Membrane-based pretreatment to mitigate variations in desalination plants.

The main source of potable water in high water-stress areas is commonly produced in brackish and seawater desalination plants. Owing to the presence of high concentration of suspended solids, organic matter and colloidal particles in raw water, pretreatment processes are needed for a stable operation of desalination plants. A submerged membrane ultrafiltration pilot plant has been operated as pretreatment of complex brackish surface water to study the filtration performance. The results show the membrane performance, chemical reagent requirements, water quality and cleaning procedures efficiency of an ultrafiltration pilot plant used as pretreatment for a reverse osmosis system. Alternative chemical cleaning procedures have been satisfactorily implemented, which maximize permeability recovery and allow a stable operation.

Assessment the ecotoxicity and inhibition of imidazolium ionic liquids by respiration inhibition assays.

The ecotoxicity and inhibition of 12 imidazolium ionic liquids (ILs) with alkyl chain from C4 to C10 and chloride (Cl-), tetrafluoroborate (BF4-) and bis(trifluoromethanesulfonyl)imide (NTf2-) anions have been studied by means of respiration inhibition assays using activated sludge collected from a wastewater treatment plant. This test represents an alternative easy, economic and quick way to evaluate the true impact of ILs on activated sludge-based wastewater treatment. For comparison purposes, the EC50 values were also determined by the Microtox test (Vibrio fischeri). It was observed that this widely used microbial test overestimates the effect of the ILs on biological wastewater treatment facilities, especially in the case of ILs with lower ecotoxicity. The results of the biological tests showed that the alkyl chain length plays a crucial role in the ecotoxicity of ILs. A significant increase of the toxicity with the length of the n-alkyl chain was found. Regarding to the impact of the anion, the ecotoxicity measured by respiration inhibition assays follows the order NTf2- > Cl- > BF4-, being the anion effect higher as decreasing the length of cation alkyl chain. According to the hazard substances ranking for aquatic organisms (Passino and Smith, 1987), imidazolium ILs with C4 alkyl chain can be classified as "practically harmless" compounds whereas those with alkyl chains C8 or C10 correspond to "highly toxic" species.

Enhanced anaerobic degradability of highly polluted pesticides-bearing wastewater under thermophilic conditions.

This work presents a sustainable and cost-competitive solution for hardly biodegradable pesticides-bearing wastewater treatment in an anaerobic expanded granular sludge bed (EGSB) reactor at mesophilic (35°C) and thermophilic (55°C). The reactor was operated in continuous mode during 160days, achieving an average COD removal of 33 and 44% under mesophilic and thermophilic conditions, respectively. The increase of temperature improved the biomass activity and the production of methane by 35%. Around 96% of pesticides identified in raw wastewater were not detected in both mesophilic and thermophilic effluents. A dramatic selection of the microbial population in anaerobic granules was caused by the presence of pesticides, which also changed significantly when the temperature was increased. Pesticides caused a significant inhibition on methanogenesis, especially over acetoclastic methanogens. Aerobic biodegradability tests of the resulting anaerobic effluents revealed that aerobic post-treatment is also a feasible and effective option, yielding more than 60% COD reduction.

Fouling control in membrane bioreactors with sewage-sludge based adsorbents.

The potential application of powdered activated carbon (PAC) to mitigate membrane fouling has been tested in membrane bioreactors (MBRs) fed with cosmetic wastewater. Inexpensive powder activated carbon was prepared from sewage sludge biosolids (B-PAC) by pyrolysis (750 °C; 0.5 h) and air-activation (400 °C; 2 h). Adsorption capacities of 143 and 570 mg g-1 were reached for carbohydrates and proteins, respectively, quite similar to those of a commercial activated carbon (C-PAC). To check the effect of PAC addition on membrane fouling, three MBRs were simultaneously operated without (control-MBR) and with PAC (B-MBR and C-MBR) for 150 days in continuous mode at 8 L m-2 h-1 flux. Similar COD removal efficiencies were achieved in these three MBR systems. After 100 days of operation, the effect of the PACs on the sludge filterability was studied in the MBRs for 10 days. B-MBR showed stable transmembrane pressure (TMP) after 9 days of operation, unlike of control-MBR and C-MBR, where the TMP increased after the 2nd and 5th days, respectively. Therefore, operational cost saving can be achieved in the membrane cleaning due to decrease of fouling rate. Operating at stable state condition the addition of PAC gave rise to an increase of the critical flux of 25%. In an extra shear test, carried out at the end of the continuous experiment, a clear reduction in mean size of the flocs from 45 to 28 µm was observed in control-MBR. However, the extra shear led to a slight reduction of the mean size of flocs (less than 5%) in MBRs with PAC, with average sizes of 62 and 71 µm in C-MBR and B-MBR, respectively. The molecular weight fractionation of the MBR demonstrated a higher selectivity of B-PAC toward the adsorption of proteins smaller than 1 µm which prevents the irreversible fouling of the membranes. The membranes lifetime was increased because the B-PAC extended the filtration for a longer period than C-PAC, probably due to its easier in-situ regeneration.

Anaerobic biodegradability of mixtures of pesticides in an expanded granular sludge bed reactor.

The biodegradability and toxicity of three commercial pesticides containing 2-methyl-4-chlorophenoxyacetic acid (MCPA), imidacloprid and dimethoate were evaluated individually, and a complex mixture of these pesticides was treated in an expanded granular sludge bed (EGSB) reactor. MCPA was partially biodegraded, while imidacloprid and dimethoate remained almost unaltered during the individual biodegradability tests. Cyclohexanone was identified as the major solvent in the dimethoate-bearing insecticide, which was completely removed regardless of the presence of other pesticides. The analysis of the inhibition over the acetoclastic methanogenesis showed IC(50) (half maximal inhibitory concentration) values of 474 and 367 mg/L for imidacloprid and dimethoate, respectively. The effect on the methanogenesis was negligible in the case of MCPA and cyclohexanone. Pesticides caused a dramatic decrease of the EGSB reactor performance. After 30 d acclimation, the EGSB reactor achieved a stable chemical oxygen demand (COD) removal efficiency and methane production of around 85% and 0.9 g CH(4)-COD/g COD, respectively, for MCPA, imidacloprid, dimethoate and cyclohexanone feed concentrations of 57, 20, 25 and 27 mg/L, respectively. The presence of complex pesticide mixtures led to synergistic/antagonistic responses, reducing the MCPA biodegradation and improving the removal of the insecticides' active ingredients, which were completely removed in the EGSB reactor.

Low-temperature anaerobic treatment of low-strength pentachlorophenol-bearing wastewater.

The anaerobic treatment of low-strength wastewater bearing pentachlorophenol (PCP) at psychro-mesophilic temperatures has been investigated in an expanded granular sludge bed reactor. Using an upward flow rate of 4 m h(-1), a complete removal of PCP, as well as COD removal and methanization efficiencies higher than 75% and 50%, respectively, were achieved. Methanogenesis and COD consumption were slightly affected by changes in loading rate, temperature (17-28°C) and inlet concentrations of urea and oils. Pentachlorophenol caused an irreversible inhibitory effect over both acetoclastic and hydrogenotrophic methanogens, being the later more resistant to the toxic effect of pentachlorophenol. An auto-inhibition phenomenon was observed at PCP concentrations higher than 10 mg L(-1), which was accurately predicted by a Haldane-like model. The inhibitory effect of PCP over the COD consumption and methane production was modelled by modified pseudo-Monod and Roediger models, respectively.

Application of microbial indices to assess the performance of a sequencing batch reactor and membrane bioreactor treating municipal wastewater.

Microbial indexes of filamentous bacterial density were evaluated for their potential to act as indicators of sludge settling characteristics for sequencing batch reactor (SBR) and membrane bioreactor (MBR) treatment options. These options were operated using settled sewage over a range of aerated loading rates from 0.05 to 0.4/d and the evolution of protozoan and metazoan populations analysed. A filament density score ranging between 0 and 5, which has previously been applied to conventional activated sludge processes, was shown also to be a useful tool for the SBR and MBR, and was correlated to the settleability of the mixed liquor from both reactors. Due to the hydrodynamics of both systems and the subsequent differences in mixed liquors, optimum performance for each bioreactor was obtained under different operating conditions. Although there was no correlation between the numbers of any given protozoan species and plant operating conditions, there was a clear dependence between operating conditions and protozoan diversity. The highest diversity was found when operating conditions were optimum for both the SBR and MBR.

Cosmetic wastewater treatment by upflow anaerobic sludge blanket reactor.

Anaerobic treatment of pre-settled cosmetic wastewater in batch and continuous experiments has been investigated. Biodegradability tests showed high COD and solid removal efficiencies (about 70%), being the hydrolysis of solids the limiting step of the process. Continuous treatment was carried out in an upflow anaerobic sludge blanket reactor. High COD and TSS removal efficiencies (up to 95% and 85%, respectively) were achieved over a wide range of organic load rate (from 1.8 to 9.2g TCODL(-1)day(-1)). Methanogenesis inhibition was observed in batch assays, which can be predicted by means of a Haldane-based inhibition model. Both COD and solid removal were modelled by Monod and pseudo-first order models, respectively.

Cometabolic biodegradation of 4-chlorophenol by sequencing batch reactors at different temperatures.

The simultaneous removal of 4-chlorophenol (4-CP) and phenol in lab-scale sequencing batch reactors at different temperatures has been studied. Phenol feed concentration was fixed at 525 mg/L and 4-CP concentration was increased from 105 to 2100 mg/L at a constant hydraulic residence time (HRT) of 10.5 d. Complete phenol and 4-CP biodegradation was achieved during the aerobic stage working with 4-CP concentrations up to 1470 mg/L in the feed. Both 4-CP and phenol specific initial removal rates were strongly affected by 4-CP feed concentration and temperature. Only at the highest temperature tested (35 degrees C) it was possible to increase the maximum assimilative 4-CP concentration by the biological sludge up to 2100 mg/L, and a significant reduction of the ecotoxicity of the effluents was observed. 4-chlorocatechol (4-CC) was identified as the major intermediate in the aerobic cometabolic 4-CP degradation, being the ecotoxicity of that species substantially lower than that of 4-CP.