ABSTRACT
Laser-induced graphene (LIG) emerged as one of the most promising materials for flexible functional devices. However, the attempts to obtain LIG onto elastomeric substrates never succeed, hindering its full exploitation for stretchable electronics. Herein, a novel polymeric composite is reported as a starting material for the fabrication of graphene-based electrodes by direct laser writing. A polyimide (PI) powder is dispersed into the poly(dimethylsiloxane) (PDMS) matrix to achieve an easily processable and functional elastomeric substrate, allowing the conversion of the polymeric surface into laser-induced graphene (LIG). The mechanical and electrical properties of the proposed material can be easily tuned by acting on the polyimide powder concentration. The reported procedure takes advantage from the simple casting process, typical of silicone elastomer, allowing to produce electrodes conformable to any kind of shape and surface as well as complex three-dimensional structures. Electrochemical capacitors and strain gauges are selected as flexible prototypes to demonstrate the multifunctional properties of the obtained LIG on the PDMS/PI composite substrate.
ABSTRACT
Stereolithography 3D printing is today recognized as an effective rapid prototyping technique in the field of polymeric materials, which represents both the strengths and the weaknesses of this technique. The strengths relate to their easy handling and the low energy required for processing, which allow for the production of structures down to the sub-micrometric scale. The weaknesses are a result of the relatively poor mechanical properties. Unfortunately, the choice of the right material is not sufficient, as the printing parameters also play a crucial role. For this reason, it is important to deepen and clarify the effect of different printing conditions on final product characteristics. In this paper, the behavior of commercial Standard Blend (ST Blend) acrylic resin printed with stereolithography (SL) apparatus is reported, investigating the influence of printing parameters on both the tensile properties of the printed parts and the build accuracy. Twenty-four samples were printed under different printing conditions, then dimensional analyses and tensile tests were performed. It was possible to find out the optimum printing setup to obtain the best result in terms of mechanical resistance and printing accuracy for this kind of resin. Finally, a micrometric spring was printed under the optimal conditions to demonstrate the possibility of printing accurate and tiny parts with the commercial and inexpensive STBlend resin.
