ABSTRACT
OBJECTIVES: To immobilize Candida rugosa lipase in Accurel MP 1000 (CRL-AMP) by physical adsorption in organic medium and apply in the synthesis of wax esters dodecanoyl octadecanoate 1 and hexadecanoyl octadecanoate 2 in a heptane medium, as well as evaluating the stability and recyclability of CRL-AMP in six reaction cycles. RESULTS: The specific activity (Asp) for CRL-AMP was 200 ± 20 U mg-1. Its catalytic activity was 1300 ± 100 U g-1. CRL-AMP was used in the synthesis of esters in heptane medium with a 1:1 acid:alcohol molar ratio at 45 °C and 200 rpm. In synthesis 1, conversion was 62.5 ± 3.9% in 30 min at 10% m v-1 and 56.9 ± 2.8% in 54 min at 5% m v-1; while in synthesis 2, conversion was 79.0 ± 3.9% in 24 min at 10% m v-1, and 46.0 ± 2.4% in 54 min at 5% m v-1. Reuse tests after six consecutive cycles of reaction showed that the biocatalyst retained approximately 50% of its original activity for both reaction systems. CONCLUSIONS: CRL-AMP showed a high potential in the production of wax esters, since it started from low enzymatic load and high specific activities and conversions were obtained, in addition to allowing an increase in stability and recyclability of the prepared biocatalyst.
Subject(s)
Esters , Lipase , Biocatalysis , Candida/metabolism , Emollients , Enzyme Stability , Enzymes, Immobilized/metabolism , Esterification , Lipase/metabolism , SaccharomycetalesABSTRACT
The present study aimed at preparing three biocatalysts via physical adsorption of lipases from Candida rugosa (CRL), Mucor javanicus, and Candida sp. on a hydrophobic and mesoporous support (Diaion HP-20). These biocatalysts were later applied to the synthesis of aromatic esters of apple peel and citrus (hexyl butyrate), apple and rose (geranyl butyrate), and apricot and pineapple (propyl butyrate). Scanning electron microscopy and gel electrophoresis confirmed a selective adsorption of lipases on Diaion, thus endorsing simultaneous immobilization and purification. Gibbs free energy (∆G) evinced the spontaneity of the process (-17.9 kJ/mol ≤ ∆G ≤ -5.1 kJ/mol). Maximum immobilized protein concentration of 30 mg/g support by CRL. This biocatalyst was the most active in olive oil hydrolysis (hydrolytic activity of 126.0 ± 2.0 U/g) and in the synthesis of aromatic esters. Maximum conversion yield of 89.1% was attained after 150 Min for the synthesis of hexyl butyrate, followed by the synthesis of geranyl butyrate (87.3% after 240 Min) and propyl butyrate (80.0% after 150 Min). CRL immobilized on Diaion retained around 93% of its original activity after six consecutive cycles of 150 Min for the synthesis of hexyl butyrate.
Subject(s)
Enzymes, Immobilized/metabolism , Esters/metabolism , Hydrocarbons, Aromatic/metabolism , Lipase/metabolism , Mucor/enzymology , Saccharomycetales/enzymology , Enzymes, Immobilized/chemistry , Esters/chemistry , Hydrocarbons, Aromatic/chemistry , Hydrophobic and Hydrophilic Interactions , Lipase/chemistry , Particle Size , Surface PropertiesABSTRACT
Short-chain alkyl esters and sugar esters are widely used in the food, pharmaceutical and cosmetic industries due to their flavor and emulsifying characteristics, respectively. Both compounds can be synthesized via biocatalysis using lipases. This work aims to compare the performance of commercial lipases covalently attached to dry acrylic beads functionalized with oxirane groups (lipases from Candida antarctica type B-IMMCALB-T2-350, Pseudomonas fluorescens-IMMAPF-T2-150, and Thermomyces lanuginosus-IMMTLL-T2-150) and a home-made biocatalyst (lipase from Pseudomonas fluorescens adsorbed onto silica coated with octyl groups, named PFL-octyl-silica) in the syntheses of short- and long-chain carboxylic acid esters. Esters with flavor properties were synthetized by esterification of acetic and butyl acids with several alcohols (e.g., ethanol, 1-butanol, 1-hexanol, and isoamyl alcohol), and sugar esters were synthetized by esterification of oleic and lauric acids with fructose and lactose. All biocatalysts showed similar performance in the syntheses of short-chain alkyl esters, with conversions ranging from 88.9 to 98.4%. However, in the syntheses of sugar esters the performance of PFL-octyl-silica was almost always lower than the commercial IMMCALB-T2-350, whose conversion was up to 96% in the synthesis of fructose oleate. Both biocatalysts showed high operational stability in organic media, thus having great potential for biotransformations.
Subject(s)
Carboxylic Acids/chemical synthesis , Enzymes, Immobilized/metabolism , Lipase/metabolism , Biocatalysis , Candida/enzymology , Carboxylic Acids/chemistry , Enzyme Stability , Esterification , Pseudomonas fluorescens/enzymologyABSTRACT
Lipids-rich wastewater was partial hydrolyzed with porcine pancreas lipase and the efficiency of the enzymatic pretreatment was verified by the comparative biodegradability tests (crude and treated wastewater). Alternatively, simultaneous run was carried out in which hydrolysis and digestion was performed in the same reactor. Wastewater from dairy industries and low cost lipase preparation at two concentrations (0.05 and 0.5 percent w.v-1) were used. All the samples pretreated with enzyme showed a positive effect on organic matter removal (Chemical Oxygen Demand-COD) and formation of methane. The best results were obtained when hydrolysis and biodegradation were performed simultaneously, attaining high COD and color removal independent of the lipase concentration. The enzymatic treatment considerably improved the anaerobic operational conditions and the effluent quality (lower content of suspended solids and less turbidity). Thus, the use of enzymes such as lipase seemed to be a very promising alternative for treating the wastewaters having high fat and grease contents, such as those from the dairy industry.
O presente trabalho teve como objetivo o pré-tratamento de efluente da indústria de laticínios na hidrólise de lipídeos, empregando lipase de fonte de células animais de baixo custo disponível comercialmente (pâncreas de porco) na formação de gás metano por biodegradabilidade anaeróbia empregando diferentes concentrações de lipase (0,05 e 0,5 por cento w.v-1). A utilização de lipase no pré-tratamento do efluente acelerou a hidrólise de lipídeos e, conseqüentemente, auxiliou o tratamento biológico resultando na redução da matéria orgânica em termos de Demanda Química de Oxigênio (DQO), cor e sólidos em suspensão como lipídeos. Os melhores resultados em termos de remoção de DQO e cor foram obtidos quando a hidrólise e biodigestão foram realizadas simultaneamente, independente da concentração de lipase empregada. Estes resultados mostram que a hidrólise e biodigestão podem ser realizadas simultaneamente empregando baixa concentração de lipase (0,05 por cento w.v-1), contribuindo para a redução de custo e tempo no processo de biodegradação aneróbia.
ABSTRACT
O objetivo deste trabalho foi verificar o efeito do cloreto de sódio em substituição à goma arábica, na redução do teor de lipídeos presentes em efluentes de laticínios empregando duas preparações de lipases pancreáticas adquiridas no mercado nacional (Kin Master - LKM e Nuclear- LNU). A preparação enzimática LNU foi mais eficiente na redução de proteínas e lipídeos, mostrando ser uma alternativa promissora para uso no pré-tratamento de águas residuárias com elevado teor desses compostos.