ABSTRACT
Surface roughness affects the results of nanomechanical tests. The surface roughness values to be measured on a surface of a porous material are dependent on the properties of the naturally occurring pore space. In order to assess the surface roughness of hardened cement paste (HCP) without the actual influence of the usual sample preparation for nanomechanical testing (i.e. grinding and polishing), focussed ion beam nanotomography datasets were utilized for reconstruction of 3D (nanoscale resolution) surface profiles of hardened cement pastes. 'Virtual topographic experiments' were performed and root mean square surface roughness was then calculated for a large number of such 3D surface profiles. The resulting root mean square (between 115 and 494 nm) is considerably higher than some roughness values (as low as 10 nm) reported in the literature. We suggest that thus-analysed root mean square values provide an estimate of a 'hard' lower limit that can be achieved by 'artefact-free' sample preparation of realistic samples of hardened cement paste. To the best of our knowledge, this 'hard' lower limit was quantified for a porous material based on hydraulic cement for the first time. We suggest that the values of RMS below such a limit may indicate sample preparation artefacts. Consequently, for reliable nanomechanical testing of disordered porous materials, such as hardened cement paste, the preparation methods may require further improvement.
ABSTRACT
Cryo-FIB-nanotomography is a novel high-resolution 3D-microscopy technique, which opens new possibilities for the quantitative microstructural analysis of complex suspensions. In this paper, we describe the microstructural changes associated with dissolution and precipitation processes occurring in a fresh cement paste, which has high alumina and sulphate contents. During the first 6 min, precipitation of ettringite leads to a general decrease of the particle size distribution. In the unhydrated cement paste almost no particles smaller than 500 nm are present, whereas after 6 min this size class already represents 9 vol%. The precipitation of ettringite also leads to a significant increase of the particle number density from 0.294*10(9)/mm(3) at t(0min) to 20.55*10(9)/mm(3) at t(6min). Correspondingly the surface area increases from 0.75 m(2)/g at t(0min) to 2.13 m(2)/g at t(6min). The small ettringite particles tend to form agglomerates, which strongly influence the rheological properties. The particular strength of cryo-FIB-nt is the potential to quantify particle structures in suspension and thereby also to describe higher-order topological features such as the particle-particle interfaces, which is important for the study of agglomeration processes.
