Comparative Diminution of Patulin Content in Apple Juice With Food-Grade Additives Sodium Bicarbonate, Vinegar, Mixture of Sodium Bicarbonate and Vinegar, Citric Acid, Baking Powder, and Ultraviolet Irradiation.

This study aimed to determine an optimal method for patulin (PAT) reduction for application in apple juice production. PAT levels in spiked apple juice (100 µg/L) were measured after treatment with citric acid, sodium bicarbonate, vinegar, mixture of sodium bicarbonate and vinegar, baking powder, and ultraviolet (UV) irradiation. Treatments with sodium bicarbonate and UV irradiation were most effective in reducing PAT; however, UV irradiation reduced the yellowness (b∗) of apple juice. However, sodium bicarbonate treatment affected quality attributes including soluble solids, pH, and color of apple juice. The color and odor of apple juice treated with sodium bicarbonate could be recovered via addition of citric acid. The present results suggest that sodium bicarbonate could be considered an additive in apple juice for PAT reduction.

Inhibitory effects of 4-hydroxy-2,5-dimethyl-3(2H)-furanone (HDMF) on acyl-homoserine lactone-mediated virulence factor production and biofilm formation in Pseudomonas aeruginosa PAO1.

4-Hydroxy-2,5-dimethyl-3(2H)-furanone (HDMF), a non-halogenated furanone found in a variety of fruits, has been shown to have antimicrobial activity. However, few studies have focused on its inhibitory effect on bacterial quorum sensing (QS) at levels below the non-inhibitory concentration. In this study, 0.1 µM HDMF decreased the production of QS signal molecules and inhibited QS-controlled biofilm formation by Pseudomonas aeruginosa PAO1 without causing growth inhibition. In the presence of 0.1 and 1.0 µM HDMF, biofilm production by PAO1 was reduced by 27.8 and 42.6%, respectively, compared to that by untreated control cells. HDMF (1.0 µM) also significantly affected virulence factor expression (regulated by the las, rhl, and pqs system), resulting in a significant reduction in the production of LasA protease (53.8%), rhamnolipid (40.9%), and pyocyanin (51.4%). This HDMF-dependent inhibition of virulence factor expression was overcome by increasing the levels of two QS signal molecules of P. aeruginosa, N-(3-oxo-dodecanoyl)-L-homoserine lactone and N-butyryl-L-homoserine lactone, suggesting reversible competitive inhibition between HDMF and these molecules. The results of this study indicate that HDMF has great potential as an inhibitor of QS, and that it may be of value as a therapeutic agent and in biofilm control, without increasing selective pressure for resistance development.

Arsenite oxidation by a facultative chemolithotrophic bacterium SDB1 isolated from mine tailing.

An arsenite (As[III])-oxidizing bacterium, SDB1, was isolated from mine tailing collected from the Sangdong mine area in Korea and showed chemolithotrophic growth on As[III] and CO(2) as the respective electron and carbon sources. SDB1 is Gram-negative, rod-shaped, and belongs to the Sinorhizobium-Ensifer branch of alpha-Proteobacteria. Growth and As[III] oxidation was enhanced significantly by the presence of yeast extract (0.005%) in minimal salt medium containing 5 mM As[III]; decreasing the doubling time from 9.8 to 2.1 h and increasing the As [III] oxidation rate from 0.014 to 0.349 pmol As [III] oxidized cell(-1) h(-1). As[III] oxidation nearly stopped at pH around 4 and should be performed at pH 7 approximately 8 to be most effective. SDB1 was immobilized in calcium-alginate beads and the oxidation capacity was investigated. Specific As[III] oxidation rates obtained with SDB1 (10.1-33.7 mM As[III] oxidized g(-1) dry cell h(-1)) were 10 approximately 16-times higher than those reported previously with a heterotrophic bacterial strain (Simeonova et al., 2005). The stability and reusability of immobilized SDB1 strongly suggested that the immobilized SDB1 cell System can make the As[III] oxidation process technically and economically feasible in practical applications.

Monitoring nutrient impact on bacterial community composition during bioremediation of anoxic PAH-contaminated sediment.

Marine harbor sediments are frequently polluted with significant amount of polycyclic aromatic hydrocarbons (PAHs) some of which are naturally toxic, recalcitrant, mutagenic, and carcinogenic. To stimulate biodegradation of PAHs in PAH-contaminated sediments collected from near Gwangyang Bay, Korea, lactate was chosen as a supplementary carbonaceous substrate. Sediment packed into 600 ml air-tight jar was either under no treatment condition or lactate amended condition (1%, w/v). Microbial community composition was monitored by bacteria-specific and archaea-specific PCR-terminal restriction fragment length polymorphism (T-RFLP), in addition to measuring the residual PAH concentration. Results showed that lactate amendment enhanced biodegradation rate of PAHs in the sediment by 4 to 8 times, and caused a significant shift in archaebacterial community in terms of structure and diversity with time. Phylogenetic analysis of 23 archaeal clones with distinctive RFLP patterns among 288 archaeal clones indicated that majority of the archaeal members were closest to unculturable environmental rDNA clones from hydrocarbon-contaminated and/or methanogenesis-bearing sediments. Lactate amendment led to the enrichment of some clones that were most closely related to PAH-degrading Methanosarcina species. These results suggest a possible contribution of methanogenic community to PAH degradation and give us more insights on how to effectively remediate PAH-contaminated sediments.

Two-step pilot-scale biofilter system for the abatement of food waste composting emission.

A pilot-scale two-step biofilter system was evaluated in treating food waste composting emission for 220 days. Wood chips were packed at the bottom section while mixture of rock wool and earthworm compost (6% w/v) was packed at the top section. Inlet ammonia concentration was found to be dominant and intermittent. The overall ammonia removal of over 98% was achieved, 70% of which was removed in the wood chip section. The highest ammonia elimination capacity was determined to be 39.43 g-NH(3)/m(3)/h at 99.5% removal efficiency. From biodegradation kinetic analysis, the maximum removal rate, V(m), of the wood chip section was determined to be 200 g-NH(3)/m(3)/h and the saturation constant, K(s), 180 mg/m(3). For the rock wool-earthworm cast mixture section, the V(m) was 87 g-NH(3)/m(3)/h and K(s) was 87 mg/m(3). Complete removal of hydrogen sulfide and most trace compounds were achieved by the biofilter. Highest hydrogen sulfide elimination rate was 0.22 g-H(2)S/m(3)/h. The biofilter was optimized from 24 to 16 s EBRT with resulting low average pressure drops of 16 and 29 mm H(2)O/m, respectively.

Enhancing the intrinsic bioremediation of PAH-contaminated anoxic estuarine sediments with biostimulating agents.

Estuarine sediments are frequently polluted with hydrocarbons from fuel spills and industrial wastes. Polycyclic aromatic hydrocarbons (PAHs) are components of these contaminants that tend to accumulate in the sediment due to their low aqueous solubility, low volatility, and high affinity for particulate matter. The toxic, recalcitrant, mutagenic, and carcinogenic nature of these compounds may require aggressive treatment to remediate polluted sites effectively. In petroleum-contaminated sediments near a petrochemical industry in Gwangyang Bay, Korea, in situ PAH concentrations ranged from 10 to 2,900 microg/kg dry sediment. To enhance the biodegradation rate of PAHs under anaerobic conditions, sediment samples were amended with biostimulating agents alone or in combination: nitrogen and phosphorus in the form of slow-release fertilizer (SRF), lactate, yeast extract (YE), and Tween 80. When added to the sediment individually, all tested agents enhanced the degradation of PAHs, including naphthalene, acenaphthene, anthracene, fluorene, phenanthrene, fluoranthene, pyrene, chrysene, and benzo[a]pyrene. Moreover, the combination of SRF, Tween 80, and lactate increased the PAH degradation rate 1.2-8.2 times above that of untreated sediment (0.01-10 microg PAH/kg dry sediment/day). Our results indicated that in situ contaminant PAHs in anoxic sediment, including high molecular weight PAHs, were degraded biologically and that the addition of stimulators increased the biodegradation potential of the intrinsic microbial populations. Our results will contribute to the development of new strategies for in situ treatment of PAH-contaminated anoxic sediments.

Evaluation of bioremediation effectiveness on crude oil-contaminated sand.

A treatability study was conducted using sea sand spiked with 3% or 6% (w/w) of Arabian light crude oil to determine the most effective bioremediation strategies for different levels of contamination. The sea sand used in the study was composed of gravel (0.1%), sand (89.0%), and silt and clay (10.9%). The water content of the sea sand was adjusted to 12.6% (w/w) for the study. Different combinations of the following treatments were applied to the sand in biometer flasks: the concentration of oil (3% or 6%), the concentration of a mixture of three oil-degrading microorganisms (Corynebacterium sp. IC-10, Sphingomonas sp. KH3-2 and Yarrowia sp. 180, 1x10(6) or 1x10(8) cells g-1 sand), the concentration of the surfactant Tween 80 (1 or 10 times the critical micelle concentration), and the addition of SRIF in a C:N:P ratio of 100:10:3. Three biometer flasks per combination of experimental conditions were incubated, and the performance of each treatment was examined by monitoring CO2 evolution, microbial activity, and oil degradation rate. The results suggest that the addition of inorganic nutrients accelerated the rate of CO2 evolution by a factor of 10. The application of oil-degrading microorganisms in a concentration greater than that of the indigenous population clearly increased biodegradation efficiency. The application of surfactant slightly enhanced the oil degradation rate in the contaminated sand treated with the higher concentration of oil-degrading microorganisms. The initial CO2 evolution rate was shown to efficiently evaluate the treatability test by providing significant data within a short period, which is critical for the rapid determination of the appropriate bioremediation approach. The measurements of microbial activity and crude oil degradation also confirmed the validity of the CO2 evolution rate as an appropriate criterion.

Dynamic behavior of compost biofilters during periods of starvation and fluctuating hydrogen sulfide loadings.

To understand transient-state performance of biofilters and the phenomena occurring during changes and interruptions in their operating conditions, dynamic behavior of biofilters exposed to shock loadings of contaminant (H2S) and periods of starvation has been investigated. The initial startup and the response of the biofilters to step changes in the H2S concentration and air-loading rate were also presented and discussed. Biofilters responded very effectively to H2S concentration spikes at H2S mass loading rates of 19.8-48.0 g/m3h by rapidly recovering their original removal rates within 1.2-20.2 min. The recovery time after each spike showed a positive correlation to the total amount of H2S loadings during the spike. Biofilters showed capabilities of withstanding 11-28 days of starvations and recovered their full performances after the starvations without any evident lag period.