Absorbent Filaments from Cellulose Nanofibril Hydrogels through Continuous Coaxial Wet Spinning.

A continuous and scalable method for the wet spinning of cellulose nanofibrils (CNFs) is introduced in a core/shell configuration. Control on the interfacial interactions was possible by the choice of the shell material and coagulant, as demonstrated here with guar gum (GG) and cellulose acetate (CA). Upon coagulation in acetone, ethanol, or water, GG and CA formed supporting polymer shells that interacted to different degrees with the CNF core. Coagulation rate was shown to markedly influence the CNF orientation in the filament and, as a result, its mechanical strength. The fastest coagulation noted for the CNF/GG core/shell system in acetone led to an orientation index of ∼0.55 (Herman's orientation parameter of 0.40), Young's modulus of ∼2.1 GPa, a tensile strength of ∼70 MPa, and a tenacity of ∼8 cN/tex. The system that underwent the slowest coagulation rate (CNF/GG in ethanol) displayed a limited CNF orientation but achieved an intermediate level of mechanical resistance, owing to the strong core/shell interfacial affinity. By using CA as the supporting shell, it was possible to spin CNF into filaments with high water absorption capacity (43 g water/g dry filament). This was explained by the fact that water (used as the coagulant for CA) limited the densification of the CNF core structure, yielding filaments with high accessible area and pore density.

Dry-Spun Single-Filament Fibers Comprising Solely Cellulose Nanofibers from Bioresidue.

We demonstrated that low-cost and environmentally friendly filaments of native cellulose can be prepared by dry spinning an aqueous suspension of cellulose nanofibers (CNF). The CNF were extracted from banana rachis, a bioresidue from banana cultivation. The relationship between spinning rate, CNF concentration, and the mechanical properties of the filaments were investigated and the results showed that the modulus of the filaments was increased from 7.8 to 12.6 GPa and the strength increased from 131 to 222 MPa when the lowest concentration and highest speed was used. This improvement is believed to be due to an increased orientation of the CNF in the filament. A minimum concentration of 6.5 wt % was required for continuous filament spinning using the current setup. However, this relatively high concentration is thought to limit the orientation of the CNF in the filament. The process used in this study has a good potential for upscaling providing a continuous filament production with well-controlled speed, but further work is required to increase the orientation and subsequently the mechanical properties.