysis revealed that the crystallinity of the perovskite films grown on mesoporous titanium dioxide is better compared to the films grown on compact TiO2. Mesoporous structured perovskite solar cells are found to have higher power conversion efficiency mainly due to enlarged perovskite/mesoporous -TiO2 interfacial area and better crystallinity of their perovskite films.
ABSTRACT
Performance of a perovskite solar cell is largely influenced by the optoelectronic properties of metal halide perovskite films. Here we study the influence of cesium concentration on morphology, crystal structure, photoluminescence and optical properties of the triple cation perovskite film. Incorporation of small amount (x = 0.1) of cesium cations into Csx(MA0.17FA0.83)1−x Pb(I0.83Br0.17)3 leads to enhanced power conversion efficiency (PCE) of the solar cell resulting mainly from significant rise of the short-current density and the fill factor value. Further increase of Cs concentration (x > 0.1) decreases the film's phase purity, carrier lifetime and correspondingly reduces PCE of the solar cell. Higher concentration of Cs (x ≥ 0.2) causes phase segregation of the perovskite alongside with formation of Cs-rich regions impeding light absorption.
ABSTRACT
The article presents the results of experimental studies of the dc and high-frequency electrical characteristics of planar microwave diodes that are fabricated on the base of the n-AlxGa1-xAs layer (x = 0, 0.15 or 0.3), epitaxially grown on a semi-insulating GaAs substrate. The diodes can serve as reliable and inexpensive sensors of microwave radiation in the millimeter wavelength range; they sense electromagnetic radiation directly, without any external bias voltage at room temperature. The investigation revealed a strong dependence of the detection properties of the microwave diodes on AlAs mole fraction x: in the Ka microwave frequency range, the median value of voltage responsivity is several volts per watt in the case of GaAs-based diodes (x = 0), and it substantially increases, reaching hundreds of volts per watt at higher x values. Also, a model enabling us to forecast the responsivity of the sensor in other frequency ranges is proposed.
ABSTRACT
Niobium-doped titanium dioxide (Ti1-xNbxO2) films were grown on p-type Si substrates at low temperature (170 °C) using an atomic layer deposition technique. The as-deposited films were amorphous and showed low electrical conductivity. The films became electrically well-conducting and crystallized into the an anatase structure upon reductive post-deposition annealing at 600 °C in an H2 atmosphere for 30 min. It was shown that the Ti0.72Nb0.28O2/p+-Si heterojunction fabricated on low resistivity silicon (10-3 Ω cm) had linear current-voltage characteristic with a specific contact resistivity as low as 23 mΩ·cm2. As the resistance dependence on temperature revealed, the current across the Ti0.72Nb0.28O2/p+-Si heterojunction was mainly determined by the band-to-band charge carrier tunneling through the junction.
