ABSTRACT
With a sharp increase in photovoltaic (PV) installations across the world, PV waste is now a relatively new addition to the e-waste category. From 45,000 tonnes in 2016, the PV waste stream is rapidly increasing and is projected to reach 60 million tonnes by 2050. Backsheets are composite structures made from several material layers of polymer, adhesive, and primer. Widely used PV backsheets can be classified into three core types: (a) KPK (Kynar®/polyethylene terephthalate (PET)/Kynar®), (b) TPT (Tedlar®/PET/Tedlar®), and (c) PPE (PET/PET/ethylvinylacetate). Kynar® and Tedlar® are based on polyvinylidene fluoride (PVDF) and polyvinyl fluoride (PVF), respectively. PPE backsheets are fluorine-free composites made primarily from PET. With increasing focus on the end-of-life (EoL) handling of PV waste, the handling of fluoropolymers, which is largely unexplored, requires closer examination to avoid environmental damage. The aim of this study was to obtain information on the fluorine released from PV backsheet materials into the gas phase during combustion and pyrolysis as EoL pathways. Therefore, several experimental trials were conducted to measure fluorine transfer into the gas phase at 300 °C, 400 °C, 500 °C, and 900 °C (for pyrolysis) and at 750 °C, 850 °C, and 950 °C (for incineration).
ABSTRACT
Solid recovered fuel (SRF) today refers to a waste-derived fuel meeting defined quality specifications, in terms of both origin (produced from non-hazardous waste) and levels of certain fuel properties. Refuse-derived fuel (RDF) nowadays is more used for unspecified waste after a basic processing to increase the calorific value and therefore this term usually refers to the segregated, high calorific fraction of municipal solid waste (MSW), commercial or industrial wastes. In comparison with conventional fuels, both types of secondary fuel show waste of inherently varying quality and an increased level of waste-specific contaminants.The transition from RDF to SRF in the emerging national and European market requires a quality assurance system with defined quality parameters and analytical methods to ensure reliable fuel characterization. However, due to the quality requirements for RDF and SRF, the current standardized analysis methods often do not meet these practical demands. Fast test methods, which minimize personnel, financial and time efforts and which are applicable for producers as well as users can be an important supporting tool for RDF- and SRF-characterization. Currently, a fast test system based on incineration and correlation analyses which enable the determination of relevant fuel parameters is under development. Fast test methods are not aimed at replacing current standardized test methods, but have to be considered as practical supporting tools for the characterization of RDF and SRF.
