[Effect of morphological changes in the sagittal plane of vertebrae and discs on degenerative kyphodeformity].

OBJECTIVE: To explore the effects of morphological changes such as vertebral wedge deformation and disc degeneration (collapse) on adult thoracolumbar/lumbar degenerative kyphosis(TL/LDK) deformity. METHODS: A retrospective analysis of 32 patients with spinal TL/LDK deformity admitted from August 2015 to December 2020, including 8 males and 24 females, aged 48 to 75(60.3±12.4) years old. On the long-cassette standing upright lateral radiographs, the coronal Cobb angle, sagittal thoracic lumbar/lumbar kyphosis angle(KA) of spine were measured, and the height and wedge parameters of apex vertebral(AV) and two vertebrae(AV-1, AV-2, AV+1, AV+2) above and below AV and the intervertebrae and the intervertebral disc(AV-1D, AV-2D, AV+1D, AV+2D) were evaluated, involving anterior vertebral body height(AVH), posterior vertebral body height(PVH), vertebral wedge angle(VWA), ratio of vertebral wedging(RVW), anterior disc height(ADH), posterior disc height(PDH), disc wedge angle(DWA), ratio of disc wedging(RDW), and DWA/KA. RESULTS: The average angle of kyphosis was (44.2±19.1)°. A significant decrease in anterior height of vertebral was observed compared to the posterior height of vertebral(P<0.005). There was no significant difference in anterior and posterior height of discs. The vertebral wedging ratio/contribution ratio:AV-2(14.98±10.95)%/(14.21±8.08)%, AV-1(21.08±12.39)%/(18.09±7.38)%, AV(26.94±11.94)%/(25.52±8.64)%, AV+1(24.19±8.42)%/(20.82±8.69)%, AV+2(20.56±7.80)%/(15.60±9.71)%, total contribution(94.23±22.25)%, the disc wedging ratio/contribution ratio:AV-2D(2.88±2.57)%/(5.27±4.11)%, AV-1D(1.98±1.41)%/(2.29±2.16)%, AV+1D(-5.54±3.75)%/(-0.57±0.46)%, AV+2D(-8.27±4.62)%/(-1.22±1.11)%, total contribution (5.77±4.79)%. And the contribution rate of AV was significantly higher than that of adjacent vertebral(P<0.05). CONCLUSION: The vertebral body and intervertebral disc shape both have influence on thoracolumbar kyphosis. However, the contribution of vertebral morphometry to the angle of TL/LDK deformity is relatively more important than the disc. The contribution of the wedge change of the AV to the TL/LDK deformity is particularly significant.

Hydrogen Promotes the Effectiveness of Bone Mesenchymal Stem Cell Transplantation in Rats with Spinal Cord Injury.

Although bone mesenchymal stem cell (BMSC) transplantation has been applied to the treatment of spinal cord injury (SCI), the effect is unsatisfactory due to the specific microenvironment (inflammation and oxidative stress) in the SCI area, which leads to the low survival rate of transplanted cells. Thus, additional strategies are required to improve the efficacy of transplanted cells in the treatment of SCI. Hydrogen possesses antioxidant and anti-inflammatory properties. However, whether hydrogen can enhance the effect of BMSC transplantation in the treatment of SCI has not yet been reported. This study was aimed at investigating whether hydrogen promotes the therapeutic effect of BMSC transplantation in the treatment of SCI in rats. In vitro, BMSCs were cultured in a normal medium and a hydrogen-rich medium to study the effect of hydrogen on the proliferation and migration of BMSCs. BMSCs were treated with a serum-deprived medium (SDM), and the effects of hydrogen on the apoptosis of BMSCs were studied. In vivo, BMSCs were injected into the rat model of SCI. Hydrogen-rich saline (5 ml/kg) and saline (5 ml/kg) were given once a day via intraperitoneal injection. Neurological function was evaluated using the Basso, Beattie, and Bresnahan (BBB) and CatWalk gait analyses. Histopathological analysis, oxidative stress, inflammatory factors (TNF-α, IL-1ß, and IL-6), and transplanted cell viability were detected at 3 and 28 days after SCI. Hydrogen can significantly enhance BMSC proliferation and migration and tolerance to SDM. Hydrogen and BMSC codelivery can significantly enhance neurological function recovery by improving the transplant cell survival rate and migration. Hydrogen can enhance the migration and proliferation capacity of BMSCs to repair SCI by reducing the inflammatory response and oxidative stress in the injured area. Hydrogen and BMSC codelivery is an effective method to improve BMSC transplantation in the treatment of SCI.

Fabricating Highly Open Porous Microspheres (HOPMs) via Microfluidic Technology.

Compared to bulk scaffolds and direct injection of cells alone, the injectable modular units have garnered enormous interest in repairing malfunctioned tissues due to convenience in the packaging of cells, improved cell retention, and minimal invasiveness. Moreover, the porous conformation of these microscale carriers could enhance the medium exchange and improve the level of nutrients and oxygen supplies. The present study illustrates the convenient fabrication of poly(lactic-co-glycolic acid)-based highly open porous microspheres (PLGA-HOPMs) by the facile microfluidic technology for cell delivery applications. The resultant monodispersed PLGA-HOPMs possessed particle sizes of ~400 µm and open pores of ~50 µm with interconnecting windows. Briefly, the emulsified oil droplets (PLGA solution in dichloromethane, DCM), wrapped with the 7.5% (w/v) gelatin aqueous phase, were introduced into the 1% (w/v) continuous flowing poly(vinyl alcohol) (PVA) aqueous solution through the coaxial nozzle in the customized microfluidic setup. Subsequently, the microspheres were subjected to solvent extraction and lyophilization procedures, resulting in the production of HOPMs. Notably, various formulations (concentrations of PLGA and porogen) and processing parameters (emulsifying power, needle gauge, and flow rate of dispersed phase) play crucial roles in the qualities and characteristics of the resulting PLGA HOPMs. Moreover, these architectures might potentially encapsulate various other biochemical cues, such as growth factors, for extended drug discovery and tissue regeneration applications.

Advances in Engineered Three-Dimensional (3D) Body Articulation Unit Models.

Indeed, the body articulation units, commonly referred to as body joints, play significant roles in the musculoskeletal system, enabling body flexibility. Nevertheless, these articulation units suffer from several pathological conditions, such as osteoarthritis (OA), rheumatoid arthritis (RA), ankylosing spondylitis, gout, and psoriatic arthritis. There exist several treatment modalities based on the utilization of anti-inflammatory and analgesic drugs, which can reduce or control the pathophysiological symptoms. Despite the success, these treatment modalities suffer from major shortcomings of enormous cost and poor recovery, limiting their applicability and requiring promising strategies. To address these limitations, several engineering strategies have been emerged as promising solutions in fabricating the body articulation as unit models towards local articulation repair for tissue regeneration and high-throughput screening for drug development. In this article, we present challenges related to the selection of biomaterials (natural and synthetic sources), construction of 3D articulation models (scaffold-free, scaffold-based, and organ-on-a-chip), architectural designs (microfluidics, bioprinting, electrospinning, and biomineralization), and the type of culture conditions (growth factors and active peptides). Then, we emphasize the applicability of these articulation units for emerging biomedical applications of drug screening and tissue repair/regeneration. In conclusion, we put forward the challenges and difficulties for the further clinical application of the in vitro 3D articulation unit models in terms of the long-term high activity of the models.

3D bioprinting of conductive hydrogel for enhanced myogenic differentiation.

Recently, hydrogels have gained enormous interest in three-dimensional (3D) bioprinting toward developing functional substitutes for tissue remolding. However, it is highly challenging to transmit electrical signals to cells due to the limited electrical conductivity of the bioprinted hydrogels. Herein, we demonstrate the 3D bioprinting-assisted fabrication of a conductive hydrogel scaffold based on poly-3,4-ethylene dioxythiophene (PEDOT) nanoparticles (NPs) deposited in gelatin methacryloyl (GelMA) for enhanced myogenic differentiation of mouse myoblasts (C2C12 cells). Initially, PEDOT NPs are dispersed in the hydrogel uniformly to enhance the conductive property of the hydrogel scaffold. Notably, the incorporated PEDOT NPs showed minimal influence on the printing ability of GelMA. Then, C2C12 cells are successfully encapsulated within GelMA/PEDOT conductive hydrogels using 3D extrusion bioprinting. Furthermore, the proliferation, migration and differentiation efficacies of C2C12 cells in the highly conductive GelMA/PEDOT composite scaffolds are demonstrated using various in vitro investigations of live/dead staining, F-actin staining, desmin and myogenin immunofluorescence staining. Finally, the effects of electrical signals on the stimulation of the scaffolds are investigated toward the myogenic differentiation of C2C12 cells and the formation of myotubes in vitro. Collectively, our findings demonstrate that the fabrication of the conductive hydrogels provides a feasible approach for the encapsulation of cells and the regeneration of the muscle tissue.

Integrated transcriptome and proteome analyses identify novel regulatory network of nucleus pulposus cells in intervertebral disc degeneration.

BACKGROUND: Degeneration of intervertebral disc is a major cause of lower back pain and neck pain. Studies have tried to unveil the regulatory network using either transcriptomic or proteomic analysis. However, neither have fully elucidated the exact mechanism of degeneration process. Since post-transcriptional regulation may affect gene expression by modulating the translational process of mRNA to protein product, a combined transcriptomic and proteomic study may provide more insight into the key regulatory network of Intervertebral disc degeneration. METHODS: In order to obtain the proteomic and transcriptomic data, we performed label-free proteome analysis on freshly isolated nucleus pulposus cells and obtained transcriptome profiling data from the Gene Expression Omnibus repository. To identify the key regulatory network of intervertebral disc degeneration in nucleus pulposus cells, we performed bioinformatic analyses and established a protein-RNA interacting network. To validate the candidate genes, we performed in vitro experimentation and immunochemistry labeling to identify their potential function during nucleus pulposus degeneration. RESULTS: The label-free proteome analysis identified altogether 656 proteins, and 503 of which were differentially expressed between nucleus pulposus cells from degenerated or normal disc cells. Using the existing nucleus pulposus transcriptomic profiling data, we integrated the proteomic and transcriptomic data of nucleus pulposus cells, and established a protein-RNA interacting network to show the combined regulatory network of intervertebral disc degeneration. In the network, we found 9 genes showed significant changes, and 6 of which (CHI3L1, KRT19, COL6A2, DPT, TNFAIP6 and COL11A2) showed concordant changes in both protein and mRNA level. Further functional analysis showed these candidates can significantly affect the degeneration of the nucleus pulposus cell when altering their expression. CONCLUSIONS: This study is the first to use combined analysis of proteomic and transcriptomic profiling data to identify novel regulatory network of nucleus pulposus cells in intervertebral disc degeneration. Our established protein-RNA interacting network demonstrated novel regulatory mechanisms and key genes that may play vital roles in the pathogenesis of intervertebral disc degeneration.

A support vector machine and a random forest classifier indicates a 15-miRNA set related to osteosarcoma recurrence.

BACKGROUND: Osteosarcoma, which originates in the mesenchymal tissue, is the prevalent primary solid malignancy of the bone. It is of great importance to explore the mechanisms of metastasis and recurrence, which are two primary reasons accounting for the high death rate in osteosarcoma. DATA AND METHODS: Three miRNA expression profiles related to osteosarcoma were downloaded from GEO DataSets. Differentially expressed miRNAs (DEmiRs) were screened using MetaDE.ES of the MetaDE package. A support vector machine (SVM) classifier was constructed using optimal miRNAs, and its prediction efficiency for recurrence was detected in independent datasets. Finally, a co-expression network was constructed based on the DEmiRs and their target genes. RESULTS: In total, 78 significantly DEmiRs were screened. The SVM classifier constructed by 15 miRNAs could accurately classify 58 samples in 65 samples (89.2%) in the GSE39040 database, which was validated in another two databases, GSE39052 (84.62%, 22/26) and GSE79181 (91.3%, 21/23). Cox regression showed that four miRNAs, including hsa-miR-10b, hsa-miR-1227, hsa-miR-146b-3p, and hsa-miR-873, significantly correlated with tumor recurrence time. There were 137, 147, 145, and 77 target genes of the above four miRNAs, respectively, which were assigned to 17 gene ontology functionally annotated terms and 14 Kyoto Encyclopedia of Genes and Genomes pathways. Among them, the "Osteoclast differentiation" pathway contained a total of seven target genes and was analyzed further. CONCLUSION: The 15-miRNAs-based SVM classifier provides a potential useful tool to predict the recurrence of osteosarcoma. Our results suggest the possible mechanisms of osteosarcoma metastasis and recurrence and provide fresh DEmiRs as potential biomarkers or therapeutic targets for osteosarcoma.