ABSTRACT
An important disadvantage of current dental resin composites is polymerization shrinkage. This shrinkage has clinical repercussions such as sensitivity, marginal discoloration, and secondary caries. The objective of this study was to compare three filling techniques in terms of the transient stresses induced at the resin composite/tooth interface during polymerization. The techniques were: bulk filling (B), three horizontal increments (HI), and three wedge increments (WI). A simple Class V cavity preparation was modeled in finite element analysis. Polymerization shrinkage was simulated by a thermal stress analogy, thereby causing 1% shrinkage due to an arbitrary coefficient of thermal expansion. Interface normal and shear stresses were calculated at nine steps during polymerization, proceeding from 0% to 100% volume of cured resin. The importance of the interface transient stresses was revealed by the finding that, in most cases, their peak values exceeded the final or residual stress. Also, the WI and B techniques consistently exhibited the highest and lowest maximum transient stresses, respectively. These results from the simple model of a Class V restoration suggest that bulk filling of light-cured resin composites should be used in restorations which are sufficiently shallow to be cured to their full depth.
Subject(s)
Composite Resins/chemistry , Dental Restoration, Permanent/methods , Dental Stress Analysis/methods , Chemical Phenomena , Chemistry, Physical , Dental Cavity Preparation , Differential Thermal Analysis , Hot Temperature , Humans , Light , Models, Chemical , Polymers , ThermodynamicsABSTRACT
The purpose of this project was to determine if alveolar bone modeling could be associated with altered mechanical environment. Finite element stress analysis of an orthodontically tipped rat molar periodontium was performed. The distributions of mechanical components within the periodontal ligament and cortical bone were compared to the well-documented bone formation and resorption patterns in the alveolus of the tooth. It was concluded that in orthodontically induced bone modeling activity, locations of osteogenesis uniquely coincided with increased tension within the periodontal ligament, while bone resorption areas could be associated with increases in other components (minimum principal and maximum shear stresses, strain energy density, and von Mises) within the bone itself.
