ABSTRACT
We propose a method to measure the interfacial tension characterizing the interface between two immiscible liquids of practically the same density. In this method, a cylindrical liquid bridge made of one the liquids is vibrated laterally inside a tank filled with the other. The first resonance frequency is determined and equated to the first eigenfrequency of the m=1 linear mode to infer the interfacial tension value. The method does not involve the density jump across the interface. Therefore, its accuracy is affected neither by the smallness of the Bond number nor by errors of the density difference. The experimental setup is relatively simple, and the procedure does not use image processing techniques. The results satisfactorily agree with those measured by TIFA-AI (Theoretical Fitting Image Analysis-Axisymmetric Interfaces) for the same liquid bridges when the density difference is sufficiently large for TIFA-AI to be valid. We conduct numerical simulations of the Navier-Stokes equations to determine the best parameter conditions for the proposed method. The transfer function characterizing the frequency response of the fluid configuration is measured in some experiments to quantify non-linear effects and to study the role played by the outer bath vibration.
ABSTRACT
Polydimethylsiloxane (PDMS), due to its remarkable properties, is one of the most widely used polymers in many industrial and medical applications. In this work, a technique based on a flow focusing technique is used to produce PDMS spherical particles with sizes of a few microns. PDMS precursor is injected through a hypodermic needle to form a film/reservoir over the needle's outer surface. This film flows towards the needle tip until a liquid ligament is steadily ejected thanks to the action of a coflowing viscous liquid stream. The outcome is a capillary jet which breaks up into PDMS precursor droplets due to the growth of capillary waves producing a micrometer emulsion. The PDMS liquid droplets in the solution are thermally cured into solid microparticles. The size distribution of the particles is analyzed before and after curing, showing an acceptable degree of monodispersity. The PDMS liquid droplets suffer shrinkage while curing. These microparticles can be used in very varied technological fields, such as biomedicine, biotechnology, pharmacy, and industrial engineering.