Field-Effect Transistors Based on Networks of Highly Aligned, Chemically Synthesized N = 7 Armchair Graphene Nanoribbons.

We report on the experimental demonstration and electrical characterization of N = 7 armchair graphene nanoribbon (7-AGNR) field effect transistors. The back-gated transistors are fabricated from atomically precise and highly aligned 7-AGNRs, synthesized with a bottom-up approach. The large area transfer process holds the promise of scalable device fabrication with atomically precise nanoribbons. The channels of the FETs are approximately 30 times longer than the average nanoribbon length of 30 nm to 40 nm. The density of the GNRs is high, so that transport can be assumed well-above the percolation threshold. The long channel transistors exhibit a maximum ION/ IOFF current ratio of 87.5.

Electrical properties of graphene-metal contacts.

The performance of devices and systems based on two-dimensional material systems depends critically on the quality of the contacts between 2D material and metal. A low contact resistance is an imperative requirement to consider graphene as a candidate material for electronic and optoelectronic devices. Unfortunately, measurements of contact resistance in the literature do not provide a consistent picture, due to limitations of current graphene technology, and to incomplete understanding of influencing factors. Here we show that the contact resistance is intrinsically dependent on graphene sheet resistance and on the chemistry of the graphene-metal interface. We present a physical model of the contacts based on ab-initio simulations and extensive experiments carried out on a large variety of samples with different graphene-metal contacts. Our model explains the spread in experimental results as due to uncontrolled graphene doping and suggests ways to engineer contact resistance. We also predict an achievable contact resistance of 30 Ω·µm for nickel electrodes, extremely promising for applications.

Note: fast and reliable fracture strain extraction technique applied to silicon at nanometer scale.

Simple fabrication process and extraction procedure to determine the fracture strain of monocrystalline silicon are demonstrated. Nanowires/nanoribbons in silicon are fabricated and subjected to uniaxial tensile stress along the complete length of the beams. Large strains up to 5% are measured for nanowires presenting a cross section of 50 nm × 50 nm and a length of 2.5 µm. An increase in fracture strain for silicon nanowires (NWs) with the downscaling of their volume is observed, highlighting the reduction of the defects probability as volume is decreased.