ABSTRACT
The article presents the possibility of increasing the water resistance of gypsum binders (GBs) obtained based on synthetic gypsum by introducing additives derived from industrial wastes. Regularities were obtained for the influence of the type and amount of additives on the water/gypsum ratio (W/G), strength indicators and water resistance of high-strength GB. The introduction of a single-component additive to improve water resistance does not have a significant effect. Complex additives based on Portland cement, granulated blast-furnace slag, electric steel-smelting slag, expanded clay dust and granite screenings of various fractions have been developed that make the maximum contribution to improving the water resistance of a high-strength GB based on synthetic calcium sulphate dihydrate, which made it possible to increase the water-resistance coefficient from 0.39 to 0.82.
ABSTRACT
Waste recycling and industrial wastewater treatment have always been of interest. A green approach was developed for the filtrate of synthetic gypsum production from water treatment coagulation sediments and spent sulfuric acid. Due to the high concentration of iron sulfate, concentrated filtrate showed good coagulation results, which were 5% lower than pure iron sulfate. In addition, a high concentration of iron facilitates its use as a precursor for synthesizing magnetic sorbents and photocatalysts. Such materials were synthesized by the solution combustion synthesis method. Oil sorption capacity reached 1.8 g/g, comparable to some synthetic materials and higher than sorption materials based on natural materials. Photodegradation of acid telon blue dye after 90 min of irradiation time was 82.7% with catalyst derived from filtrate compared to the just dye solution with 17.6% efficiency. The reaction rate constant for the photocatalyst sample was up to 11.4-fold higher compared with only UV treatment. The neutralized filtrate containing sulfur, calcium, magnesium, and sodium has been tested as a complex fertilizer. The results of bioindication for oil radish showed up to a 15% increase in the shoot length. A number of techno-economic indicators show that such an approach is advantageous from a technological, environmental, and economic point of view.
Subject(s)
Calcium Sulfate , Water Purification , Magnesium , Adsorption , IronABSTRACT
In this work, Cu-Sn-TiO2 composite coatings were electrochemically obtained from a sulfate bath containing 0-10 g/L of TiO2 nanoparticles. The effect of TiO2 particles on kinetics of cathodic electrodeposition has been studied by linear sweep voltammetry and chronopotentiometry. As compared to the Cu-Sn alloy, the Cu-Sn-TiO2 composite coatings show rougher surfaces with TiO2 agglomerates embedded in the metal matrix. The highest average amount of included TiO2 is 1.7 wt.%, in the case of the bath containing 5 g/L thereof. Composite coatings showed significantly improved antibacterial properties towards E. coli ATCC 8739 bacteria as compared to the Cu-Sn coatings of the same composition. Such improvement has been connected with the corrosion resistance of the composites studied by linear polarization and electrochemical impedance spectroscopy. In the bacterial media and 3% NaCl solutions, Cu-Sn-TiO2 composite coatings have lower corrosion resistance as compared to Cu-Sn alloys, which is caused by the nonuniformity of the surface.
