ABSTRACT
Polymers formed by ring-opening metathesis polymerization (ROMP) such as poly(dicyclopentadiene) (pDCPD) exhibit a technologically desirable combination of high toughness, high glass transition temperature, and outstanding low-temperature performance. However, because of their nonpolar molecular structure, they tend to suffer from relatively low elastic moduli and poor adhesion to common fillers, fibers, and substrates, limiting their utility as adhesives and composite binders without specialized bonding agents. Here, we investigate the mechanical properties of a pDCPD-based copolymer filled with well-defined spherical microparticles having four distinct surface chemistries capable of strong, moderate, or weak bonding to the matrix with surfaces ranging from polar to nonpolar. Measurements in uniaxial tension, quasi-static fracture, and high-velocity impact are complemented by digital image correlation (DIC), scanning electron microscopy (SEM) fractography, and X-ray computed tomography (X-µCT) of subcritically loaded crack tips, yielding insight into the complex roles played by interfacial bonding in strength, stiffness, and toughening mechanisms of an already tough polymer. Analysis using quantitative fracture and impact mechanism models provided valuable guidelines for designing heterogeneous systems that combine structural and tough performance.
ABSTRACT
This paper describes a new witness material for quantifying the back face deformation (BFD) resulting from high rate impact of ballistic protective equipment. Accurate BFD quantification is critical for the assessment and certification of personal protective equipment, such as body armor and helmets, and ballistic evaluation. A common witness material is ballistic clay, specifically, Roma Plastilina No. 1 (RP1). RP1 must be heated to nearly 38°C to pass calibration, and used within a limited time frame to remain in calibration. RP1 also exhibits lot-to-lot variability and is sensitive to time, temperature, and handling procedures, which limits the BFD accuracy and reproducibility. A new silicone composite backing material (SCBM) was developed and tested side-by-side with heated RP1 using quasi-static indentation and compression, low velocity impact, spherical projectile penetration, and both soft and hard armor ballistic BFD measurements to compare their response over a broad range of strain rates and temperatures. The results demonstrate that SCBM mimics the heated RP1 response at room temperature and exhibits minimal temperature sensitivity. With additional optimization of the composition and processing, SCBM could be a drop-in replacement for RP1 that is used at room temperature during BFD quantification with minimal changes to the current RP1 handling protocols and infrastructure. It is anticipated that removing the heating requirement, and temperature-dependence, associated with RP1 will reduce test variability, simplify testing logistics, and enhance test range productivity.
