Numerical study of drop dynamics for inkjet based 3D printing of pharmaceutical tablets.

Interest in 3D printing has been growing rapidly especially in pharmaceutical industry due to its multiple advantages such as manufacturing versatility, personalization of medicine, scalability, and cost effectiveness. Inkjet based 3D printing gained special attention after FDA's approval of Spritam® manufactured by Aprecia pharmaceuticals in 2015. The precision and printing efficiency of 3D printing is strongly influenced by the dynamics of ink/binder jetting, which further depends on the ink's fluid properties. In this study, Computational Fluid Dynamics (CFD) has been utilized to study the drop formation process during inkjet-based 3D printing for piezoelectric and thermal printhead geometries using Volume of Fluid (VOF) method. To develop the CFD model commercial software ANSYS-Fluent was used. The developed CFD model was experimentally validated using drop watcher setup to record drop progression and drop velocity. During the study, water, Fujifilm model fluid, and Amitriptyline drug solutions were evaluated as the ink solutions. The drop properties such as drop volume, drop diameter, and drop velocity were examined in detail in response to change ink solution properties such as surface tension, viscosity, and density. A good agreement was observed between the experimental and simulation data for drop properties such as drop volume and drop velocity.

Discrete Element Modeling (DEM) based investigation of tribocharging in the pharmaceutical powders during hopper discharge.

Triboelectric charging is defined as the phenomenon of charge transfer between two different material surfaces when they are brought into contact and separated. The focus of this research is the development of a Discrete Element Method (DEM) based simulation model to predict tribocharging during hopper discharge. Due to decreased particle-wall interactions and reduced particle wall contact times, net charges generated during hopper discharge are low. The simulation model confirmed this effect and was implemented to predict the triboelectric behavior of glass beads and MCC particles during hopper flow, along with the prediction of percent charged and uncharged particles. Approximately one-third of the particles were predicted to remain uncharged during the hopper discharge simulations for mono-dispersed particles, thus rendering a comparatively high amount of charge distribution into a small concentration of materials. The DEM model acted as a tool to predict charges that can be generated during hopper discharge at a specified geometry, with a potential to mitigate particle charging, when used for appropriate selection of hopper angles, and hopper wall materials.