Impact of source-separation of urine on treatment capacity, process design, and capital expenditure of a decentralised wastewater treatment plant.

In this study, the impact of urine diversion on the treatment capacity, treatment process, and capital costs of a decentralised wastewater treatment plant (WWTP) was simulated using BioWin. The data for simulation including for economic analysis were obtained from a real decentralised WWTP at Sydney. Simulation was conducted for two alternative process design scenarios of a WWTP: membrane bioreactor (MBR) without denitrification and anaerobic MBR in place of aerobic MBR and compared to existing process design. The simulation shows that with about 75% urine diversion (through source separation), the treatment capacity of the existing WWTP can be doubled although above 40% urine diversion, the impact appears less rapid. When the urine diversion exceeds 75%, it was found that the anoxic tank for biological denitrification becomes redundant and the current wastewater treatment process could be replaced with a simpler and much less aeration intensive membrane bioreactor (MBR) producing similar effluent quality with a 24% reduction in capital expenditure (footprint) cost. Anaerobic MBR can be a potential alternative to aerobic MBR although pre-treatment becomes essential before reverse osmosis treatment for water reuse applications. Sensitivity analysis has revealed that by operating the bioreactor at higher mixed liquor suspended solids concentrations (9 g/L instead of 5 g/L) could help increase the WWTP treatment capacity by about 3.5 times at 75% urine diversion. Hence, urine diversion (until nitrogen-limiting conditions occur above 75% urine diversion) can increase the treatment capacity of an existing WWTP and reduce the capital expenses due to reduced plant footprint.

Biomethane production from anaerobic co-digestion at wastewater treatment plants: A critical review on development and innovations in biogas upgrading techniques.

Anaerobic co-digestion (AcoD) can utilise spare digestion capacity at existing wastewater treatment plants (WWTP) to generate surplus biogas beyond the plant's internal energy requirement. Data from industry reports and the peer-reviewed literature show that through AcoD, numerous examples of WWTPs have become net energy producers, necessitating other high-value applications for surplus biogas. A globally emerging trend is to upgrade biogas to biomethane, which can then be used as town gas or transport fuel. Water, organic solvent and chemical scrubbing, pressure swing adsorption, membrane separation, and cryogenic technology are commercially available CO2 removal technologies for biogas upgrade. Although water scrubbing is currently the most widely applied technology due to low capital and operation cost, significant market growth in membrane separation has been seen over the 2015-2019 period. Further progress in materials engineering and sciences is expected and will further enhance the membrane separation competitiveness for biogas upgrading. Several emerging biotechnologies to i) improve biogas quality from AcoD; ii) accelerate the absorption rate, and iii) captures CO2 in microalgal culture have also been examined and discussed in this review. Through a combination of AcoD and biogas upgrade, more WWTPs are expected to become net energy producers.

Simultaneous nitrification-denitrification using baffled osmotic membrane bioreactor-microfiltration hybrid system at different oxic-anoxic conditions for wastewater treatment.

The efficacy of a baffled osmotic membrane bioreactor-microfiltration (OMBR-MF) hybrid system equipped with thin film forward osmosis membrane for wastewater treatment was evaluated at laboratory scale. The novel OMBR-MF hybrid system involved baffles, that separate oxic and anoxic zones in the aerobic reactor for simultaneous nitrification and denitrification (SND), and a bioreactor comprised of thin film composite-forward osmosis (TFC-FO) and polyether sulfone-microfiltration (PES-MF) membranes. The evaluation was conducted under four different oxic-anoxic cycle patterns. Changes in flux, salinity build-up, and microbial activity (e.g., extracellular polymeric substances (EPS) were assessed. Over the course of a 34 d test, the OMBR-MF hybrid system achieved high removal of total organic carbon (TOC) (86-92%), total nitrogen (TN) (63-76%), and PO4-P (57-63%). The oxic-anoxic cycle time of 0.5-1.5 h was identified to be the best operating condition. Incorporation of MF membrane effectively alleviated salinity build-up in the reactor, allowing stable system operation.

Efficient fouling control using outer-selective hollow fiber thin-film composite membranes for osmotic membrane bioreactor applications.

This paper investigates the efficiency of fouling mitigation methods using a novel outer selective hollow fiber thin-film composite forward osmosis (OSHF TFC FO) membrane for osmosis membrane bioreactor (OMBR) system treating municipal wastewater. Two home-made membrane modules having similar transport properties were used. Two operation regimes with three different fouling mitigation strategies were utilized to test the easiness of membrane for fouling cleaning. These two membrane modules demonstrated high performance with high initial water flux of 14.4 LMH and 14.1 LMH and slow increase rate of mixed liquor's salinity in the bioreactor using 30 g/L NaCl as draw solution. OMBR system showed high removals of total organic carbon and NH4 + -N (>98%). High fouling cleaning efficiency was achieved using OSHF TFC FO membrane with different fouling control methods. These results showed that this membrane is suitable for OMBR applications due to its high performance and its simplicity for fouling mitigation.

Combining high performance fertiliser with surfactants to reduce the reverse solute flux in the fertiliser drawn forward osmosis process.

Solutions to mitigate the reverse diffusion of solutes are critical to the successful commercialisation of the fertiliser drawn forward osmosis process. In this study, we proposed to combine a high performance fertiliser (i.e., ammonium sulfate or SOA) with surfactants as additives as an approach to reduce the reverse diffusion of ammonium ions. Results showed that combining SOA with both anionic and non-ionic surfactants can help in reducing the reverse salt diffusion by up to 67%. We hypothesised that, hydrophobic interactions between the surfactant tails and the membrane surface likely constricted membrane pores resulting in increased rejection of ions with large hydrated radii such as SO42-. By electroneutrality, the rejection of the counter ions (i.e., NH4+) also therefore subsequently improved. Anionic surfactant was found to further decrease the reverse salt diffusion due to electrostatic repulsions between the surfactant negatively-charged heads and SO42-. However, when the feed solution contains cations with small hydrated radii (e.g., Na+); it was found that NH4+ ions can be substituted in the DS to maintain its electroneutrality and thus the diffusion of NH4+ to the feed solution was increased.

Evaluating the effect of different draw solutes in a baffled osmotic membrane bioreactor-microfiltration using optical coherence tomography with real wastewater.

This study investigated the performance of an integrated osmotic and microfiltration membrane bioreactor for real sewage employing baffles in the reactor. To study the biofouling development on forward osmosis membranes optical coherence tomography (OCT) technique was employed. On-line monitoring of biofilm growth on a flat sheet cellulose triacetate forward osmosis (CTA-FO) membrane was conducted for 21 days. Further, the process performance was evaluated in terms of water flux, organic and nutrient removal, microbial activity in terms of soluble microbial products (SMP) and extracellular polymeric substance (EPS), and floc size. The measured biofouling layer thickness was in the order sodium chloride (NaCl) > ammonium sulfate (SOA) > potassium dihydrogen phosphate (KH2PO4). Very high organic removal (96.9 ±â€¯0.8%) and reasonably good nutrient removal efficiency (85.2 ±â€¯1.6% TN) was achieved. The sludge characteristics and biofouling layer thickness suggest that less EPS and higher floc size were the governing factors for less fouling.

Assessing the removal of organic micropollutants by a novel baffled osmotic membrane bioreactor-microfiltration hybrid system.

A novel approach was employed to study removal of organic micropollutants (OMPs) in a baffled osmotic membrane bioreactor-microfiltration (OMBR-MF) hybrid system under oxicanoxic conditions. The performance of OMBR-MF system was examined employing three different draw solutes (DS), and three model OMPs. The highest forward osmosis (FO) membrane rejection was attained with atenolol (100%) due to its higher molar mass and positive charge. With inorganic DS caffeine (94-100%) revealed highest removal followed by atenolol (89-96%) and atrazine (16-40%) respectively. All three OMPs exhibited higher removal with organic DS as compared to inorganic DS. Significant anoxic removal was observed for atrazine under very different redox conditions with extended anoxic cycle time. This can be linked with possible development of different microbial consortia responsible for diverse enzymes secretion. Overall, the OMBR-MF process showed effective removal of total organic carbon (98%) and nutrients (phosphate 97% and total nitrogen 85%), respectively.

Performance of a novel baffled osmotic membrane bioreactor-microfiltration hybrid system under continuous operation for simultaneous nutrient removal and mitigation of brine discharge.

The present study investigated the performance of an integrated osmotic and microfiltration membrane bioreactor system for wastewater treatment employing baffles in the reactor. Thus, this reactor design enables both aerobic and anoxic processes in an attempt to reduce the process footprint and energy costs associated with continuous aeration. The process performance was evaluated in terms of water flux, salinity build up in the bioreactor, organic and nutrient removal and microbial activity using synthetic reverse osmosis (RO) brine as draw solution (DS). The incorporation of MF membrane was effective in maintaining a reasonable salinity level (612-1434mg/L) in the reactor which resulted in a much lower flux decline (i.e. 11.48-6.98LMH) as compared to previous studies. The stable operation of the osmotic membrane bioreactor-forward osmosis (OMBR-FO) process resulted in an effective removal of both organic matter (97.84%) and nutrient (phosphate 87.36% and total nitrogen 94.28%), respectively.