Photocatalytic Hydrogen Evolution Activity of Nitrogen/Fluorine-Codoped Rutile TiO2.

The development of a photocatalyst capable of evolving H2 from water under visible light is important. Here, the photocatalytic activity of N/F-codoped rutile TiO2 (TiO2:N,F) for H2 evolution was examined with respect to metal cocatalyst loading and irradiation conditions. Among the metal species examined, Pd was the best-performing cocatalyst for TiO2:N,F under UV-vis irradiation (λ > 350 nm), producing H2 from an aqueous methanol solution. The H2 evolution activity was also dependent on the state of the loaded Pd species on the TiO2:N,F, which varied depending on the preparation conditions. Pd/TiO2:N,F prepared by an impregnation-H2 reduction method, showed the highest performance. However, the activity of the optimized Pd/TiO2:N,F toward H2 evolution from an aqueous methanol solution was negligibly small under visible-light irradiation (λ > 400 nm), although the use of an ethylenediaminetetraacetic acid disodium salt as an electron donor resulted in observable H2 evolution. Transient absorption spectroscopy revealed that although a relatively large population of reactive electrons was generated in the TiO2:N,F under 355 nm UV-pulse photoexcitation, the density of reactive electrons generated under 480 nm visible light was lower. This wavelength-dependent behavior in photogenerated charge carrier dynamics could explain the different photocatalytic activities of the TiO2:N,F catalysts under different irradiation conditions.

Fluorine-Assisted Low-Temperature Synthesis of GaN:ZnO-Related Solid Solutions with Visible-Light Photoresponse.

Wurtzite-structured Ga1-xZnx(N,O,F) was successfully synthesized by nitridation of mixtures of a Ga-containing oxide and ZnF2. The addition of ZnF2 lowered the nitridation temperature for the synthesis of Ga1-xZnx(N,O,F) to 823 K, even when bulk ZnGa2O4 was used as a paired precursor. This lowering of the synthesis temperature was ascribed to the enhancement of nitridation through the addition of fluorine. The low-temperature nitridation achieved by the addition of fluorine suppressed the volatilization of Zn compared with that during the synthesis of a GaN:ZnO solid solution by a conventional high-temperature ammonolysis reaction. The higher concentration of Zn, as well as the higher N concentration in Ga1-xZnx(N,O,F) achieved through the fluorine-assisted nitridation, led to a redshift of the absorption edge of Ga1-xZnx(N,O,F) to 560 nm compared with that of GaN:ZnO synthesized by the conventional ammonolysis reaction. The visible-light absorption of Ga1-xZnx(N,O,F) can be used to drive the photoelectrochemical oxidation of water.

Effects of Nitrogen/Fluorine Codoping on Photocatalytic Rutile TiO2 Crystal Studied by First-Principles Calculations.

Nitrogen/fluorine codoping of rutile TiO2 was recently reported to be effective for introducing visible-light absorption, and the resultant TiO2:N,F worked efficiently as an O2 evolution photocatalyst in a Z-scheme water-splitting system. Although an increase in the amount of nitrogen doped into rutile TiO2 lattice in the presence of fluorine was experimentally demonstrated, the role of fluorine in the system remained unclear. Here, we report a computational study on TiO2:N,F through the construction of supercell models with substitutional defects to reveal the atomic arrangement of the material and the electronic band structure. Calculations for all possible structures of nitrogen/fluorine and nitrogen/oxygen-vacancy relative positions revealed that the defect complexes were preferentially located on the (110) plane and that the distance between defects did not have a strong correlation with the formation energy. The present work also showed that although fluorine did not directly contribute to the narrowing of the band gap of TiO2:N,F, the fluorine activity of the synthetic atmosphere promotes the formation of substitutional defect complexes of nitrogen/fluorine for anion sites. This eventually increases the amount of nitrogen incorporated into the rutile TiO2 lattice and also results in reduction of the amount of oxygen vacancy, which is in qualitative agreement with our previous result of transient absorption measurement for rutile TiO2:N,F. The role of fluorine in TiO2:N,F is thus clarified through our systematic first-principles calculations.

Synthesis of Three-Layer Perovskite Oxynitride K2Ca2Ta3O9N·2H2O and Photocatalytic Activity for H2 Evolution under Visible Light.

Substitution of oxide anions (O2-) in a metal oxide for nitrogen (N3-) results in reduction of the band gap, which is attractive in heterogeneous photocatalysis; however, only a handful of two-dimensional layered perovskite oxynitrides have been reported, and thus, the structural effects of layered oxynitrides on photocatalytic activity have not been sufficiently examined. This study reports the synthesis of a Ruddlesden-Popper phase three-layer oxynitride perovskite of K2Ca2Ta3O9N·2H2O, and the photocatalytic activity is compared with an analogous two-layer perovskite, K2LaTa2O6N·1.6H2O. Topochemical ammonolysis reaction of a Dion-Jacobson phase oxide KCa2Ta3O10 at 1173 K in the presence of K2CO3 resulted in a single-phase layered perovskite, K2Ca2Ta3O9N·2H2O, which belongs to the tetragonal P4/mmm space group, as demonstrated by synchrotron X-ray diffraction, scanning transmission electron microscopy measurements, and elemental analysis. The synthesized K2Ca2Ta3O9N·2H2O has an absorption edge at around 460 nm, with an estimated band gap of ca. 2.7 eV. K2Ca2Ta3O9N·2H2O modified with a Pt cocatalyst generated H2 from an aqueous solution containing a dissolved NaI as a reversible electron donor under visible light (λ > 400 nm) with no noticeable change in the crystal structure and light absorption properties. However, the H2 evolution activity of K2Ca2Ta3O9N·2H2O was an order of magnitude lower than that of K2LaTa2O6N·1.6H2O. Femtosecond transient absorption spectroscopy revealed that the lifetime of photogenerated mobile electrons in K2Ca2Ta3O9N·2H2O was shorter than that in K2LaTa2O6N·1.6H2O, which could explain the low photocatalytic activity of K2Ca2Ta3O9N·2H2O.

Mechanistic Insight on the Formation of GaN:ZnO Solid Solution from Zn-Ga Layered Double Hydroxide Using Urea as the Nitriding Agent.

A solid solution of GaN and ZnO (GaN:ZnO) is promising as a photocatalyst for visible-light-driven overall water splitting to produce H2. However, several obstacles still exist in the conventional preparation procedure of GaN:ZnO. For example, the atomic distributions of Zn and Ga are nonuniform in GaN:ZnO when a mixture of the metal oxides, i.e. Ga2O3 and ZnO, is used as a precursor. In addition, GaN:ZnO is generally prepared under a harmful NH3 flow for long durations at high temperatures. Here, a facile synthesis of GaN:ZnO with homogeneous atomic composition via a simple and safe procedure is reported. A layered double hydroxide (LDH) containing Zn2+ and Ga3+ was used to increase the uniformity of the atomic distributions of Zn and Ga in GaN:ZnO. We employed urea as a nitriding agent instead of gaseous NH3 to increase the safety of the reaction. Through the optimization of reaction conditions such as heat treatment temperature and content of urea, single-phase GaN:ZnO was successfully obtained. In addition, the nitridation mechanism using urea was investigated in detail. NH3 released from the thermal decomposition of urea did not directly nitride the LDH precursor. X-ray absorption and infrared  spectroscopies revealed that Zn(CN2)-like intermediate species were generated at the middle temperature range and Ga-N bonds formed at high temperature along with dissociation of CO and CO2.

Water Splitting on Rutile TiO2 -Based Photocatalysts.

Water splitting using a semiconductor photocatalyst with sunlight has long been viewed as a potential means of large-scale H2 production from renewable resources. Different from anatase TiO2 , rutile enables preferential water oxidation, which is useful for the construction of a Z-scheme water-splitting system. The combination of rutile TiO2 with a suitable H2 -evolution photocatalyst such as a Pt-loaded BaZrO3 -BaTaO2 N solid solution enables solar-driven water splitting into H2 and O2 . While rutile TiO2 is a wide-gap semiconductor with a bandgap of 3.0 eV, co-doping of rutile TiO2 with certain metal ions and/or nitrogen produces visible-light-driven photocatalysts, which are also useful as a component for water oxidation in visible-light-driven Z-scheme water splitting. The key to achieving highly efficient water oxidation is to maintain a charge balance of dopants in the rutile, because single doping typically produces trap states that capture photogenerated electrons and/or holes. Here we provide a concise summary of rutile TiO2 -based photocatalysts for water-splitting systems.