Comparative stress physiological analysis of aluminium stress tolerance of indigenous maize (Zea mays L.) cultivars of eastern Himalaya.

Yield potential of maize having distinct genetic diversity in Eastern Himalayan Region (EHR) hill ecologies is often limited by Al toxicity caused due to soil acidity. Stress physiological analysis of local check exposed to 0-300 µM Al under sand culture revealed that 150 µM Al as critical and 200 µM Al as tolerable limit. Increase in Al from 0 to 300 µM reduced total chlorophyll, carotenoids by 74.8 % and 44.7 % respectively and enhanced anthocyanin by 35.3 % whereas LA, SLW and SL have reduced by 81.3%, 21.3 % and 47.8 % respectively. R/S ratio was 51.0 and 13.7 % higher at lower Al levels (50 µM and 100 µM) and photosynthetic, transpiration rate and TDM were 62.5 %, 42.9 % and 78.6 % lower at higher Al (300 µM) as compared to control. TRL, RSA, RDW and RV at higher Al (300 µM) were 92.6 %, 98.7 %, 78.7 and 97.5 % lower over control respectively. Root and shoot Al and PUpE at higher Al (300 µM) was 194.0, 69.2 and 830 % higher whereas PUE decreased to 88.5 % over control. Evaluation of 31 indigenous maize cultivars at 0, 150, and 250 µM Al in sand culture, alongside tolerance scoring and assessment, revealed that Megha-9, Megha-10, and MZM-19 exhibits high Al tolerance, Megha-1, MZM-22, and MZM-42 demonstrated moderate tolerance, whereas Uruapara, Sublgarh, and BRL Para were identified as Al-sensitive. Stress physiological parameters like SDW, TDM, TRL, SL and LA contributed 46.02 % of variability to PC1, whereas A, RV, RSA, anthocyanin and Chlorophyll_b, contributed 13.56 % of variability to PC2. Highest values of CMS, SL, LP, LA, TRL and anthocyanin were recorded in cluster I having sensitive cultivars while highest CMS, SL, LA, LP, TRL and RSA were found in cluster II having moderately tolerant cultivars and highest mean values for TRL, RSA, LP, LA, CMS and SL were recorded in cluster III having highly Al stress tolerant cultivars. The traits viz., A, RV, RSA, anthocyanin and Chlorophyll_b, total chlorophyll and TDM were emanated as physio-morphological for assessing Al toxicity stress tolerance in Maize with high divergence values. Tolerant cultivars showing 63.4 % and 22.4 % higher anthocyanin at 150 µM Al and 250 µM Al than moderately tolerant one in acid soil experiment with increased root Al, shoot Al, root P and shoot P by 42.6 %, 11 %, 95.1 % and 34 % respectively were emerged as promising for novel maize improvement under acid soils of EHR.

Fabrication of biochars obtained from valorization of biowaste and evaluation of its physicochemical properties.

This study investigated the yields and the physicochemical properties of biochar from three different feedstocks viz., i) bioenergy byproducts (deoiled cakes of Jatropha carcus and Pongamia glabra), ii) lignocellulose biomass (Jatropha carcus seed cover), and iii) a noxious weed (Parthenium hysterophorus), obtained through slow pyrolysis at a heating rate of 40°Cmin-1 with a nitrogen flow 100mlmin-1 at a temperature range of 350-650°C. For successful utilization of biochar for C-sequestration, its ability to resist abiotic or biotic degradation was deduced from recalcitrance index R50 by using TG analysis. It was observed that the biochar produced at higher temperature had higher water holding capacity (WHC) and pH, suggesting its suitability as an amendment in soil with low water retention capacity; thus biochar may be designed to selectively improve soil chemical and physical properties by altering feedstocks and pyrolysis conditions. Biochar produced at 650°C had highest yield in the range of 28.52-39.9 wt.%.

Effect of torrefaction on yield and quality of pyrolytic products of arecanut husk: An agro-processing wastes.

In the present study, arecanut husk, an agro-processing waste of areca plam industry highly prevalent in the north-eastern region of India, was investigated for its suitability as a prospective bioenergy feedstock for thermo-chemical conversion. Pretreatment of areca husk using torrefaction was performed in a fixed bed reactor with varying reaction temperature (200, 225, 250 and 275°C). The torrefied areca husk was subsequently pyrolyzed from temperature range of 300-600°C with heating rate of 40°C/min to obtain biooil and biochar. The torrefied areca husk, pyrolysis products were characterized by using different techniques. The energy and mass yield of torrefied biomass were found to be decreased with an increase in the torrefaction temperature. Further, biochar were found to be effective in removal of As (V) from aqueous solutions but efficiency of removal was better in case of torrefied biochar. Chemical composition of bio-oil is also influenced by torrefaction process.

Complete utilization of non-edible oil seeds of Cascabela thevetia through a cascade of approaches for biofuel and by-products.

Lipid-rich biomass, generally opted for biodiesel production, produces a substantial amount of by-product (de-oiled cake and seed cover) during the process. Complete utilization of Cascabela thevetia seeds for biofuel production through both chemical and thermochemical conversion route is investigated in the present study. Various properties of biodiesel produced was characterized and compared with those obtained from similar oil seeds. The by-products of the chemical process were used as a feedstock for pyrolysis at different temperatures in a fixed bed reactor. Maximum bio-oil yields of 29.11% and 26.18% were observed at 500°C. The bio-oil obtained at optimum yield was characterized by CHN analyzer, NMR and FTIR spectroscopy. The biochar produced was further characterized by SEM-EDX, XRD and FTIR along with elemental analysis to explore its utilization for various purposes. The present investigation depicts a new approach towards complete utilization of lipid-rich bio-resources to different types of biofuels and biochar.

Pyrolysis of Mesua ferrea and Pongamia glabra seed cover: characterization of bio-oil and its sub-fractions.

In the present study, pyrolysis of Mesua ferrea seed cover (MFSC) and Pongamia glabra seed cover (PGSC) was performed to investigate the characteristics of bio-oil and its sub fractions. In a fixed bed reactor, the effect of temperature (range of 350-650 °C) on product yield and quality of solid product were monitored. The maximum bio-oil yield of 28.5 wt.% and 29.6 wt.% for PGSC and MFSC respectively was obtained at 550 °C at heating rate of 40 °C/min. The chemical composition of bio-oil and its sub fractions were investigated using FTIR and (1)H NMR. GC-MS was performed for both PGSC and MFSC bio-oils and their corresponding n-hexane fractions. The results showed that bio-oil from the feedstocks and its sub-fractions might be a potential source of renewable fuel and value added chemicals.