ABSTRACT
Highly charged cation permeable composite membranes were prepared by blending of sulfonated poly(ether sulfone) (SPES) with sulfonated poly(ether ether ketone) (SPEEK) in 0 to 90% weight ratio, to adjust the hydrophobic properties and ion selective nature. Extent of sulfonation was confirmed by 1H NMR and ion exchange capacity and degree of sulfonation depending on blending composition. These membranes were characterized as a function of weight fraction of SPEEK by recording ion-exchange capacity, water uptake, thermogravimetric analysis, membrane conductivity and membrane potential in equilibration with different electrolytic solutions. Membrane permselectivity and solute flux were estimated using these data on the basis of non-equilibrium thermodynamic principles and for observing the selectivity of different membranes for mono- or bivalent counter-ions. It was observed that relative selectivity for monovalent in comparison to bivalent counter-ions were increased with the decrease in SPEEK content in the composite membrane matrix. The range of SPEEK content in the blend from 60 to 80% appears the most suitable for the selective separation of monovalent ions from bivalent ions. Furthermore, highly charged nature and stabilities of these membranes extend their applications for the electro-assisted separations of similarly charged ions as well as other electro-membrane processes.
ABSTRACT
Rapid growth of chemical and biotechnology in diversified areas fuels the demand for the need of reliable green technologies for the down stream processes, which include separation, purification and isolation of the molecules. Ion-exchange membrane technologies are non-hazardous in nature and being widely used not only for separation and purification but their application also extended towards energy conversion devices, storage batteries and sensors etc. Now there is a quite demand for the ion-exchange membrane with better selectivities, less electrical resistance, high chemical, mechanical and thermal stability as well as good durability. A lot of work has been done for the development of these types of ion-exchange membranes during the past twenty-five years. Herein we have reviewed the preparation of various types of ion-exchange membranes, their characterization and applications for different electro-membrane processes. Primary attention has been given to the chemical route used for the membrane preparation. Several general reactions used for the preparation of ion-exchange membranes were described. Methodologies used for the characterization of these membranes and their applications were also reviewed for the benefit of readers, so that they can get all information about the ion-exchange membranes at one platform. Although there are large number of reports available regarding preparations and applications of ion-exchange membranes more emphasis were predicted for the usefulness of these membranes or processes for solving certain type of industrial or social problems. More efforts are needed to bring many products or processes to pilot scale and extent their applications.
Subject(s)
Ion Exchange , Membranes, Artificial , Polymers/chemistry , Biotechnology , Chemical Phenomena , Chemistry, Physical , Dialysis/instrumentation , Dialysis/methods , Electrochemistry , Food Industry , Molecular Structure , Permeability , Stress, Mechanical , Water Purification/methodsABSTRACT
Organic-inorganic composite membranes based on poly(vinyl alcohol)/SiO(2) were prepared via an aqueous dispersion polymerization route and anion-exchange groups were introduced in the membrane matrix by the chemical grafting of 4-vinylpyridine with the desired content. These membranes were extensively characterized for their surface morphology, thermal stability, water content, and surface-charge properties using SEM, TEM, FTIR, TGA, water uptake, and ion-exchange capacity measurements. Counterion transport numbers across these membranes were estimated from membrane potential data. Membrane conductance measurements were also performed and these data were used for the estimation of values of counterion diffusion coefficients in the membrane phase. Physicochemical and electrochemical properties of these membranes and equivalent pore radius (estimated from electroosmotic flux measurements) were found to be highly dependent on the 4-vinylpyridine (4-VP) content in the membrane phase. It was also observed that for better selectivity and membrane conductivity of anion-exchange membranes complete optimization of the loading of 4-VP in the membrane phase is necessary. Furthermore, among these, membrane with 25% loading with 4-VP exhibited very good selectivity, water content, and ion-exchange capacity along with moderate membrane conductivity, which may be used for their application in electro-driven separation at elevated temperatures or for other electrochemical processes.
ABSTRACT
Composite membranes were prepared by chemical polymerization of a thin layer of polyaniline (PANI) in the presence of a high oxidant concentration on a single face of a sulfonated cation-exchange membrane (CEM) and quaternary aminated anion-exchange membrane (AEM). IR and SEM studies for both types of membranes confirmed PANI loading on the ion-exchange membranes. PANI composite ion-exchange membranes were characterized as a function of the polymerization time by ion-exchange capacity, coating density, and membrane conductance measurements. Membrane potential measurements were performed in various electrolyte solutions in order to observe the selectivity of these membranes for different types of counterions. Membrane potential data in conjunction with membrane conductance data was interpreted on the basis of frictional considerations between membrane matrix and solute. Electrodialysis experiments, using PANI composite ion-exchange membranes with 4 h polymerization time, were performed in single and mixed electrolyte solutions for observing electromigration of solute across PANI composite ion-exchange membranes. Relative dialytic rates of Na(2)SO(4), CaCl(2), and CuCl(2) were estimated with reference to NaCl on the basis of electrodialysis experiments and it was concluded that it is possible to separate different electrolytes using PANI composite ion-exchange membranes.
ABSTRACT
With the objective of introducing antifouling characteristics into interpolymer types of cation and anion exchange membranes, the surface of these membranes was coated with a 12-microm-thick urethane acrylate layer and was cured by UV radiation of wavelengths 308 and 172 nm under a complete inert atmosphere. Different urethane acrylate composite ion exchange membranes developed were characterized in NaCl solution by measuring their ion-exchange capacity, volume fraction of water, contact angle with water, membrane conductance, and membrane potential. It was found that the electrochemical transport properties of urethane acrylate composite cation-exchange membranes were increased due to resonance stabilization of the urethane group, which acts as a weak acid and dissociates as a negatively charged urethane ion and a positively charged proton. This contributes toward the net charge density of the membrane matrix responsible for enhanced selectivity and conductivity, while for urethane acrylate composite anion-exchange membranes reduction in net charge density was responsible for reduction in electrochemical transport properties. Counterion transport number, permselectivity, and counterion diffusion coefficient values for these membranes were also estimated. Experiments were also carried out in higher homologs of sodium carboxylate solutions in order to observe the fouling tendencies of these membranes. It was concluded that it is possible to obtain antifouling characteristics of ion-exchange membranes by coating and curing thin hydrophilic layers of urethane acrylate on their surfaces without sacrificing their electrochemical transport properties.