Loss engineered slow light waveguides.

Slow light devices such as photonic crystal waveguides (PhCW) and coupled resonator optical waveguides (CROW) have much promise for optical signal processing applications and a number of successful demonstrations underpinning this promise have already been made. Most of these applications are limited by propagation losses, especially for higher group indices. These losses are caused by technological imperfections ("extrinsic loss") that cause scattering of light from the waveguide mode. The relationship between this loss and the group velocity is complex and until now has not been fully understood. Here, we present a comprehensive explanation of the extrinsic loss mechanisms in PhC waveguides and address some misconceptions surrounding loss and slow light that have arisen in recent years. We develop a theoretical model that accurately describes the loss spectra of PhC waveguides. One of the key insights of the model is that the entire hole contributes coherently to the scattering process, in contrast to previous models that added up the scattering from short sections incoherently. As a result, we have already realised waveguides with significantly lower losses than comparable photonic crystal waveguides as well as achieving propagation losses, in units of loss per unit time (dB/ns) that are even lower than those of state-of-the-art coupled resonator optical waveguides based on silicon photonic wires. The model will enable more advanced designs with further loss reduction within existing technological constraints.

A reconfigurable architecture for continuously variable optical slow-wave delay lines.

A novel reconfigurable architecture based on slow-wave propagation in integrated optical ring resonators is proposed for the realization of variable optical delay lines. A continuously variable delay is achieved by combining a coarse discrete (digital) delay, provided by a coupled resonator slow-wave structure, with a fine continuous (analog) delay given by a cascaded ring- resonator phase-shifter. The reflective configuration of the structure enables a simple, accurate and robust tuning of the delay and provides a footprint reduction by a factor 2 with respect to conventional coupled resonator optical waveguides. Proof-of-concept devices realized in 4.4% silicon oxynitride waveguides and activated by a thermal control are discussed. Experimental results demonstrate, in both spectral and time domain, a continuously variable delay, from zero to 800 ps (2 bit fractional delay), on a 2.5 Gbit/s NRZ signal, with less than 8 dB insertion loss and less than 5 mm2 device footprint.

Synthesis of a parallel-coupled ring-resonator filter.

An effective and exact synthesis technique for the design of parallel-coupled ring-resonator filters with a maximally flat stop-band characteristic of any order is presented. Simple closed-form formulas determine the Q factor of each resonator and the coupling coefficients. The performances of these filters are discussed for their applications as interleavers and channel-dropping filters in wavelength-division multiplexing systems.

Direct measurement of electrostriction in optical fibers.

The electrostriction contribution to the nonlinear refractive index in optical fiber was theoretically calculated and measured. Nonlinearity was induced directly by insertion of the optical fiber into an intense external electric field. With this technique both the Kerr and the electrostrictive contributions to the intensity dependence of the nonlinear refractive index in a step-index fiber were measured. Good agreement between calculated and measured values was observed. These results should confirm and explain the differences observed in measurement of n(2) at different bit rates.

Measurement of the frequency response induced by electrostriction in optical fibers.

Accurate measurements of the frequency response of the nonlinear refractive index induced by the combined effects of Kerr nonlinearity with electrostrictional excitation of acoustic waves in optical fibers are presented. A detailed experimental investigation of both standard (zero-dispersion wavelength,lambda(0) approximately 1.31microm) and dispersion-shifted (lambda(0)=1.55microm) single-mode fibers showed the presence of several resonant peaks induced by the electrostrictive nonlinearity in the fiber structure. This investigation has provided better insight into the frequency behavior of the electrostriction-induced acoustic waves in optical fibers.

Polarization-independent Kerr coefficient measurement in optical fibers.

A novel cross-phase modulation scheme that permits measurement of the optical Kerr coefficient in nonpolarization-preserving fiber is presented. The scheme is based on a Michelson-type interferometer in which one mirror is replaced by an orthoconjugated mirror. The use of this device leads to an effective insensitivity with respect to the state of polarization of the probe and pump beams.