Measurement of the energy distribution of electrons escaping confinement from an electron cyclotron resonance ion source.

Production of high charge state ions in electron cyclotron resonance ion sources (ECRISs) is dependent on the electron energy distribution (EED) within the source plasma. In order to better understand the EED, a measurement of electrons escaping axially from an ECRIS device has been performed at the National Superconducting Cyclotron Laboratory. Electrons were measured escaping from the Superconducting Source for Ions, driven at 18 GHz. Dependencies of the observed EED on the confining magnetic field strength and injected microwave power are reported. This paper focuses on large peaks of electrons in the 400-1200 keV energy range. Measurements of the axial bremsstrahlung spectrum have been simultaneously carried out to provide a direct comparison between both techniques. A comparison between the energy associated with the peak of the electron distribution and the spectral temperature of the bremsstrahlung distribution is shown.

Status of ECR ion sources for the Facility for Rare Isotope Beams (FRIB) (invited).

Ahead of the commissioning schedule, installation of the first Electron Cyclotron Resonance (ECR) ion source in the front end area of the Facility for Rare Isotope Beam (FRIB) is planned for the end of 2015. Operating at 14 GHz, this first ECR will be used for the commissioning and initial operation of the facility. In parallel, a superconducting magnet structure compatible with operation at 28 GHz for a new ECR ion source is in development at Lawrence Berkeley National Laboratory. The paper reviews the overall work in progress and development done with ECR ion sources for FRIB.

Beam simulation studies of ECR beam extraction and low energy beam transport for FRIB.

To meet the beam power requirements of 400 kW at the fragmentation target for facility for Rare Isotope Beams (FRIB), simultaneous acceleration of two-charge states should be used for heavier ions. These intense multi-charged ion beams will be produced by a 28 GHz electron cyclotron resonance (ECR) ion source at a high voltage of 35 kV. After extraction, the ion beam will be pre-accelerated to 12 keV/u with a 50 kV platform, transported down to an achromatic charge state selection (CSS) system followed by a vertical transport line, and then injected into a radio frequency quadrupole accelerator. The TRACK code developed at ANL is used to perform the simulations of the ECR beam extraction and low energy beam transport for FRIB. In this study, we include the magnetic field of ECR ion source into simulations. Different initial beam conditions as well as different space charge neutralization levels are tested for the ECR beamline. The beam loss in CSS system and the corresponding protective measures are discussed. The detailed results about the beam dynamic simulation and beam loss in CSS system will be presented in this paper.

Metallic beam development for the Facility for Rare Isotope Beam.

The Facility for Rare Isotope Beams (FRIB) at Michigan State University (MSU) will accelerate a primary ion beam to energies beyond 200 MeV/u using a superconducting RF linac and will reach a maximum beam power of 400 kW on the fragmentation target. The beam intensity needed from the ECR ion source is expected to be between 0.4 and 0.5 emA for most medium mass to heavy mass elements. Adding to the challenge of reaching the required intensity, an expanded list of primary beams of interest has been established based on the production rate and the number of isotope beams that could be produced with FRIB. We report here on the development done for some of the beam in the list including mercury (natural), molybdenum ((98)Mo), and selenium ((82)Ser).