Improved in vitro rooting in liquid culture using a two piece scaffold system.

Plant tissue culture techniques have been used to propagate horticultural crops at a commercial scale for more than three decades. However, due to the high cost it is generally only used for high value crops. To increase production efficiency and make micropropagation viable for a wider range of species, new approaches to address key steps of the process with high labor inputs need to be evaluated. For this study, a two-piece scaffold system was designed, prototyped using 3D printing, and tested to physically hold plants upright thereby facilitating liquid based rooting. This system was evaluated with Malus domestica, Betula lenta, and Musa sp. using static liquid culture as well as rocker based temporary immersion system and compared to rooting in semi-solid based medium as is commonly practiced. Significantly, earlier rooting was observed in all three species in liquid when compared to semi-solid culture system, and plants cultured in liquid on the rocker generally performed better than those in static liquid. In addition to quicker, more uniform rooting, reducing labor requirements, and preventing root damage. This newly designed system is simple, easy to use, will help to improve efficiency, and reduce the cost of micropropagation.

Application of 3D printing to prototype and develop novel plant tissue culture systems.

BACKGROUND: Due to the complex process of designing and manufacturing new plant tissue culture vessels through conventional means there have been limited efforts to innovate improved designs. Further, development and availability of low cost, energy efficient LEDs of various spectra has made it a promising light source for plant growth in controlled environments. However, direct replacement of conventional lighting sources with LEDs does not address problems with uniformity, spectral control, or the challenges in conducting statistically valid experiments to assess the effects of light. Prototyping using 3D printing and LED based light sources could help overcome these limitations and lead to improved culture systems. RESULTS: A modular culture vessel design in which the fluence rate and spectrum of light are independently controlled was designed, prototyped using 3D printing, and evaluated for plant growth. This design is compatible with semi-solid and liquid based culture systems. Observations on morphology, chlorophyll content, and chlorophyll fluorescence based stress parameters from in vitro plants cultured under different light spectra with similar overall fluence rate indicated different responses in Nicotiana tabacum and Artemisia annua plantlets. This experiment validates the utility of 3D printing to design and test functional vessels and demonstrated that optimal light spectra for in vitro plant growth is species-specific. CONCLUSIONS: 3D printing was successfully used to prototype novel culture vessels with independently controlled variable fluence rate/spectra LED lighting. This system addresses several limitations associated with current lighting systems, providing more uniform lighting and allowing proper replication/randomization for experimental plant biology while increasing energy efficiency. A complete procedure including the design and prototyping of a culture vessel using 3D printing, commercial scale injection molding of the prototype, and conducting a properly replicated experiment are discussed. This open source design has the scope for further improvement and adaptation and demonstrates the power of 3D printing to improve the design of culture systems.