ABSTRACT
The crystallization of micrometer-sized particles with shapes mimicking those of tetrabenzoheptacene (TBH) and 1,2:5,6-dibenzanthracene (DBT), both flat polyacenes, in an electric field results in the formation of ordered 2D packings that mimic the plane group symmetries in their respective molecular crystal equivalents. Whereas the particles packed in low-density disordered arrangements under a gravitational gradient, dielectrophoresis (under an ac electric field) produced ordered high-density packings with readily identifiable plane group symmetry. The ordered colloidal assemblies were stable for hours, with the packing density decreasing slowly but with recognizable symmetry for up to 12 h for the TBH-shaped particles and up to 4 h for the DBT-shaped particles. This unexpected stability is attributed to jamming behavior associated with interlocking of the dogbone-shaped (TBH) and Z-block (DBT) particles, contrasting with the more rapid reduction of packing density and loss of hexagonal symmetry for disk-shaped particles upon removal of the electric field. The TBH-shaped and DBT-shaped particles assemble into the p2 plane group, which corresponds to the densest particle packing among the possible close-packed plane groups for these particle symmetries. The p2 symmetry observed for the TBH-shaped and DBT-shaped colloid crystal emulates the p2 symmetry of the (010) layers in their respective molecular crystals, which crystallize in monoclinic lattices. Notably, DBT-shaped particles also form ordered domains with pgg symmetry, replicating the plane group symmetry of the (100) layer in the orthorhombic polymorph of DBT. These observations illustrate that the 2D ordering of colloid particles can mimic the packing of molecules with similar shapes, demonstrating that packing can transcend length scales from the molecular to the colloidal.
ABSTRACT
Although atomic force microscopy (AFM) has emerged as the preeminent experimental tool for real-time in situ measurements of crystal growth processes in solution, relatively little is known about the mass transfer limitations that may impact these measurements. We present a continuum analysis of flow and mass transfer in an atomic force microscope fluid cell during crystal growth, using data acquired from calcium oxalate monohydrate (COM) crystal growth measurements as a comparison. Steady-state flows and solute concentration fields are computed using a three-dimensional, finite element method implemented on a parallel supercomputer. Steady-state flow results are compared with flow visualization experiments to validate the model. Computations of the flow field demonstrate how nonlinear momentum transport alters the spatial structure of the flow with increasing flow volume, altering mass transport conditions near the AFM cantilever and tip. The simulations demonstrate that the combination of solute depletion from crystal growth and mass transfer resistance lowers the solute concentration in the region between the tip and the crystal compared with the solute concentration at the inlet of the AFM cell. For example, using experimentally measured growth rates for COM, the solute concentration in this region is 3.1% lower than the inlet value because the solute consumed by crystal growth beneath the AFM tip cannot be replenished fully due to mass transport limitations. The simulations also reveal that increasing the flow rate through the cell does not affect this difference significantly because of the inherent shielding by the AFM tip in proximity with the crystal surface. Models such as the one presented here, used in conjunction with AFM measurements, promise more precise interpretations of measurement data.
