High throughput assay to detect compounds that enhance the proton permeability of Candida albicans membranes.

We describe a 96-well microtiter plate format assay to detect changes in proton permeability in membranes of the pathogenic yeast, Candida albicans. Candida albicans cells were incubated with the lipophilic ester of 2',7'-bis-(2-carboxyethyl)-5-(and-6)-carboxyfluorescein (BCECF), a pH-sensitive fluorescein derivative. Inside the cells, BCECF was released and trapped in the vacuole. Compounds that destroyed membrane integrity increased the pH value of the vacuole due to proton leakage into the cytoplasm. This was paralleled by an increase in BCECF fluorescence intensity, which could be quantified. The test assay was validated with amphotericin B, as well as with other membrane-active compounds known to increase membrane permeability. Possible applications and limitations of this assay in the field of antifungal drug discovery are discussed.

On-line measurement of microvascular diameter and red blood cell velocity by a line-scan CCD image sensor.

A line-scan charge-coupled device (CCD) image sensor (256 photo sites) was equipped for on-line measurement and calculation of red blood cell velocity and microvascular diameter. The principle of measurement is based on a sequential readout of the CCD-sensor photo signal at predefined time intervals. The velocity is calculated by a computer by cross correlation of a given set of readouts. Rotation of the sensor into a position perpendicular to the microvessel axis allows measurement of the diameter, which is related to the red blood cell column moving under the sensor. At low magnification (up to 38-fold) diameters up to 80 microns can be measured. Calibration, which was performed by comparing diameters measured in vivo by the CCD-based system with microphotographically obtained measurements, revealed a mean CCD/photo ratio of 0.98 +/- 0.08. Calibration of velocity measurements in glass tubes of different diameters by a calibrated pump with known bulk flow resulted in a mean conversion factor of 1.59 +/- 0.2 (mean +/- SD). The CCD sensor is mounted such that it can freely rotate on the microscope. In conjunction with a programmable scanning table, several vessels can be measured sequentially in one preparation. The interval between two combined measurements and calculations of velocity and diameter is 1.1 sec.

Measurement of regional myocardial blood flow with multiple colored microspheres.

BACKGROUND: The use of radioactive microspheres (RM) for the measurement of regional myocardial blood flow (RMBF) is limited and inaccessible to many investigators due to radiation safety concerns and radioactive waste disposal problems. Therefore, a new method for the measurement of RMBF using colored microspheres (CM) was developed. METHODS AND RESULTS: Polystyrene spheres (diameter, 15 +/- 0.1 [SD] micron; density, 1.09 g/ml) were dyed with one of five colors. With the injection of CM into the left atrium or into a coronary perfusion line, RMBF and its distribution can be determined. CM are extracted from the myocardium and blood by digestion with potassium hydroxide and subsequent microfiltration. The dyes are then recovered from the CM within a defined volume of a solvent, and their concentrations are determined by spectrophotometry. The separation of composite absorbance spectra by spectrophotometry with the CM technique was as good as the separation of energy spectra by a gamma-counter using the RM technique. Leaching of dye from the CM was less than 0.1% during a 2-month period in vitro. Significant leaching of dye from the microspheres also did not occur during 8 hours in the blood and myocardium of four anesthetized dogs in vivo. For further validation of this method, pairs of CM and RM (15.5 +/- 0.1 [SD] microns) were simultaneously injected under five different RMBF conditions (range, 0-10 ml/[min.g]) into the left anterior descending coronary artery of four anesthetized pigs, with coronary inflow as a flow reference, or into the left atrium of four anesthetized dogs using aortic blood withdrawal as a reference. The relation between RMBF determined by CM and RM was CM = 0.01 + 1.00.RM (r = 0.98, n = 1,080 data points) in the pigs, and CM = -0.19 + 0.92.RM (r = 0.97, n = 1,813 data points) in the dogs. CONCLUSIONS: Measurement of RMBF with CM yields values very similar to those of RM. Their use is less expensive and avoids all the disadvantages related to radioactivity, thus offering an alternative method for as many as five RMBF measurements in a single experiment.

Spontaneous and experimentally evoked [Ca2+]i-transients in cardiac myocytes measured by means of a fast Fura-2 technique.

A setup for dual wavelength-excitation fluorescence measurements is introduced which permits a temporal resolution of up to 1 KHz, using the Ca2(+)-sensitive fluorescent dye Fura-2. The system makes use of a novel technical solution for chopping between two excitation wavelengths which does not move any optical components. Two beams, which are alternatively opened or shut by a rotating chopper wheel, are united by a dichroic mirror and are used for low-noise epifluorescence microscopy. The system includes a device for fast changes of extracellular solution that can be used for studying various components of [Ca2+]i-regulation in excitable and non-excitable cells. Sample recordings of spontaneous and experimentally-evoked [Ca2+]i-transients from cardiac myocytes are presented. Cardiac myocytes are a cell species that produces particularly fast [Ca2+]i-transients and therefore, a high temporal resolution is required in order to study physiological and/or pharmacological properties of these transients.