Two green and sensitive spectrofluorimetric approaches for determination of Ambroxol and guaifenesin in their single and combined pharmaceutical formulations.

Ambroxol hydrochloride (AMX) and guaifenesin (GFN) are approved drugs utilized to treat coughs through their potent mucolytic and expectorant properties. Due to their massive, combined administration in many illnesses, there is a persistent need for their concurrent estimation in different pharmaceutical formulations. Two sensitive, environmentally friendly spectrofluorimetric methods were developed. AMX was determined using the first method (I) without interference from GFN. This method depends on the quenching of Erythrosine B (EB) native fluorescence at 552 nm after excitation at 527 nm due to the formation of a non-fluorescent AMX-EB ion-pair complex in Britton-Robinson buffer (BRB) solution pH (3.5). The concentration plot is linear over the 0.25-5.0 µg/mL range, with a mean percent found value of 99.74%. Method (II) depends on measuring the native fluorescence of aqueous GFN solution at two analytical wavelengths, either 300 or 600 nm, after excitation at 274 nm. Relative fluorescence intensity (RFI)-concentration plots are linear over the ranges of 0.02-0.5 and 0.1-2.0 µg/ml, with mean percent found at 99.96% and 99.91% at dual wavelengths, respectively. The proposed methods were successfully applied to assay both drugs in raw materials and different single and combined pharmaceutical formulations. These methods have been thoroughly validated following International Committee on Harmonisation (ICH) guidelines. National Environmental Methods Index, Analytical Eco-Scale, and Green Analytical Procedure Index were used to prove greenness, thereby enhancing their applicability. The proposed techniques provide straightforward, precise, and cost-effective solutions for routine formulation analysis in quality control laboratories.

Three techniques for the determination of perindopril through derivatization with 4-chloro-7-nitrobenzo-2-oxa-1,3-diazole.

In addition to its pure form, three accurate, rapid, and simple methods have been established for determining perindopril (PRD) in its tablet form. At pH 9.0 using a borate buffer, developing the three designated methods was successful according to the reaction between PRD and 4-chloro-7-nitrobenzo-2-oxa-1,3-diazole (NBD-Cl) and the formation of a chromogen (with a yellow color) measurable at 460 nm using the spectrophotometric method (Method I). In addition, the produced chromogen was assessed using the spectrofluorimetric method (Method II) at 535 nm following excitation at 461 nm. Afterward, the same reaction product was separated and determined using the HPLC method with fluorescence detection (Method III). A Promosil C18 stainless steel column (Q7 5 mm particle size, 250-4.6 mm) has proven suitable for separation. The mobile phase adjustment was made at pH 3.0, with a 1.0 mL min -1 flow rate; its composition was methanol-sodium dihydrogen phosphate, 0.02 M (60: 40, v/v). Through concentration ranges of 5.0-60.0, 0.5-6.0, and 1.0-10.0 µg mL-1, the calibration curves were rectilinear for Methods I, II, and III, respectively, with limits of quantification (LOQ) of 1.08, 0.16 and 0.19 µg mL-1 as well as limits of detection (LOD) of 0.36, 0.05 and 0.06 µg mL-1. The developed methods were implemented to estimate PRD in tablets, and a comparison between the obtained outcomes utilizing the developed methods as well as obtained from the official method revealed that they were comparable. The official BP method was based on dissolving PRD in anhydrous acetic acid and titrating with 0.1 M perchloric acid, then the potentiometric determination of the end-point. The designated methods were also implemented in content uniformity testing with satisfying results. The reaction pathway proposal was speculated, and according to ICH Guidelines, the statistical evaluation of the data was performed. The three proposed methods were confirmed to be green, eco-friendly and safe to environment using Green Analytical procedure index (GAPI) method.

Evaluation of efficiency of insulin suppository formulations containing sodium salicylate or sodium cholate in insulin dependent diabetic patients.

Two formulations of insulin suppositories were prepared to contain different amounts of sodium salicylate and sodium cholate as absorption promoters and also of insulin with the purpose of obtaining the most effective formulation in reducing plasma glucose levels after rectal administration to diabetic patients. The results show that insulin suppositories containing 100 mg sodium salicylate and 100 or 200 U of crystalline insulin showed no significant difference in AUC, Cmax and Tmax and both formulations showed significant reduction in plasma glucose level compared to initial values within 1.5-2 h. The results from experiments carried out in health volunteers showed that 100 mg sodium salicylate is the optimum amount to be included in insulin suppositories producing significantly higher Cmax and AUC compared to those produced after rectal administration of insulin suppositories containing 50 or 200 mg sodium salicylate. The results also show that using sodium cholate in 50 mg amount did not produce any significant reduction in plasma glucose levels of insulin dependent diabetic patients given suppositories containing 100 U of insulin, but this amount in suppositories containing 200 U of insulin was able to produce significant (p < 0.05) reduction in plasma glucose level within 1 h which lasted till end of experiment producing Cmax of 29.7 +/- 6.61% at Tmax of 1.5 +/- 0.61 h. On increasing the amount of sodium cholate to 100 mg in the suppositories, a marked (p < 0.01) reduction in plasma glucose level took place and the Cmax increased to 47.7 +/- 12.24% at Tmax of 1.5 +/- 0.63 h. This resulted in AUC of 86.7 +/- 22.4 mg%h which was non significantly higher from that produced after administration of suppositories containing 50 mg sodium cholate and 200 U insulin (62.5 +/- 17.6 mg%h). The results also show that insulin suppositories containing 100 mg sodium cholate and 200 U insulin resulted in a non significant differences in Cmax and AUC from those produced by S.C. injection of insulin (20 U) but significantly (p < 0.001) shorter Tmax. This formulation also shows non significant differences in Tmax and AUC and significantly (p < 0.05) higher Cmax than from those produced after rectal administration of suppositories containing 100 mg of sodium salicylate and same amount of insulin. Further more this formulation produced severe hypoglycemia in control healthy volunteers within 1 h of administration producing Cmax of 57.0 +/- 18.8% at Tmax of 0.75 +/- 0.35 h. The results of this study showed that the formulation containing 100 mg of sodium cholate and 200 U of insulin tested in fasted insulin dependent diabetic patients produced a maximum % reduction in plasma glucose levels (Cmax) of 47.7 +/- 12.24% at tmax of 1.5 +/- 0.63 h compared to Cmax of 50.56 +/- 6.8% at tmax of 2.93 +/- 0.19 h resulted after subcutaneous injection of 20 U insulin. These suppositories produced an area under the curve (AUC) of 87 +/- 22.4 mg%h compared to an AUC of 81 +/- 13.4 mg%h obtained after subcutaneous injection. This formulation of suppositories studied in 7 insulin dependent diabetic patients was found to abolish the 2-h post-prandial significant rise in plasma glucose levels after meal. These results show that these insulin suppositories containing 100 mg of sodium cholate and 200 U of insulin can serve as effective buffer against meal related hyperglycemia. The suppositories were safe, effective, accepted and well tolerated by the tested individuals.