A DFT Study on the Co-polymerization of CO2 and Ethylene: Feasibility Analysis for the Direct Synthesis of Polyethylene Esters.

The co-polymerization of CO2 with the non-polar monomer ethylene, though highly desirable, still presents a challenge whereas the palladium-catalyzed CO/C2 H4 co-polymerization is well understood. Building on this analogy, the goal of this study was to elucidate the feasibility of developing suitable catalysts for co-polymerizing CO2 with ethylene to polyethylene esters. Computational methods based on density functional theory were hereby employed. In the search for new catalyst lead structures, a closed catalytic cycle was identified for the palladium-catalyzed CO2 /C2 H4 co-polymerization reaction. The computational study on palladium complexes with a substituted anionic 2-[bis(2,4-dimethoxyphenyl)-phosphine]-benzene-2-hydroxo ligand revealed key aspects that need to be considered when designing ligand sets for potential catalysts for the non-alternating co-polymerization of CO2 and ethylene.

NH3 Synthesis in the N2/H2 Reaction System using Cooperative Molecular Tungsten/Rhodium Catalysis in Ionic Hydrogenation: A†DFT Study.

The ionic hydrogenation of N2 with H2 to give NH3 is investigated by means of density functional theory (DFT) computations using a cooperatively acting catalyst system. In this system, N2 binds to a neutral tungsten pincer complex of the type [(PNP)W(N2)3] (PNP=pincer ligand) and is reduced to NH3. The protons and hydride centers necessary for the reduction are delivered by heterolytic cleavage of H2 between the N2-tungsten complex and the cationic rhodium complex [Cp*Rh{2-(2-pyridyl)phenyl}(CH3 CN)](+). Successive transfer of protons and hydrides to the bound N2, as well as all Nx Hy units that occur during the reaction, enable the computation of closed catalytic cycles in the gas and in the solvent phase. By optimizing the pincer ligands of the tungsten complex, energy spans as low as 39.3 kcal mol(-1) could be obtained, which is unprecedented in molecular catalysis for the N2/H2 reaction system.

Hydrogenation of carbon dioxide to methanol using a homogeneous ruthenium-Triphos catalyst: from mechanistic investigations to multiphase catalysis.

The hydrogenation of CO2 to methanol can be achieved using a single molecular organometallic catalyst. Whereas homogeneous catalysts were previously believed to allow the hydrogenation only via formate esters as stable intermediates, the present mechanistic study demonstrates that the multistep transformation can occur directly on the Ru-Triphos (Triphos = 1,1,1-tris(diphenylphosphinomethyl)ethane) centre. The cationic formate complex [(Triphos)Ru(η2-O2CH)(S)]+ (S = solvent) was identified as the key intermediate, leading to the synthesis of the analogous acetate complex as a robust and stable precursor for the catalytic transformation. A detailed mechanistic study using DFT calculations shows that a sequential series of hydride transfer and protonolysis steps can account for the transformation of CO2via formate/formic acid to hydroxymethanolate/formaldehyde and finally methanolate/methanol within the coordination sphere of a single Ru-Triphos-fragment. All experimental results of the systematic parameter optimisation are fully consistent with this mechanistic picture. Based on these findings, a biphasic system consisting of H2O and 2-MTHF was developed, in which the active cationic Ru-complex resides in the organic phase for recycling and methanol is extracted with the aqueous phase.

Stereocontrol in dinuclear triple lithium-bridged titanium(IV) complexes: solving some stereochemical mysteries.

Compounds 1 a-f-H2 form "monomeric" triscatecholate titanium(IV) complexes [Ti(1 a-f)3](2-), which in the presence of Li cations are in equilibrium with the triple lithium-bridged "dimers" [Li3(Ti(1 a-f)3)2](-). The equilibrium strongly depends on the donor ability of the solvent. Usually, in solvents with high donor ability, the stereochemically labile monomer is preferred, whereas in nondonor solvents, the dimer is the major species. In the latter, the stereochemistry at the complex units is "locked". The configuration at the titanium(IV) triscatecholates is influenced by addition of chiral ammonium countercations. In this case, the induced stereochemical information at the monomer is transferred to the dimer. Alternatively, the configuration at the metal complexes can be controlled by enantiomerically pure ester side chains. Due to the different orientation of the ester groups in the monomer or dimer, opposite configurations of the triscatecholates were observed by circular dichroism (CD) spectroscopy for [Ti(1 c-e)3](2-) or [Li3(Ti(1 c-e)3)2](-). A surprising exception was found for the dimer [Li3(Ti(1 f)3)2](-). Herein, the dimer is the dominating species in weak donor (methanol), as well as strong donor (DMSO), solvents. This is due to the bulkiness of the ester substituent destabilizing the monomer. Due to the size of the substituent in [Li3(Ti(1 f)3)2](-) the esters have to adopt an unusual conformation in the dimer resulting in a stereocontrol of the small methyl group. Following this, opposite stereocontrol mechanisms were observed for the central metal-complex units of [Li3(Ti(1 c-e)3)2](-) or [Li3(Ti(1 f)3)2](-).