ABSTRACT
We propose a bottom-up procedure to fabricate an easy-to-engineer graphene-based device, consisting of a microstrip-like circuit where few-layer graphene nanoplatelets are used to contact two copper electrodes. The graphene nanoplatelets are obtained by the microwave irradiation of intercalated graphite, i.e., an environmentally friendly, fast and low-cost procedure. The contact is created by a bottom-up process, driven by the application of a DC electrical field in the gap between the electrodes, yielding the formation of a graphene carpet. The electrical resistance of the device has been measured as a function of the gap length and device temperature. The possible use of this device as a gas sensor is demonstrated by measuring the sensitivity of its electrical resistance to the presence of gas. The measured results demonstrate a good degree of reproducibility in the fabrication process, and the competitive performance of devices, thus making the proposed technique potentially attractive for industrial applications.
ABSTRACT
A set of epoxy resin composites filled with 0.25-2.0 wt.% of commercially available ENSACO carbon black (CB) of high and low surface area (CBH and CBL respectively) has been produced. The results of broadband dielectric spectroscopy of manufactured CB/epoxy below the percolation threshold in broad temperature (200 K to 450 K) and frequency (20 Hz to 1 MHz) ranges are reported. The dielectric properties of composites below the percolation threshold are mostly determined by alpha relaxation in pure polymer matrix. The glass transition temperature for CB/epoxy decreases in comparison with neat epoxy resin due to the extra free volume at the polymer-filler interface. At room temperature, the dielectric permittivity is higher for epoxy loaded with CBH additives. In contrast, at high temperature, the electrical conductivity was found to be higher for composites with CBL embedded. The established influence of the CB surface area on the broadband dielectric characteristics can be exploited for the production of effective low-cost antistatic paints and coatings working at different temperatures.
ABSTRACT
This work introduces an experimental activity related to the realization of an epossidic nanostructured material that develops the function of covering for electronic circuits in aeronautical field. This covering meets the demand of protection of these circuits from possible troubles of electromagnetic nature. In order to realize this covering we used an epoxy resin as matrix (Epon 828) loaded with conductive nanofillers or carbon nanotubes (Cnts). To check the efficiency of the coating we have considered the carbon black, filler widely used as a conductive covering for screenings. We have considered different percentages of the different fillers, precisely 0.1%, 0.25% and 0.5% wt (% valued in comparison to the weight of the resin). From every mixture 12 samples have been obtained (the size of every sample is 10 mm x 10 mm x 10 mm). Every sample has been subjected to electrical measurements, that have concerned the measurement of current intensity and resistance (so as to allow the evaluation of the enhancement of the conductivity), through the application of different values of voltage. The results have demonstrated that the epoxy matrix loaded with Cnts yields higher values of electrical conductivity than the same matrix loaded with carbon black.
