Accelerated solvent extraction for natural products isolation.

Accelerated solvent extraction (ASE(®)), first introduced in 1995, is an automated rapid extraction technique that utilizes common solvents at elevated temperature and pressure, and thereby increases the efficiency of extraction of organic compounds from solid and semisolid matrices. ASE(®) allows extractions for sample sizes 1-100 g in minutes, reduces solvent uses dramatically, and can be applied to a wide range of matrices, including natural products.

Simultaneous analysis of select pharmaceuticals and personal care products in fish tissue using pressurized liquid extraction combined with silica gel cleanup.

Analytical improvements were developed and validated for measuring select personal care products (PCPs) and two pharmaceuticals in fish tissue. The method was validated using fortified fillet tissue for twelve PCPs including fragrance materials, alkylphenols, photo initiators, and triclosan as well as two pharmaceuticals including carbamazepine (anti-seizure) and diazepam (anti-convulsant). The analytical method utilized pressurized liquid extraction (PLE) combined with silica gel cleanup, gel permeation chromatography, and gas chromatography ion-trap tandem mass spectrometry. Silica gel cleanup was combined with the PLE to produce one automated extraction/cleanup technique. This analytical improvement served to reduce the incurred cost, time, and loss of potential target analytes associated with independent cleanup steps. The combined extraction/cleanup technique resulted in an average increase of 10% in analyte recoveries. Average triplicate recoveries and relative standard deviations for the entire method, using 2.5 g of fish fillet tissue, were 92 ± 9% (recoveries ranged from 64 to 131%). The sensitivity of the analytical methods was improved by optimizing the resonant collision induced dissociation energy to the hundredths place (0.01 V). Improvements in ion production range from 24 to 122% for six of the 12 PCPs. Statistically derived method detection limits (MDLs) were also lowered on average by a factor of 8 and ranged from 1.2 to 38 ng/g wet weight. MDLs for carbamazepine and diazepam were 18 and 3.7 ng/g wet weight, respectively. Galaxolide and tonalide were measured in an environmental sample at concentrations of 81 and 5.5 ng/g wet weight, respectively.

Occurrence of pharmaceuticals and personal care products in fish: results of a national pilot study in the United States.

Pharmaceuticals and personal care products are being increasingly reported in a variety of biological matrices, including fish tissue; however, screening studies have presently not encompassed broad geographical areas. A national pilot study was initiated in the United States to assess the accumulation of pharmaceuticals and personal care products in fish sampled from five effluent-dominated rivers that receive direct discharge from wastewater treatment facilities in Chicago, Illinois; Dallas, Texas; Orlando, Florida; Phoenix, Arizona; and West Chester, Pennsylvania, USA. Fish were also collected from the Gila River, New Mexico, USA, as a reference condition expected to be minimally impacted by anthropogenic influence. High performance liquid chromatography-tandem mass spectrometry analysis of pharmaceuticals revealed the presence of norfluoxetine, sertraline, diphenhydramine, diltiazem, and carbamazepine at nanogram-per-gram concentrations in fillet composites from effluent-dominated sampling locations; the additional presence of fluoxetine and gemfibrozil was confirmed in liver tissue. Sertraline was detected at concentrations as high as 19 and 545 ng/g in fillet and liver tissue, respectively. Gas chromatography-tandem mass spectrometry analysis of personal care products in fillet composites revealed the presence of galaxolide and tonalide at maximum concentrations of 2,100 and 290 ng/g, respectively, and trace levels of triclosan. In general, more pharmaceuticals were detected at higher concentrations and with greater frequency in liver than in fillet tissues. Higher lipid content in liver tissue could not account for this discrepancy as no significant positive correlations were found between accumulated pharmaceutical concentrations and lipid content for either tissue type from any sampling site. In contrast, accumulation of the personal care products galaxolide and tonalide was significantly related to lipid content. Results suggest that the detection of pharmaceuticals and personal care products was dependent on the degree of wastewater treatment employed.

Gas chromatography-mass spectrometry screening methods for select UV filters, synthetic musks, alkylphenols, an antimicrobial agent, and an insect repellent in fish.

Two screening methods have been developed for simultaneous determination of ten extensively used personal care products (PCPs) and two alkylphenol surfactants in fish. The methods consisted of extraction, clean-up, derivatization and analysis by gas chromatography-mass spectrometry with selected ion monitoring (GC-SIM-MS) or gas chromatography-tandem mass spectrometry (GC-MS/MS) techniques. Among solvents tested to assess recovery of target compounds from 1-g tissue homogenates, acetone was selected as optimal for extracting compounds with dissimilar physicochemical properties from fish tissue. Initial experiments confirmed that GC-SIM-MS could be applied for analysis of lean fillet tissue (<1% lipid) without gel-permeation chromatography (GPC), and this approach was applied to assess the presence of target analytes in fish fillets collected from a regional effluent-dominated stream in Texas, USA. Benzophenone, galaxolide, tonalide, and triclosan were detected in 11 of 11 environmental samples at concentrations ranging from; 37 to 90, 234 to 970, 26 to 97, and 17 to 31 ng/g, respectively. However, performance of this analytical approach declined appreciably with increasing lipid content of analyzed tissues. Successful analysis of samples with increased lipid content was enabled by adding GPC to the sample preparation protocol and monitoring analytes with tandem mass spectrometry. Both analytical approaches were validated using fortified fillet tissue collected from locations expected to be minimally impacted by anthropogenic influences. Average analyte recoveries ranged from 87% to 114% with RSDs <11% and from 54% to 107% with RSDs <20% for fish tissue containing <1% and 4.9% lipid, respectively. Statistically derived method detection limits (MDLs) for GC-SIM-MS and GC-MS/MS methodologies ranged from 2.4 to 16 ng/g, and 5.1 to 397 ng/g, respectively.

Analysis of pharmaceuticals in fish using liquid chromatography-tandem mass spectrometry.

A liquid chromatography-tandem mass spectrometry (LC-MS/MS) screening method has been developed targeting 23 pharmaceuticals and 2 metabolites with differing physicochemical properties in fish tissue. Reversed-phase separation of target compounds was achieved using a C18 column and a nonlinear gradient consisting of 0.1% (v/v) formic acid and methanol. Eluted analytes were introduced into the mass analyzer using positive or negative electrospray ionization, as appropriate. A variety of extraction solvents, differing in polarity, pH, or both, were investigated in order to assess recovery of target compounds from 1-g tissue homogenates. Among 10 solvents tested, a 1:1 mixture of 0.1 M aqueous acetic acid (pH 4) and methanol was identified as optimal, resulting in extraction recoveries for 24 of 25 compounds exceeding 60%. Tissue extracts were found to influence the LC-MS/MS response for several analytes. Consequently, matrix-matched calibration standards were employed to determine analyte concentrations in environmental samples. Statistically derived method detection limits were <6 ng/g for most analytes. The method was subsequently used to screen for target analytes in fish from an effluent-dominated stream. Diphenhydramine, diltiazem, carbamazepine, and norfluoxetine were detected in 11 of 11 environmental samples at concentrations ranging from 0.11 to 5.14 ng/g.

Determination of benzene, toluene, ethylbenzene and xylene in river water by solid-phase extraction and gas chromatography.

A rapid and reproducible method is described that employs solid-phase extraction (SPE) using dichloromethane, followed by gas chromatography (GC) with flame ionization detection for the determination of benzene, toluene, ethylbenzene, xylene and cumene (BTEXC) from Buriganga River water of Bangladesh. The method was applied to detect BTEXC in a sample collected from the surface, or 5 cm depth of water. Two-hundred milliliters of n-hexane-pretreated and filtered water samples were applied directly to a C18 SPE column. BTEXC were extracted with dichloromethane and the BTEX concentrations were obtained to be 0.1 to 0.37 microg ml(-1). The highest concentration of benzene was found as 0.37 microg ml(-1) with a relative standard deviation (RSD) of 6.2%; cumene was not detected. The factors influencing SPE e.g., adsorbent types, sample load volume, eluting solvent, headspace and temperatures, were investigated. A cartridge containing a C18 adsorbent and using dichloromethane gave a better performance for the extraction of BTEXC from water. Average recoveries exceeding 90% could be achieved for cumene at 4 degrees C with a 2.7% RSD.

Enhanced desolvation and improved deposition efficiency by modified thermospray for the coupling of HPLC and FT-IR.

A thermospray interface was modified for the on-line coupling of normal- and reversed-phase high-performance liquid chromatography (HPLC) and Fourier transform infrared (FTIR) spectrometry. An LC/FTIR assembly was used to evaporate the column effluents and the solutes were deposited as a series of individual spots on a stainless-steel moving belt, which continuously transferred the solutes into a diffuse reflectance accessory of FTIR, enabling the identification of deposited solutes by measuring the IR spectrum. A lowered desolvation temperature of reversed-phase HPLC eluents, a higher deposition efficiency, such as 69%, and a reduction of the thermospray capillary voltage were achieved by using a heated gas flow and a heating plate. The thermospray temperature and the distance between the tip of the thermospray tubing and the surface of the belt were shown to influence the area of deposition of spots. A variation of +/- 1 degrees C could be used for a sensitive and reproducible deposition of Irganox 565 with a relative standard deviation (RSD) of 1.8 to 2.5%. The UV and FTIR chromatograms gave similar features for the HPLC-separated constituents. The interface-derived IR spectra of the constituents showed excellent agreement of the spectral features with those of the standard FTIR spectra, and no thermal degradation was found to occur.