ABSTRACT
HYPOTHESIS: Cation exchange membranes (CEMs) are subject to fouling when utilized to desalinate wastewater from the oil and gas industry, hampering their performance. The kind and extent of the fouling are most likely dependent on the composition of the stream, which in practical applications can vary significantly. EXPERIMENTS: Fouling experiments were performed on commercial cation exchange membranes, which were used in electrodialysis runs to desalinate solutions of varying composition. The variations included ionic strength, type of ions, amount of viscosifying polyelectrolyte (partially hydrolyzed polyacrylamide), presence of crude oil, and surfactants. Performance parameters, like electric potential and pH, were monitored during the runs, after which the membranes were recovered and analyzed. FINDINGS: Fouling was detected on most CEMs and occurred mainly in the presence of the viscosifying polyelectrolyte. Under normal pH conditions (pH ~ 8), the polyelectrolyte fouled the concentrate side of the CEMs, as expected due to electrophoresis. However, by applying a current in the opposite direction, the polyelectrolyte layer could be removed. Precipitation occurred mostly on the opposite side of the membrane, with different morphology depending on the feed composition.
ABSTRACT
HYPOTHESIS: Anion exchange membranes (AEMS) are particularly prone to fouling when employed to desalinate polymer flooding produced water (PFPW), an abundant sub-product from the oil and gas industry. The formation of fouling on an AEM will be affected by the composition of the solution, which includes various dissolved salts, partially hydrolyzed polyacrylamide (HPAM), crude oil, and surfactants. EXPERIMENTS: Electrodialysis experiments were performed to desalinate feed solutions with different compositions, aiming to distinguish between their individual and combined effects. The solutions contained diverse mono- and divalent ions. The analysis included data collected during the desalination and characterization of the fouled AEMs by diverse analytical techniques. FINDINGS: HPAM produced the most severe effects in terms of visible fouling and increase of resistance. This polyelectrolyte fouls the AEM by adsorbing on its surface and by forming a viscous gel layer that hampers the replenishment of ions from the bulk solution. Ca and Mg have a large influence on the formation of thick HPAM gel layers, while the oily compounds have only a minimal influence acting mainly as a destabilizing agent. The membranes also presented scaling consisting of calcium precipitates. The effects of the gel layer were minimized by applying current reversal and foulant-free solution.
