Is timing of superior labrum anterior to posterior (SLAP) repair important? A cohort study evaluating the effect of the duration of symptoms prior to surgery on the outcomes of patients who underwent type II SLAP repair.

Background: The management of superior labrum anterior to posterior (SLAP) tears is somewhat controversial. It is unclear if the length of time between symptom onset and surgery affects SLAP repair outcomes. Methods: Sixty-one SLAP repairs were retrospectively reviewed pre-operatively and post-operatively at 1, 6, 24 weeks, and > 2 years post-surgery. Patients were allocated to an 'early repair' or 'late repair' group based on time between symptom onset and surgery. Results: Of the 61 patients, 22 patients had surgery within six months of symptom onset. Pre-operatively, 'late repair' patients played a higher level of sport than 'early repair' patients prior to injury. Post-operatively, both groups had similar outcomes up to six months, though at six months 'early repair' patients reported a higher level of work than 'late repair' patients (p = 0.01). At > 2 years after surgery, 'early repair' patients had reduced pain and difficulty with overhead activities (p = 0.002), less stiffness (p = 0.001) and were more satisfied than 'late repair' patients (p = 0.04). Conclusions: Up to six months post-operatively, the time between symptom onset and surgery has limited effect on functional outcomes. However, at > 2 years after surgery, earlier repairs ( < 6 months) are interestingly associated with better functional outcomes. Further studies are required to determine if this is a causal relationship.

Augmentation of rotator cuff repair with gelatin-resorcin-formalin glue: a biomechanical study.

Introduction: Rotator cuff tendons are typically reattached to the proximal humerus using transosseous sutures or suture anchors. Their primary mode of failure is at the tendon-bone interface. Methods: We investigated the addition of an adhesive, gelatin-resorcin-formalin (GRF) glue, to a single-row rotator cuff repair (RCR) on ex vivo sheep models. We hypothesised the addition of GRF glue would increase the repair construct strength. The study consisted of three groups of six sheep infraspinatus tendons with an inverted-mattress stitch, tension-band configuration. Group 1 was the control group where no glue was applied. Group 2 involved applying 2 × 2 cm of GRF glue to the infraspinatus footprint and a 2-min curing time. Group 3 allowed for a 15-min cure time. Results: Failure occurred at the tendon-bone-suture interface in 6/6 of the control group, and 4/6 from groups 2 and 3. Failure occurred via the suture pulling out of the anchor in 2/6 of groups 2 and 3. No significant differences were noted between all three groups in ultimate failure load, repair stiffness or total energy to failure (p > 0.05). Discussion: The addition of GRF glue to the tendon-bone-suture interface did not enhance RCR strength in an ovine model.

A review of bone grafting techniques for glenoid reconstruction.

Background: Traumatic anterior shoulder dislocations can cause bony defects of the anterior glenoid rim and are often associated with recurrent shoulder instability. For large glenoid defects of 20-30% without a mobile bony fragment, glenoid reconstruction with bone grafts is often recommended. This review describes two broad categories of glenoid reconstruction procedures found in literature: coracoid transfers involving the Bristow and Latarjet procedures, and free bone grafting techniques. Methods: An electronic search of MEDLINE and PubMed was conducted to find original articles that described glenoid reconstruction techniques or modifications to existing techniques. Results: Coracoid transfers involve the Bristow and Latarjet procedures. Modifications to these procedures such as arthroscopic execution, method of graft attachment and orientation have been described. Free bone grafts have been obtained from the iliac crest, distal tibia, acromion, distal clavicle and femoral condyle. Conclusion: Both coracoid transfers and free bone grafting procedures are options for reconstructing large bony defects of the anterior glenoid rim and have had similar clinical outcomes. Free bone grafts may offer greater flexibility in graft shaping and choice of graft size depending on the bone stock chosen. Novel developments tend towards minimising invasiveness using arthroscopic approaches and examining alternative non-rigid graft fixation techniques.

Biomechanical evaluation of an independent acromioclavicular ligament repair for acromioclavicular joint reconstruction.

BACKGROUND: A number of surgical techniques for the treatment of acromioclavicular joint separations have been described; however, few have been able to create a strong intra-operative construct that provides minimal joint translation. A biomechanical study was conducted to examine joint translation in an independent acromioclavicular ligament repair. METHODS: Three variations of a novel independent acromioclavicular ligament repair technique underwent testing using a Sawbones model. The technique involves threading sutures through two acromial bone tunnels in a suture-bridge configuration and anchoring them into the distal clavicle. Three groups of eight specimens underwent reconstruction; group 1 using FiberTape, group 2 using FiberWire and group 3 using FiberTape in a modified (under-over) suture-bridge configuration. Superior, anterior and posterior translation was tested at loads of 10, 20 and 30 N. RESULTS: Group 3 repair yielded the least translation in both anterior-posterior and superior-inferior planes, with a two-fold decrease in superior translation compared to groups 1 and 2 (P < .05). Both groups 1 and 3 using FiberTape resulted in significantly less anterior and posterior translation compared to the FiberWire group (P < .05). DISCUSSION: The independent acromioclavicular ligament repair, without repair of the coracoclavicular ligament, demonstrated significant translational stability in the anterior-posterior and superior-inferior planes.

Reliability of shear wave elastography ultrasound to assess the supraspinatus tendon: An intra and inter-rater in vivo study.

INTRODUCTION: Shear wave elastography ultrasound is a relatively new technique that evaluates the tissue elasticity by applying an acoustic radiation force impulse. It is undetermined how reliable this modality is in assessing rotator cuff tendons. The aim of this study, therefore, was to evaluate the reliability of shear wave elastography ultrasound to assess the stiffness of normal and tendinopathic supraspinatus tendons. METHODS: An inter- and intra-rater reliability trial was carried out using shear wave elastography to assess the supraspinatus tendon at its distal insertion, by measuring shear wave velocity and elasticity. Twenty participants with a mean age of 37 (21-69) years old were evaluated. Ten subjects with normal supraspinatus tendon and 10 subjects with tendinopathic tendon were selected. The Virtual Touch Imaging Quantification program was used to generate the acoustic radiation force impulse and to obtain the elastography data. Three raters with different experience in conventional ultrasound were used for the inter-rater trial in normal tendons and the most experienced rater examined all subjects for the intra-rater reliability evaluation. Each rater obtained three readings in three different examinations per subject over a one-week period. RESULTS: The mean (±SEM) shear wave velocity for the normal supraspinatus tendon was 9.96 ± 0.02 m/s (=297 kPa), while in the tendinopathic supraspinatus tendon was 8.3 ± 0.2 m/s (=207 kPa) (p < 0.001). The intra-rater trial agreement was excellent, with an intraclass correlation coefficient = 0.96. In the inter-rater testing, the mean shear wave velocity in normal tendons was 9.90 ± 0.07 m/s (=294 kPa), with intraclass correlation coefficient = 0.45. CONCLUSION: Shear wave elastography ultrasound was able to show that tendinopathic tendons were less stiff than normal tendons. It was a reliable imaging technique to assess the supraspinatus tendon, especially when used by a single experienced musculoskeletal sonographer.

Not all ultrasounds are created equal: general sonography versus musculoskeletal sonography in the detection of rotator cuff tears.

BACKGROUND: This cross-sectional analytic diagnostic accuracy study was designed to compare the accuracy of ultrasound performed by general sonographers in local radiology practices with ultrasound performed by an experienced musculoskeletal sonographer for the detection of rotator cuff tears. METHODS: In total, 238 patients undergoing arthroscopy who had previously had an ultrasound performed by both a general sonographer and a specialist musculoskeletal sonographer made up the study cohort. Accuracy of diagnosis was compared with the findings at arthroscopy. RESULTS: When analyzed as all tears versus no tears, musculoskeletal sonography had an accuracy of 97%, a sensitivity of 97% and a specificity of 95%, whereas general sonography had an accuracy of 91%, a sensitivity of 91% and a specificity of 86%. When the partial tears were split with those ≥ 50% thickness in the tear group and those < 50% thickness in the no-tear group, musculoskeletal sonography had an accuracy of 97%, a sensitivity of 97% and a specificity of 100% and general sonography had an accuracy of 85%, a sensitivity of 84% and a specificity of 87%. CONCLUSIONS: Ultrasound in the hands of an experienced musculoskeletal sonographer is highly accurate for the diagnosis of rotator cuff tears. General sonography has improved subsequent to earlier studies but remains inferior to an ultrasound performed by a musculoskeletal sonographer.

Biomechanical comparison of expanded polytetrafluoroethylene (ePTFE) and PTFE interpositional patches and direct tendon-to-bone repair for massive rotator cuff tears in an ovine model.

BACKGROUND: Massive irreparable rotator cuff tears are a difficult problem. Modalities such as irrigation and debridement, partial repair, tendon transfer and grafts have been utilized with high failure rates and mixed results. Synthetic interpositional patch repairs are a novel and increasingly used approach. The present study aimed to examine the biomechanical properties of common synthetic materials for interpositional repairs in contrast to native tendon. METHODS: Six ovine tendons, six polytetrafluoroethylene (PTFE) felt sections and six expanded PTFE (ePTFE) patch sections were pulled-to-failure to analyze their biomechanical and material properties. Six direct tendon-to-bone surgical method repairs, six interpositional PTFE felt patch repairs and six interpositional ePTFE patch repairs were also constructed in ovine shoulders and pulled-to-failure to examine the biomechanical properties of each repair construct. RESULTS: Ovine tendon had higher load-to-failure (591 N) and had greater stiffness (108 N/mm) than either PTFE felt (296 N, 28 N/mm) or ePTFE patch sections (323 N, 34 N/mm). Both PTFE felt and ePTFE repair techniques required greater load-to-failure (225 N and 177 N, respectively) than direct tendon-to-bone surgical repairs (147 N) in ovine models. CONCLUSIONS: Synthetic materials lacked several biomechanical properties, including strength and stiffness, compared to ovine tendon. Interpositional surgical repair models with these materials were significantly stronger than direct tendon-to-bone model repairs.

Ultrasound determination of rotator cuff tear repairability.

BACKGROUND: Rotator cuff repair aims to reattach the torn tendon to the greater tuberosity footprint with suture anchors. The present study aimed to assess the diagnostic accuracy of ultrasound in predicting rotator cuff tear repairability and to assess which sonographic and pre-operative features are strongest in predicting repairability. METHODS: The study was a retrospective analysis of measurements made prospectively in a cohort of 373 patients who had ultrasounds of their shoulder and underwent rotator cuff repair. Measurements of rotator cuff tear size and muscle atrophy were made pre-operatively by ultrasound to enable prediction of rotator cuff repairability. Tears were classified following ultrasound as repairable or irreparable, and were correlated with intra-operative repairability. RESULTS: Ultrasound assessment of rotator cuff tear repairability has a sensitivity of 86% (p < 0.0001) and a specificity of 67% (p < 0.0001). The strongest predictors of rotator cuff repairability were tear size (p < 0.001) and age (p = 0.004). Sonographic assessments of tear size ≥4 cm(2) or anteroposterior tear length ≥25 mm indicated an irreparable rotator cuff tear. CONCLUSIONS: Ultrasound assessment is accurate in predicting rotator cuff tear repairability. Tear size or anteroposterior tear length and age were the best predictors of repairability.

The temporal outcomes of open versus arthroscopic knotted and knotless rotator cuff repair over 5 years.

BACKGROUND: The present study aimed to determine how repair technique influenced structural and clinical outcomes at 5 years post-surgery. METHODS: Three cohorts of patients had repair of a symptomatic rotator cuff tear using (i) an open double-row mattress repair technique (n = 25); (ii) arthroscopic single-row simple suture knotted technique (n = 25); or (iii) arthroscopic single-row inverted mattress knotless technique (n = 36) by one surgeon. Standardized patient- and examiner-determined outcomes were obtained pre-operatively and postoperatively with a validated protocol, ultrasound were also performed at the same time. RESULTS: Retear occurred more often after open repair (48%) at 5 years than after arthroscopic knotted (33%) and arthroscopic knotless (26%) repair. Retear was associated with increasing age, pre-operative tear size and weaker pre-operative and 5 years postoperative cuff strength. Between 2 years and 5 years, the open repair group experienced an increase in the frequency of pain during activity, as well as in the difficulty experienced and the severity of pain during overhead activities (p < 0.05) and, at 5 years, also experienced more difficulty with overhead activities, compared to the arthroscopic knotless repair group. CONCLUSIONS: At 5-year follow-up, arthroscopic rotator cuff repair techniques resulted in fewer retears and better outcomes compared to an open double-row technique.