ABSTRACT
A linear anionic polysaccharide, sodium alginate, electrostatically interacts with a cationic polysaccharide, quaternized hydroxyethyl cellulose ethoxylate, in aqueous solution, thus giving an interpolyelectrolyte complex. Aqueous solutions of the initial polysaccharides and polycomplexes with an excess of the cationic or anionic polymers were used for the stabilization of soil and sand against water erosion. Physicochemical, mechanical and biological properties of the polymers and coatings were characterized by gravimetric analysis, viscosimetry, mechanical strength assessment, cell viability, and cell-mediated degradation with the following main conclusions. (a) Non-stoichiometric polycomplexes with an excess of cationic or anionic units ("cationic" and "anionic" polycomplexes, respectively) form transparent solutions or stable-in-time dispersions. (b) The complexation results in a decrease in the viscosity of polymer solutions. (c) A complete dissociation of polycomplexes to the initial components is achieved in a 0.2 M NaCl solution. (d) Soil/sand treatment with 1 wt% aqueous solutions of polymers or polycomplexes and further drying lead to the formation of strong composite coatings from polymer(s) and soil/sand particles. (e) Cationic polycomplexes form stronger coatings in comparison with anionic polycomplexes. (f) The polymer-soil coatings are stable towards re-watering, while the polymer-sand coatings show a much lower resistance to water. (g) The individual polysaccharides demonstrate a negligible toxicity to Gram-negative and Gram-positive bacteria and yeast. (h) The addition of Bacillus subtilis culture initiates the degradation of the polysaccharides and polycomplexes. (i) Films from polysaccharides and polycomplexes decompose down to small fragments after being in soil for 6 weeks. The results of the work are of importance for constructing water-resistant, low toxicity and biodegradable protective coatings for soil and sand.
ABSTRACT
A linear polycation, poly(diallyldimethylammonium chloride), electrostatically interacts with anionic latex particles from a carboxylated butadiene-styrene copolymer in aqueous solution thus forming an interpolyelectrolyte complex. A mutual neutralization of oppositely charged latex and polycation groups occurs at W = latex/polycation = 50 w/w ratio. At W = 27, an ultimate polycation adsorption is reached, resulting in the formation of positive polycomplex particles, while at W Ë 27, two-component systems are formed composed of positive polycomplex particles and free polycation. A film created from the W = 12 formulation shows a high toxicity to Gram-positive and Gram-negative bacteria and yeast. Repeated washing the film leads to partial removal of polycation and a 50% decrease in the activity of the film only towards Gram-negative Pseudomonas aeruginosa. The results indicate the potential for use of the mixed polymer formulations for the fabrication of antimicrobial films and coatings.
ABSTRACT
Wide usage of clay-based materials in industry requires investigations concerning efficient modification techniques to control their mechanical behavior in aqueous media. The challenging problem in this field involves minimization of the modifying agent content to provide marked changes in the operating characteristics of the material. In this work, the physicochemical, mechanical and structural aspects of the interaction of capillary water-saturated kaolinite with polyelectrolytes were studied. Modification of kaolinite with a negligible amount (0.1 wt.%) of hydrophilic and amphiphilic polyelectrolytes provides the control for rheological parameters of kaolinite suspensions such as storage and loss modulus in the range of three orders of magnitude. The results obtained reveal the wide possibilities for the production of a spectrum of clay materials using minor amounts of polymer modifying agents.
ABSTRACT
The initial-stage dynamics of flocculation of positively charged latex particles induced by polyelectrolytes (PEs) and polyelectrolyte complexes (PECs), composed of linear polyacrylic acid (PAA) and a PAA-based hydrophilic microgel (PAA#) with a small amount of a linear polycation, was comparatively analyzed by applying the standardized colloidal mixing procedure. Based on the rate of flocculation, this method allows us to investigate the dynamics of flocculation immediately after the onset. In addition to confirming the prediction made regarding the initial rate of flocculation with linear polyanions-which was mostly similar to that observed in negatively charged colloids with positively charged PEs-we have confirmed two important new results regarding the microgel: (1) the increase of the initial rate is less markedly affected by the microgel concentration than by the linear polymer concentration, which can be explained by the fact that the three-dimensional (3D) cross-linked structure of the microgel that does not deform as easily as the linear structure upon touching the colloidal surface; and (2) there is a remarkable increase of the initial rate due to the contribution of instant aggregation of the negatively charged microgel induced by the polycation adsorption. These results suggest the significance of state and formation dynamics of PECs prior to reaching the surface of targeted colloidal particles for the intension of effective flocculation. These aspects are not treated so far in the dynamic process of flocculation.
ABSTRACT
Wide-angle X-ray scattering observations of alpha-cyclodextrin (CD)-poly(ethylene glycol) (PEG) inclusion complexes (ICs) have shown for the first time that two crystalline columnar modifications (forms I and II) are produced in the process of their formation. This was made possible by precise azimuthal X-ray diffraction scanning of oriented IC samples. Form I is characterized by CDs threaded onto PEG chains and arranged along channels in the order head-to-head/tail-to-tail, while form II is formed by unbound CDs also arranged into columns in a head-to-tail and also possibly a head-to-head/tail-to-tail manner, probably as a result of template crystallization on the form I IC crystals. It was shown that similar structural peculiarities are inherent for channel structures based on ICs obtained with PEG with a wide range of molecular weights (MWs). The characteristic feature of ICs based on PEG, especially with MW > 8000, is the presence of unbound polymer in the composition of the complex. The amount of unbound PEG was shown to rise with increasing MW of PEG, resulting in greater imperfections in the IC crystalline structure. The polyblock structure of ICs based on alpha-CD and PEG was therefore proposed.