A graphene-based platform for induced pluripotent stem cells culture and differentiation.

Induced pluripotent stem cells (iPSCs) hold great promise as a cell source for regenerative medicine yet its culture, maintenance of pluripotency and induction of differentiation remain challenging. Conversely, graphene (G) and graphene oxide (GO) have captured tremendous interests in the fields of materials science, physics, chemistry and nanotechnology. Here we report on that G and GO can support the mouse iPSCs culture and allow for spontaneous differentiation. Intriguingly, G and GO surfaces led to distinct cell proliferation and differentiation characteristics. In comparison with the glass surface, iPSCs cultured on the G surface exhibited similar degrees of cell adhesion and proliferation while iPSCs on the GO surface adhered and proliferated at a faster rate. Moreover, G favorably maintained the iPSCs in the undifferentiated state while GO expedited the differentiation. The iPSCs cultured on both G and GO surfaces spontaneously differentiated into ectodermal and mesodermal lineages without significant disparity, but G suppressed the iPSCs differentiation towards the endodermal lineage whereas GO augmented the endodermal differentiation. These data collectively demonstrated that the different surface properties of G and GO governed the iPSCs behavior and implicate the potentials of graphene-based materials as a platform for iPSCs culture and diverse applications.

A method for the fabrication of low-noise carbon fiber nanoelectrodes.

A new and facile method has been developed for the fabrication of low-noise carbon fiber microelectrodes (CFMEs) and carbon fiber nanoelectrodes (CFNEs). The carbon fiber was flame-fuse sealed in the tip of the glass capillary. The CFMEs were made by cutting the protruding carbon fiber to the desired length, and the CFNEs were achieved by etching the protruding carbon on the flame to form a nanometer-scale tip. The tip of CFNEs can be controlled within the range from 100 to 300 nm. Thus, no epoxy wax was involved in the CFMEs and CFNEs. The experimental results of inspecting CFMEs and CFNEs by scanning electron microscopy demonstrated that the surface of the electrodes and the glass/fiber interface are very smooth. Therefore, the noise caused by the glass/fiber of these electrodes is much lower than that of the electrodes fabricated conventionlly. The electrodes were characterized by ferricyanide, catecholamine (dopamine,DA), norepinephrine (NE), and epinephrine (E)) and 5-hydroxytryptamine (5-HT) neurotransmitters using CV, LSV, DPV, and FSCV. The results showed that the CFMEs and CFNEs have very excellent electrochemical behavior and high sensitivity. The CV and DPV detection limits of DA, NE, and E are 7.6 x 10(-8), 7.0 x 10(-8), and 5.0 x 10(-8) mol/L, and the DPV detection limits of DA, NE, and E are 4.0 x 10(-8), 1.0 x 10(-7), and 2.2 x 10(-7) mol/L, respectively. This experiment offers a new and facile method for the fabrication of CFMEs and CFNEs of very high sensitivity and low noise.

Interactions of benzyl viologen with surface-bound single- and double-stranded DNA.

The interactions of benzyl viologen (BV) with single- and double-stranded calf-thymus DNA immobilized onto gold electrodes have been studied by electrochemical methods. Benzyl viologen interacts electrostatically with both double-stranded (ds) and single-stranded (ss) DNA, and the strength of the interactions is dependent on ionic strength (mu). The dicationic form (BV2+) binds to dsDNA 9 times more strongly than the singly reduced form, BV*+, in a pH 7.4 Tris-HCl buffer solution at mu = 8.4 mM. BV2+ binds to ssDNA 5 times more strongly than the BV*+ form. From measurements at mu = 8.4 mM, a binding constant (K2+) of 2.0 (+/-0.2) x 10(4) M(-1) and a binding site size (s) of 1 base pair were obtained, respectively, for dsDNA. For ssDNA, at the same ionic strength, the values obtained for K and s were 3.6 (+/-0.4) x10(4) M(-1) and 2 nucleotides, respectively. The amount of BV bound, whether to dsDNA or ssDNA, decreased with increasing ionic strength. Whereas the binding rate of BV to both dsDNA and ssDNA immobilized onto gold electrodes is relatively low, once immobilized, it dissociates rapidly away from the electrode surface. The electron-transfer rate constant for BV is moderately fast at both dsDNA- and ssDNA-modified gold electrodes. The application of benzyl viologen as an electroactive indicator capable of differentiating between surface-immobilized single- and double-stranded DNA in denaturation/regeneration cycles has been explored.

DNA-modified electrodes; part 4: optimization of covalent immobilization of DNA on self-assembled monolayers.

The covalent immobilization of DNA onto self-assembled monolayer (SAM) modified gold electrodes (SAM/Au) was studied by X-ray photoelectron spectrometry and electrochemical method so as to optimize its covalent immobilization on SAMs. Three types of SAMs with hydroxyl, amino, and carboxyl terminal groups, respectively, were examined. Results obtained by both X-ray photoelectron spectrometry and cyclic voltammetry show that the largest covalent immobilization amount of dsDNA could be gained on hydroxyl-terminated SAM/Au. The ratio of amount of dsDNA immobilized on hydroxyl-terminated SAMs to that on carboxyl-terminated SAMs and to that on amino-terminated SAMs is (3-3.5): (1-1.5): 1. The dsDNA immobilized covalently on hydroxyl-terminated SAMs accounts for 82.8-87.6% of its total surface amount (including small amount of dsDNA adsorbed). So the hydroxyl-terminated SAM is a good substrate for the covalent immobilization of dsDNA on gold surfaces.

Micromethod for the investigation of the interactions between DNA and redox-active molecules.

A novel microscale and surface-based method for the study of the interactions of DNA with other redox-active molecules using DNA-modified electrodes is described. The method is simple, convenient, reliable, reagent-saving, and applicable for DNA studies, especially those involving microsamples. Information such as binding site size (s, in base pairs), binding constant (K), ratio (K0x/KRed) of the binding constants for the oxidized and reduced forms of a bound species, binding free energy (delta Gb), and interaction mode, including changes in the mode of interaction, and "limiting" ratio K0x0/KRed0 at zero ionic strength can be obtained using only 3-15 micrograms of DNA samples. The method was developed using [Co(Phen)3]3+/2+ (Phen = 1,10-phenanthroline)/double-stranded DNA (dsDNA)-modified gold electrodes and [Co(bpy)3]3+/2+ (2,2'-bipyridyl)/dsDNA-modified gold electrodes as model systems. For the [Co(Phen)3]3+/2+/dsDNA-modified gold electrode system, a K2+ of (2.5 +/- 0.3) x 10(5) M-1 and an s of 5 bp were obtained in 5 mM pH 7.1 Tris-HCl buffer solution containing 50 mM NaCl. For [Co(bpy)3]3+/2+/dsDNA-modified gold electrodes, K3+ and s values of (1.3 +/- 0.3) x 10(5) M-1 and 3 bp, respectively, were obtained. While the s values are consistent with those reported in the literature obtained by solution methods, the K values are almost an order of magnitude larger. A transition in the nature of the interaction between dsDNA and [Co(Phen)3]3+/2+, from electrostatic to intercalative with increasing ionic strength, was found in our studies. Negative values of delta E0' for [Co(bpy)3]3+/2+ bound to dsDNA suggest that its interaction with dsDNA is predominantly electrostatic over the ionic strength range of 5-105 mM. The "limiting" ratio K3+0/K2+0 of 22 obtained for [Co(Phen)3]3+/2+ bound to dsDNA at zero ionic strength suggests that electrostatic interactions are predominant over intercalative ones under these limiting conditions. The ratio for [Co(bpy)3]3+/2+ of 16 also indicates that the 3+ form binds to dsDNA more strongly than the 2+ form at zero ionic strength. For [Co(Phen)3]3+/2+/single-stranded DNA (ssDNA)-modified gold electrodes, the nonuniformity of the surface structure of ssDNA-modified gold electrodes greatly complicates the analysis. A system consisting of a dsDNA-modified gold electrode and [Co(tppz)2]3+/2+ (tppz = tetra-2-pyridyl-1,4-pyrazine) was studied by this method, with a K2+ value of (5 +/- 1) x 10(5) M-1 and an 8 value of 7 bp being obtained.

[Effect of (+/-)12-chloroscoulerine on brain dopamine receptors].

AIM: To assess potencies of tetrahydroprotoberberines (THPB) and hydrobenzyltetrahydroisoquinolines (HBTI) on DA receptors. METHODS: The receptor binding assay with calf striatum to D1 and D2 receptors, and the animal behavior tests were used. RESULTS: (+/-) 12-Chloroscoulerine (CSL) was the most potent one among the THPB and HBTI. The affinities of CSL to D1 and D2 receptors were 13 and 51 nmol.L-1, respectively. In rats, CSL showed an antagonistic effect on the stereotypy and induced catalepsy. In the 6-OHDA lesioned rats, however, CSL exerted the agonistic effect to DA receptors. CONCLUSION: CSL had dual actions to DA receptors and its effects were similar to that of (-)stepholidine.