ABSTRACT
The effects of the contents of iron and cobalt on the crystal structure, oxygen content, thermal expansion coefficient, and electrical-electrochemical properties of materials Eu2SrCoxFe2-xO7-δ (x = 0.50 and 1.00) are reported. These oxides are well-ordered new members of the Ruddlesden-Popper series (Eu,Sr)n+1(Co,Fe)nO3n+1 system with n = 2 as determined by selected area electron diffraction and high-resolution transmission electron microscopy and X-ray diffraction studies. The two materials are semiconductors of p-type, with much higher total conductivity under working conditions for the low cobalt compound, Eu2SrCo0.50Fe1.50O7-δ. Composite cathodes prepared with this oxide present much lower area-specific resistance values (0.08 Ω·cm2 at 973 K in air) than composites containing Eu2SrCo1.00Fe1.00O7-δ (1.15 Ω·cm2). This significant difference is related to the much higher total conductivity and a sufficiently high content of oxygen vacancies in the Fe-rich phase. The excellent electrochemical performance of Eu2SrCo0.50Fe1.50O7-δ with low cobalt content, which shows one of the lowest area-specific resistance reported so far for a Ruddlesden-Popper oxide, makes it a good candidate for application as a cathode material for solid oxide fuel cells at intermediate temperatures in real devices.
ABSTRACT
The utilization of biobased materials for the fabrication of naturally derived ion-exchange membranes is breezing a path to sustainable separators for polymer electrolyte fuel cells (PEFCs). In this investigation, bacterial nanocellulose (BNC, a bacterial polysaccharide) and lignosulfonates (LS, a by-product of the sulfite pulping process), were blended by diffusion of an aqueous solution of the lignin derivative and of the natural-based cross-linker tannic acid into the wet BNC nanofibrous three-dimensional structure, to produce fully biobased ion-exchange membranes. These freestanding separators exhibited good thermal-oxidative stability of up to about 200 °C, in both inert and oxidative atmospheres (N2 and O2, respectively), high mechanical properties with a maximum Young's modulus of around 8.2 GPa, as well as good moisture-uptake capacity with a maximum value of ca. 78% after 48 h for the membrane with the higher LS content. Moreover, the combination of the conducting LS with the mechanically robust BNC conveyed ionic conductivity to the membranes, namely a maximum of 23 mS cm-1 at 94 °C and 98% relative humidity (RH) (in-plane configuration), that increased with increasing RH. Hence, these robust water-mediated ion conductors represent an environmentally friendly alternative to the conventional ion-exchange membranes for application in PEFCs.
ABSTRACT
The potential of the perovskite system Nd1-xSrxCoO3-δ (x = 1/3 and 2/3) as cathode material for solid oxide fuel cells (SOFCs) has been investigated via detailed structural, electrical, and electrochemical characterization. The average structure of x = 1/3 is orthorhombic with a complex microstructure consisting of intergrown, adjacent, perpendicularly oriented domains. This orthorhombic symmetry remains throughout the temperature range 373-1073 K, as observed by neutron powder diffraction. A higher Sr content of x = 2/3 leads to stabilization of the cubic perovskite with a homogeneous microstructure and with a higher oxygen vacancy content and cobalt oxidation state than the orthorhombic phase at SOFC operation temperature. Both materials are p-type electronic conductors with high total conductivities of 690 and 1675 S·cm-1 at 473 K in air for x = 1/3 and 2/3, respectively. Under working conditions, both compounds exhibit similar electronic conductivities, since x = 2/3 loses more oxygen on heating than x = 1/3, associated with a greater loss of p-type charger carriers. However, composite cathodes prepared with Nd1/3Sr2/3CoO3-δ and Ce0.8Gd0.2O2-δ present lower ASR values (0.10 Ω·cm2 at 973 K in air) than composites prepared with Nd2/3Sr1/3CoO3-δ and Ce0.8Gd0.2O2-δ (0.34 Ω·cm2). The high activity for the oxygen electrochemical reaction at intermediate temperatures is likely attributable to a large disordered oxygen-vacancy concentration, resulting in a very promising SOFC cathode for real devices.
ABSTRACT
The zeolitic imidazolate framework-8 (ZIF-8) combines a significantly high microporosity with an excellent thermal, chemical, and hydrothermal stability. Here, we demonstrated that ZIF-8 can display significant levels of protonic conductivity through a water-mediated surface transport mechanism associated to the presence of di-coordinated Zn ions revealed by X-ray photoelectron spectroscopy. A set of powders with particle sizes from 2.8 µm down to 80 nm studied by dynamic water vapour sorption analysis was used to demonstrate that water adsorbs predominantly in the micropore cavities of microcrystalline ZIF-8, whereas adsorption on the external surface becomes the dominant contribution for the nanostructured material. Impedance spectroscopy in turn revealed that the protonic conductivity of the nanocrystalline ZIF-8 was two orders of magnitude higher than that of the micron-sized powders, reaching approximately 0.5 mS·cm-1 at 94 °C and 98% relative humidity. Simple relations were derived in order to estimate the potential gains in water uptake and conductivity as a function of the particle size. This new strategy combining particle nanostructuring with surface defects, demonstrated here for one of the most know metal organic framework, is of general application to potentially boost the conductivity of other materials avoiding chemical functionalization strategies that in most if not all cases compromise their chemical stability, particularly under high humidity and high temperature conditions.
ABSTRACT
The perovskite series Sr2 CoNb1-x Tix O6-δ (0≤x≤1) was investigated in the full compositional range to assess its potential as cathode material for solid oxide fuel cell (SOFC). The variation of transport properties and thus, the area specific resistances (ASR) are explained by a detailed investigation of the defect chemistry. Increasing the titanium content from x=0-1 produces both oxidation of Co3+ to Co4+ (from 0 up to 40 %) and oxygen vacancies (from 6.0 to 5.7 oxygen atom/formula unit), although each charge compensation mechanism predominates in different compositional ranges. Neutron diffraction reveals that samples with high Ti-contents lose a significant amount of oxygen upon heating above 600â K. Oxygen is partially recovered upon cooling as the oxygen release and uptake show noticeably different kinetics. The complex defect chemistry of these compounds, together with the compositional changes upon heating/cooling cycles and atmospheres, produce a complicated behavior of electrical conductivity. Cathodes containing Sr2 CoTiO6-δ display low ASR values, 0,13â Ω cm2 at 973â K, comparable to those of the best compounds reported so far, being a very promising cathode material for SOFC.
Subject(s)
Electric Conductivity , Electric Power Supplies , Oxides/chemistry , Electrodes , Oxygen/chemistry , Pressure , TemperatureABSTRACT
Layered-type ordering and oxygen vacancies ordering are revealed in GdBaMnFeO(6-δ) perovskite. Selected area electron diffraction and high-resolution transmission electron microscopy results indicate a modulation of the crystal structure. Ba and Gd ordering in (001)(p) layers is confirmed by high angle annular dark field scanning transmission electron microscopy and electron energy-loss spectroscopy. These techniques also revealed formation of layer-stacking defects in the crystals. Direct imaging of the oxygen sublattice is obtained by phase image reconstruction. Location of the oxygen vacancies in the (GdO)(x) layers is achieved by analysis of the intensity of the averaged phase image. Physical properties of the GdBaMnFeO(6-δ) perovskite, are likely to be strongly affected by its ordering effects and crystal microstructure. In this sense, layered-type GdBaMnFeO(6-δ) perovskite show better electrochemical properties as cathodes in SOFCs than ion disordered Gd(0.5)Ba(0.5)Mn(0.5)Fe(0.5)O(3-δ) perovskite.
