ABSTRACT
We present, for the first time based on our knowledge, a novel in-fiber optical phase modulator that is inherently broadband, efficient, and polarization-maintaining (PM). The modulator is a 25 mm long section of a D-shaped cladding PM fiber with half of its silica cladding replaced with an electro-optic (EO) silicone gel. A phase modulation of more than pi rad has been demonstrated. We describe techniques that enable the long-distance exposure of the fiber core, microfabrication of on-fiber electrodes, a low refractive index EO cladding material for replacing silica fiber cladding, and accurate phase measurement utilizing a Sagnac interferometer.
ABSTRACT
Surface-relief fiber Bragg gratings exhibit substantially more polarization dependence than standard fiber Bragg gratings. Using D-fiber with different core orientations, surface-relief gratings are analyzed and fabricated to determine the polarization dependence. We show that the largest Bragg reflection occurs for the polarization state with a dominant TE field component parallel to the flat surface of the fiber. The polarization dependence is adjusted by changing the index of refraction of the surrounding media and by fabricating the surface relief grating using rotated core D-fiber.
ABSTRACT
We present a method for fabricating an in-fiber electro-optic polymer waveguide within a D-shaped optical fiber. A combined process of selective chemical etching and spin coating creates a 2-cm in-fiber poly(methyl methacrylate)-DR1 dye polymer waveguide section with an overall insertion loss of micro 1.6 dB at 1550 nm. Numerical simulations show that, for in-fiber polymer waveguides to have low loss, the polymer layer's thickness must be kept below a certain value so that it will not support slab waveguide modes. Long transition regions between the unetched fiber and the polymer waveguide section also reduce loss. We analyze the efficiency of an in-fiber polymer waveguide by simulating its theoretical performance as an electro-optic modulator.
ABSTRACT
The partial removal of a section of the core from a continuous D-shaped optical fiber is presented. In the core removal process, selective chemical etching is used with hydrofluoric (HF) acid. A 25% HF acid solution removes the cladding material above the core, and a 5% HF acid solution removes the core. A red laser with a wavelength of 670 nm is transmitted through the optical fiber during the etching. The power transmitted through the optical fiber is correlated to the etch depth by scanning electron microscope imaging. The developed process provides a repeatable method to produce an optical fiber with a specific etch depth.
