ABSTRACT
We report on a fiber-based chirped-pulse-amplification laser system with bulk transmission grating compression to a pulse duration of 357 fs, average power of 175 W, and pulse energy of 233µ J. The compressed pulse train has a beam quality factor M2 of 1.21. The power amplifier is based on a state-of-the-art single-mode photonic crystal rod-type ytterbium-doped fiber operating at 248 W of average power and a repetition rate of 750 kHz. The long-term stability of the laser system has been tested continuously for more than 4000 hours and shows no sign of transverse mode instability.
ABSTRACT
We report a novel, to the best of our knowledge, analysis of high power rod fiber amplifiers by monitoring the cross-polarization of the output. Spatially and temporally resolved imaging of co- and cross-polarizations at high power amplification reveals dynamic eigenmode behavior of the rod fiber. The dynamic of the eigenmodes is caused by the moving refractive index grating written by the modal interference pattern of transverse mode instability and is the first direct observation of this refractive index grating, to our knowledge.
ABSTRACT
In this work we investigate transverse mode instability (TMI) in the presence of pump intensity noise and a controlled perturbation of the input coupling for a rod-type fiber amplifier using spatially and temporally resolved imaging (ST). We show that inherent pump intensity noise from the power supply can define significant peaks in the resulting TMI spectrum. ST measurements show that the TMI in the transition region consists of different orientations of LP11. This finding indicates that the simple picture of TMI being seeded by the combination of a static initial fraction of LP11 and pump or signal intensity noise is not valid for our measurements. Furthermore we present seeding of TMI by perturbing the input coupling dynamically. ST measurements of the resulting TMI as a function of perturbation frequency provides quantitative information regarding the frequency response of the non-linear coupling coefficient. Finally, ST measurements of the resulting TMI as a function of signal power shows that the TMI experiences an exponential gain long before visible beam fluctuations appear.
ABSTRACT
Frequency dynamics of transverse mode instabilities (TMIs) are investigated by testing three 285/100 rod fibers in a single-pass amplifier setup reaching up to ~200W of extracted output power without beam instabilities. The pump power is increased well above the TMI threshold to uncover output dynamics, and allowing a simple method for determining TMI threshold based on standard deviation. The TMI frequency component is seen to appear on top of system noise that may trigger the onset. A decay of TMI threshold with test number is identified, but the threshold is fully recovered between testing to the level of the pristine fiber by thermal annealing the fiber output end to 300°C for 2 h.
