The effect of transient operations on the levels and congener profiles of PCBz, PCPh and PCDD/F in raw flue gases of MSWI plant.

The concentrations and congener profiles of polychlorinated benzenes, phenols, dibenzo-p-dioxin and dibenzofurans, measured in raw flue gases of a real MSWI plant, are discussed in this paper. The data covers steady-state and transient operation conditions, including the memory effect period close to two shutdowns. The highest levels of concentrations of the pollutants were observed the first day after the shutdown with subsequent gradual decrease towards steady-state values. The conditions of the steady-state period prior to shutdown are decisive for the increase of start-up values, memory effect values and memory effect length. We found that the above-mentioned pollutants had a different length of the memory effect period. It can be concluded that under plant transient operation the formation of pollutants by the de novo synthesis is higher than under steady-state conditions.

Effect of fuels and domestic heating appliance types on emission factors of selected organic pollutants.

This study reports on the first complex data set of emission factors (EFs) of selected pollutants from combustion of five fuel types (lignite, bituminous coal, spruce, beech, and maize) in six different domestic heating appliances of various combustion designs. The effect of fuel as well as the effect of boiler type was studied. In total, 46 combustion runs were performed, during which numerous EFs were measured, including the EFs of particulate matter (PM), carbon monoxide, polyaromatic hydrocarbons (PAH), hexachlorobenzene (HxCBz), polychlorinated dibenzo-p-dioxins and furans (PCDD/F), etc. The highest EFs of nonchlorinated pollutants were measured for old-type boilers with over-fire and under-fire designs and with manual stoking and natural draft. Emissions of the above-mentioned pollutants from modern-type boilers (automatic, downdraft) were 10 times lower or more. The decisive factor for emission rate of nonchlorinated pollutants was the type of appliance; the type of fuel plays only a minor role. Emissions of chlorinated pollutants were proportional mainly to the chlorine content in fuel, but the type of appliance also influenced the rate of emissions significantly. Surprisingly, higher EFs of PCDD/F from combustion of chlorinated bituminous coal were observed for modern-type boilers (downdraft, automatic) than for old-type ones. On the other hand, when bituminous coal was burned, higher emissions of HxCBz were found for old-type boilers than for modern-type ones.

Thermochemical properties and relative stability of polychlorinated biphenyls.

The values of thermochemical quantities (enthalpy and Gibbs energy of formation, entropy and molar heat capacity) in the ideal gas state and dihedral angles for all 209 polychlorinated biphenyls were obtained by the Benson contribution method and ab initio calculations. The di-, tri- and tetra-ortho-chlorinated biphenyls are related with properties of WHO non-ortho- and mono-ortho-biphenyls in connection with their potential human toxicities.

Matrix effects on the de novo synthesis of polychlorinated dibenzo-p-dioxins, dibenzofurans, biphenyls and benzenes.

The formation of polychlorinated dibenzo-p-dioxins, dibenzofurans, biphenyls and benzenes in de novo synthesis experiments have been studied on model fly ashes with a wide range of matrices. The model fly ash consisted of 18 selected matrices with the addition of CuCl(2) x 2H(2)O, activated charcoal and NaCl. The studied matrices were not restricted to the commonly investigated matrices with defined chemical composition (silica gel, alumina, florisil) and industrially produced adsorbents with silicate structures (diatomaceous earths), but also included natural occurring matrices (clays, kaolin, bentonite and feldspars). In addition fly ashes from a hazardous waste incinerator were included in the study for comparison. Differences in the isomer composition (homologue profiles and isomer patterns) of the substances formed by de novo synthesis experiments are discussed in dependence on the chemical composition of the studied matrices. The de novo synthesis experiments on matrices with silicate structures resulted in high concentration of mainly perchlorinated aromatic compounds while for other matrices in particular alkaline matrices a homologue shift to lower chlorinated homologues and lower formation rates were found. The paper discusses the resulting PCDD/PCDF pattern and compares them to the PCDD/PCDF profile found in naturally occurring kaolin and ball clay (illite).

Dechlorination ability of municipal waste incineration fly ash for polychlorinated phenols.

Pathways of pentachlorophenol dechlorination have been investigated on municipal waste incineration fly ash at 200 degrees C under nitrogen atmosphere. Thermodynamic calculations have been carried out for these dechlorination conditions using the method of total Gibbs energy minimization for the whole system consisting of gaseous components, i.e., chlorinated phenols, phenol, hydrogen chloride and the Cu3Cl3 trimer and of solid Cu2O and CuCl2 components. The effects of water, temperature and of the amounts of the reaction components on the thermodynamic equilibrium have been discussed and the experimental results compared with the calculated thermodynamic data.

Dehalogenation potential of municipal waste incineration fly ash. II. Comparison of dehalogenation pathways of fly ash and model fly ash with thermodynamic calculations.

BACKGROUND, AIMS AND SCOPE: In the first part of this paper the main principles which control the dehalogenation of polychlorinated aromatic compounds on municipal waste incineration fly ash (MWI-FA) have been discussed and the model fly ash of similar dehalogenation activity has been proposed. Even if both systems show comparable dehalogenation properties, the main question concerning the postulated identical reaction mechanism in both cases is left unanswered. The other very important point is to what extent is this dechlorination mechanism thermodynamically controlled. The same problem is often discussed in the literature also for the de novo synthetic reactions. From the data it is clear that metallic copper plays a decisive role in the mechanism of the dehalogenation reaction. Although the results reported in the first part strongly support the idea that copper acts in this dechlorination as the reaction component, in contrast to its generally accepted catalytic behaviour, we believed that additional support for this conclusion can be obtained with the help of a thermodynamic interpretation of the mechanism of the reaction. RESULTS AND DISCUSSION: The pathways of hexachlorobenzene dechlorination on MWI-FA and model fly ash were studied in a closed system at 260-300 degrees C under nitrogen atmosphere. These pathways were the same for both systems, with the following prevailing sequences: hexachlorobenzene --> pentachlorobenzene --> 1,2,3,5-tetrachlorobenzene --> 1,3,5-trichlorobenzene --> 1,3-dichlorobenzene. Thermodynamic calculations were carried out by using the method of minimization total Gibbs energy of the whole system. In the calculations, the following reaction components were taken into account: all gaseous chlorinated benzenes, benzene, hydrogen chloride, a gaseous trimer Cu3Cl3, and also Cu2O and CuCl2 as solid components. The effect of the reaction temperature and the amount of copper and water vapour were considered as well. The effect of reaction temperature was determined from the data calculated for the 500 to 750 K temperature region. The effect of the initial composition was determined for the molar amounts of copper = 0.01-3 moles and water vapour = 0.2 to 3 moles per mole of chlorobenzene isomer CONCLUSIONS: The results of hexachlorobenzene dechlorination by MWI-FA and model fly ash under comparable reaction conditions allow us to conclude that both dechlorinations proceed via the same dechlorination pathways, which can be taken as an evidence of the identical dehalogenation mechanism for both systems. The relative percentual distribution of the dehalogenated products depends on the temperature, but not on the initial amount of water vapour or copper metal. On the other hand, the initial amount of copper substantially affects the conversion of the dehalogenation as well as the molar ratio of Cu3Cl3 to HCl in the equilibrium mixture. Comparison of the experimental with thermodynamic results supports the idea that dehalogenation reactions are thermodynamically controlled. RECOMMENDATIONS AND OUTLOOK: Thermodynamic analysis of the dehalogenation reactions may prove useful for a wide range of pollutants. The calculations concerning polychlorinated biphenyls and phenols are under study.

Dehalogenation potential of municipal waste incineration fly ash. I. General principles.

BACKGROUND, AIMS AND SCOPE: It is well known that the fly ash from filters of municipal waste incinerators (MWI-FA) shows dehalogenation properties after heating it to 240-450 degrees C. However, this property is not general, and fly ash samples do not possess dehalogenation ability at all in many cases. Fly ash has a very variable composition, and the state of the fly ash matter therefore plays the decisive role. In the present paper, the function of important components responsible for the dehalogenation activity of MWI-FA is analysed and compared with the model fly ash. METHODS: With the aim of accounting for the dehalogenation activity of MWI-FA, the following studies of hexachlorobenzene (HCB) dechlorination were performed: The role of copper in dehalogenation experiments was evaluated for five types of metallic copper. The gasification of carbon in MWI-FA was studied in the 250-350 degrees C temperature range. Five different kinds of carbon were used, combined with conventional Cu(o) and activated nanosize copper powder. The dechlorination experiments were also carried out with Cu(II) compounds such as CuO, Cu(OH)2, CuCl2 and CuSO4. The results were discussed from the standpoint of thermodynamics of potential reactions. Based on these results, the model of fly ash was proposed, containing silica gel, metallic copper and carbon. The dechlorination ability of MWI-FA and the model fly ash are compared under oxygen-deficient atmosphere. CONCLUSIONS: The results show that, under given experimental conditions, copper acts in the dechlorination as a stoichiometric agent rather than as a catalyst. The increased surface activity of copper enhances its dechlorination activity. It was found further that the presence of copper leads to a decrease in the temperature of carbon gasification. The cyclic valence change from Cu(o) to Cu+ or Cu2+ is a prerequisite for the dehalogenation to take place. RECOMMENDATION AND OUTLOOK: Thermodynamic analysis of the dechlorination effect, as well as the comparison of dechlorination pathways on MWI-FA and model fly ash, can provide a deeper understanding of the studied reaction.