ABSTRACT
Fluorescence in situ hybridization (FISH) using fluorochrome-labeled DNA oligonucleotide probes has been successfully applied for in situ detection of anaerobic ammonium oxidizing (anammox) bacteria. However, application of the standard FISH protocols to visualize anammox bacteria in biofilms from a laboratory-scale wastewater reactor produced only weak signals. Increased signal intensity was achieved either by modifying the standard FISH protocol, using peptide nucleic acid probes (PNA FISH), or applying horse radish peroxidase- (HRP-) labeled probes and subsequent catalyzed reporter deposition (CARD-FISH). A comparative analysis using anammox biofilm samples and suspended anammox biomass from different laboratory wastewater bioreactors revealed that the modified standard FISH protocol and the PNA FISH probes produced equally strong fluorescence signals on suspended biomass, but only weak signals were obtained with the biofilm samples. The probe signal intensities in the biofilm samples could be enhanced by enzymatic pre-treatment of fixed cells, and by increasing the hybridization time of the PNA FISH protocol. CARD-FISH always produced up to four-fold stronger fluorescent signals but unspecific fluorescence signals, likely caused by endogenous peroxidases as reported in several previous studies, compromised the results. Interference of the development of fluorescence intensity with endogenous peroxidases was also observed in cells of aerobic ammonium oxidizers like Nitrosomonas europea, and sulfate-reducers like Desulfobacter postgatei. Interestingly, no interference was observed with other peroxidase-positive microorganisms, suggesting that CARD-FISH is not only compromised by the mere presence of peroxidases. Pre-treatment of cells to inactivate peroxidase with HCl or autoclavation/pasteurization failed to inactive peroxidases, but H(2)O(2) significantly reduced endogenous peroxidase activity. However, for optimal inactivation, different H(2)O(2) concentrations and incubation time may be needed, depending on nature of sample and should therefore always be individually determined for each study.
Subject(s)
Bacteria, Anaerobic/isolation & purification , Biofilms , In Situ Hybridization, Fluorescence/methods , Water Microbiology , Water Purification/methods , Bacteria, Anaerobic/genetics , Bacteria, Anaerobic/metabolism , Hydrogen Peroxide/metabolism , Oxidation-Reduction , Peroxidases/antagonists & inhibitors , Quaternary Ammonium Compounds/metabolism , Sensitivity and SpecificityABSTRACT
Few reports on in situ mRNA detection in bacteria have been published, even though a major aim in environmental microbiology is to link function/activity to the identity of the organisms. This study reports a reliable approach for the in situ detection of nifH mRNA using fluorescence hybridization based on a previously described protocol for pmoA. nifH codes for a dinitrogenase reductase, a key enzyme in dinitrogen fixation. nifH mRNA was hybridized with a digoxigenin-labelled polynucleotide probe. The hybrid was detected with an anti-DIG-antibody labelled with horseradish peroxidase. Subsequently, the signal was amplified by catalyzed reporter deposition (CARD) with fluorochrome-labelled tyramides. Furthermore, the imaged organisms were identified using standard fluorescence in situ hybridization of rRNA. Thus, the approach enabled us specifically to link in situ the information from the dinitrogen fixation activity of an organism to its identity. Unexpectedly, the signals derived from nifH mRNA hybridization showed a distinct uneven pattern within the cells. This indicated that the method used could even give insights about the localization of the detected mRNA within the cell, which is a potential use of mRNA fluorescence in situ hybridization (FISH) that has not been reported up to now for bacterial cells.
