PANI sensor for monitoring the oxidative degradation of wine using cyclic voltammetry.

Redox species in wine are altered by pH and some wines are easily degraded due to oxidation and sulfur dioxide (SO2) reduction. There is a need for quick, easy, simple, and economical methodologies for pH and wine-oxidized products (acetaldehyde) analysis. This study aimed to measure pH and degradation of wines that were electrochemically analyzed using polyaniline (PANI) sensor. Gas chromatography (GC) and fourier transform infrared spectrometer (FT-IR) were also used. Electrochemical analysis showed that oxidation was accelerated and peak currents (Ip,a) and potentials (Ep,a) shifted to negative direction due to acetaldehyde formation. PANI sensor achieved a limit of detection (LOD) of 7 × 10-1 ppm and a sensitivity of 5.20 µA ppm-1 cm-2. Acetaldehyde formation was confirmed by GC (30%) and FT-IR spectra at 1647 cm-1 to the CO vibration of aldehyde. These results suggested that acetaldehyde degraded the taste of wine after remaining open.

Alginic Acid Beads Containing Fluorescent Solvatochromic Dyes Display an Emission Color Response to a Cationic Surfactant.

Lipophilic fluorescent dyes can be employed as sensors for surfactants present in concentrations above the critical micellar concentration (CMC) where the dyes are monodispersed in micelles. However, the surfactant concentration range over which these dyes are effective is narrowed because by the sigmoidal nature of their responses. To overcome this limitation, we developed a novel sensor material comprised of a labeled fluorescent solvatochromic dye covalently bonded to alginate gel, which is known to strongly adsorb cationic surfactants. We hypothesized that the dye-alginate conjugate would undergo fluorescent color changes in response to binding of surfactants which alter the polarity of the surrounding environment. Indeed, addition of the representative cationic surfactant, cetylpyridinium chloride (CPC), to an aqueous solution of the alginate conjugated fluorescent solvatochromic dye leads to a visible fluorescent color change when the concentration of CPC is below the CMC. The average values of the color appearance parameter, referred to as a hue, of light emitted from gels, calculated by analysis of fluorescence microscopy images using ImageJ software, were found to be approximately linearly dependent on the concentration of CPC encapsulated in the alginate-fluorescent dye complex. This finding shows that absorbed CPC can be quantitatively determined over a wide concentration range in the form of simple fluorescence wavelength or visible responses.

Design, Synthesis, and Antifouling Activity of Glucosamine-Based Isocyanides.

Biofouling, an undesirable accumulation of organisms on sea-immersed structures such as ship hulls and fishing nets, is a serious economic issue whose effects include oil wastage and clogged nets. Organotin compounds were utilized since the 1960s as an antifouling material; however, the use of such compounds was later banned by the International Maritime Organization (IMO) due to their high toxicity toward marine organisms, resulting in masculinization and imposex. Since the ban, there have been extensive efforts to develop environmentally benign antifoulants. Natural antifouling products obtained from marine creatures have been the subject of considerable attention due to their potent antifouling activity and low toxicity. These antifouling compounds often contain isocyano groups, which are well known to have natural antifouling properties. On the basis of our previous total synthesis of natural isocyanoterpenoids, we envisaged the installation of an isocyano functional group onto glucosamine to produce an environmentally friendly antifouling material. This paper describes an effective synthetic method for various glucosamine-based isocyanides and evaluation of their antifouling activity and toxicity against cypris larvae of the barnacle Amphibalanus amphitrite. Glucosamine isocyanides with an ether functionality at the anomeric position exhibited potent antifouling activity, with EC50 values below 1 µg/mL, without detectable toxicity even at a high concentration of 10 µg/mL. Two isocyanides had EC50 values of 0.23 and 0.25 µg/mL, comparable to that of CuSO4, which is used as a fouling inhibitor (EC50 = 0.27 µg/mL).

Determination of SDS using fluorescent γ-cyclodextrin based on TICT in aqueous solution.

Fluorescent γ-cyclodextrin derivatives, modified using N-phenyl-x-anthracenecarboxamido (ACs; x = 9, 1), were synthesized and investigated using fluorescence and UV-vis spectroscopy. Fluorescence enhancements of ACs were observed up to 12-fold by the addition of sodium dodecyl sulfate (SDS) below the critical micellar concentration (CMC). In the presence of a nonionic surfactant, such as Triton X-100, fluorescence spectra were scarcely changed. The fluorescence selectivity between SDS and Triton X-100 was clarified from the different spectral behaviors by circular dichroism and (1)H NMR spectroscopies.

TritonX-100 selective chemosensor based on beta-cyclodextrin modified by anthracene derivative.

Beta-cyclodextrin (CD) modified by 2-(9-anthracenecarboxamido)phenyl group (Ant-CD) was synthesized and their complexation behavior was investigated by UV and fluorescence spectroscopy. Fluorescence intensity of Ant-CD was dramatically enhanced ca. 10-fold by the addition of TritonX-100 (TX-100) in water below the critical micelle concentration. Ant-CD also showed ca. 4-fold fluorescence increasing in the addition of analogous materials, n-octylbenzenesulfonate in water. These results indicate that Ant-CD can act as a highly sensitive and selective chemosensor for TX-100. Ant-CD and TX-100 formed a pseudorotaxane supramolecular complex. This result was supported by (1)H-(1)H NOESY NMR measurement.

Substituted position effect on twisted intramolecular charge transfer of 1- and 2-anthracene aromatic carboxamides as chemosensors based on linear polyether.

Bi-chromophoric compounds linked to linear polyether N,N'-[oxybis(3-oxapentamethyleneoxy-2-phenyl)]-bis(1-anthracenecarboxamide) (1(4)) and its analogues (1(5), 2(4) and 2(5)) were synthesized. Their photochemical properties and complexation actions were investigated in acetonitrile. These fluoroionophores have shown weak emissions in the absence of guest ions, resulting in a twisted intramolecular charge transfer (TICT) quenching process (off state) of an anthracene aromatic amide moiety. After the formation of a complex with alkaline earth metal ions, a large enhancement of fluorescent intensities was obtained (on state). The efficiencies of controlling an off-on fluorescent signal using 1(4) and its analogues (1(5), 2(4) and 2(5)) were larger than that of the 9-positioned analogue. These results suggested that the TICT relaxation process was effectively able to control using 1(4) and its analogues (1(5), 2(4) and 2(5)) by complex formations.

New "off-on" responsible fluoroionophores for alkaline earth metal ions based on benzo-15-crown-5 bearing 9-phenanthreneacetamide.

The photochemical behaviors of a series of 9-phenanthreneacetamide (PA) derivatives were investigated using UV, fluorescence, and (1)H-NMR spectroscopy in acetonitrile solutions. To apply the electron transfer (ET) action of PA as a detecting moiety of chemosensors, 4'-(9-phenanthreneacetamido)-benzo-15-crown-5 (1) and 3'-methyl-4'-(9-phenanthreneacetamido)-benzo-15-crown-5 (2) were synthesized. After metal ion complex formation, the fluorescence intensity increased with increased concentration of the guest alkaline earth metal ions. The photochemical responses of the fluorescence intensity, as defined by the fluorescence intensity ratio (I(max)/I(0)) between free and complex of 1 for Ca(2+), was determined to be 4.76. However, the addition of guest ions in a solution of 2 greatly enhanced the fluorescence intensity of 2. The I(max)/I(0) of 2 was 16.6 for Ca(2+). The efficiency of ET of PA can be tuned by adding an electron-donating group onto a suitable position; fluorescent 2 was able to read out metal ions as an "Off-On" fluorescence signal.

Anomalous fluorescent responses of 9-fluorenecarboxamide derivatives possessing benzo-15-crown-5.

A new fluorescent ionophore for alkaline earth metal ions, 4'-(9-fluorenecarboxamido)benzo-15-crown-5 (3), was synthesized; its photochemical behavior was investigated using UV, fluorescence, (1)H NMR, and (13)C NMR spectrometry. In the absence of a metal ion, the fluorene moiety showed weak fluorescence emission (fluorescence "Off" state). However, complexation with metal ions greatly enhanced the fluorescence intensity (fluorescence "On" state).

Discriminating detection between Mg2+ and Ca2+ by fluorescent signal from anthracene aromatic amide moiety.

Novel fluorescent reagents 1 and 2 were synthesized. In the absence of metal ions, the fluorescence emissions of these compounds were quite weak, but their intensities were much greater in the presence of alkaline earth metal ions. The peak shape and maximum wavelength of the emission of the complex with Mg2+ differed from those of Ca2+ and other alkaline earth metal ions. The peak wavelength difference was 30 nm.

The "off-on" fluorescence detection of alkaline earth metal ions by using 1-naphthylacetanilide derivatives: new cation sensors based on oligo-ethylene oxides connecting 1-naphthylacetanilide at its terminals.

New fluorescent ionophores containing the 1-naphthylacetanilide moiety based on oligo-ethylene oxide (1(4) and 1(5)) have been synthesized, and their photochemical behaviors have been studied. In the absence of a metal ion, the 1-naphthylacetanilide moiety showed a weak fluorescence emission (fluorescence "off state"). However, complexation with Ca(2+) induced a large enhancement effect on the fluorescence intensity of 1(4) and 1(5) from the naphthalene ring (fluorescence "on" state). This behavior can be explained in terms of a similar twisted intramolecular charge-transfer relaxation mechanism. Such "off-on" fluorescence responses of 1(4) and 1(5) provide the digital detection of alkaline earth metal ions.