ABSTRACT
The rheological properties of the Zr-2.5Nb alloy by the strain rate range of 0.5-15 s-1 and by the temperature range of 20-770 °C was studied. The dilatometric method for phase states temperature ranges was experimentally determined. A material properties database for computer FEM simulation regards the indicated temperature-velocity ranges were created. Using this database and DEFORM-3D FEM-softpack, the radial shear rolling complex process numerical simulation was carried out. The contributed conditions for the ultrafine-grained state alloy structure refinement were determined. Based on the simulation results, a full-scale experiment of Zr-2.5Nb rod rolling a on a radial-shear rolling mill RSP-14/40 was carried out. It takes in seven passes from a diameter of 37-20 mm with a total diameter reduction ε = 85%. According to this case simulation data, the total equivalent strain in the most processed peripheral zone 27.5 mm/mm was reached. Due to the complex vortex metal flow, the equivalent strain over the section distribution was uneven with a gradient reducing towards the axial zone. This fact should have a deep effect on the structure change. Changes and structure gradient by sample section EBSD mapping with 2 mm resolution were studied. The microhardness section gradient by the HV 0.5 method was also studied. The axial and central zones of the sample by the TEM method were studied. The rod section structure has an expressed gradient from the formed equiaxed ultrafine-grained (UFG) structure on a few outer millimeters of the peripheral section to the elongated rolling texture in the center of the bar. The work shows the possibility of processing with the gradient structure obtaining and enhanced properties for the Zr-2.5Nb alloy, and a database for this alloy FEM numerical simulations are also presents.
ABSTRACT
The method of radial shear rolling makes it possible to achieve comparable to high pressure torsion (HPT) method ultrahigh degrees of total strain level in combination with the vortex metal flow character for long-length large bulk bars unable by HPT and many other processes of sever plastic deformation (SPD). Sequential rolling of the Zr-1%Nb alloy was carried out under extreme conditions on two radial shear rolling mills with a total diameter reduction ε = 185% and a maximum total strain level = 46 mm/mm. The strain level and its cross-section distribution assessment by finite element method (FEM) simulation was studied. The final bar cross-section structure type distribution detailed study 1 mm resolution by electron back scatter diffraction (EBSD) mapping was performed. A gradient structure with a predominance of the equiaxed ultrafine-grained (UFG) state was found. The deformation level rising did not allow to refine it in the periphery zone more than that obtained nearly middle of the processing, but it allows for significant change in the axial zone structure. The additional large warm deformations by radial shear rolling have no additional grain refinement effect for already 300-600 nm refined zone. An equiaxed UFG structure was obtained in a relatively large volume of the sample with a reduced gradient towards the non-UFG center zone in regard to known works.
ABSTRACT
An overview of the prospects for the development of nuclear technologies and the conclusion of the relevant requirements for advanced structural materials, their classification and features were performed. In order to obtain a bar with a modified radiation-resistant outer layer, an experiment of radial-shear rolling under the most stringent conditions was carried out. For the same conditions, a FEM-simulation of sequential rolling in eight passes with a total compression of 70.7% (from a diameter of 37 mm to 20 mm) was conducted. For adequate simulation results a new material database for Zr-1%Nb alloy using plastometry investigations was generated. An experimental obtaining of a gradient-modified structure with an ultrafine-grained (UFG) periphery and an elongated rolling texture in the center of the bar was performed.
