ABSTRACT
A compact active x-ray beamstop has been developed for the SWING beamline at Synchrotron SOLEIL with two main functions, blocking the x-ray beam directly transmitted by the sample to protect the Dectris EigerX4M 2D detector and monitoring its intensity. The beamstop is composed of a sensor inserted in a well of tungsten carbide. The sensor is based on a piece of free-standing single crystal chemical vapor deposited diamond used in the ionization chamber mode. The beamstop has been installed on the beamline detector stage within the detection vacuum chamber, just upstream of the large 2D detector. The intensity monitoring performance (rms noise over signal) is shown to be better than 0.06% and the linearity is shown to be better than 2% for over more than five decades. The beamstop has been calibrated between 5 and 16 keV to provide the photon flux measurements in absolute units (ph/s). The specific design of the beamstop increases the small-angle x-ray scattering q-range by a factor of 1.5 in the low angle side, as compared to the previous active beamstop, based on a more standard commercial Si diode. The beamstop has been available for three years for SWING user operation (5-17 keV). It is fully compatible with the different beamline operating modes and fluxes, except in the microbeam mode, where the very divergent beam becomes too large at the beamstop position, and the previous, larger, beamstop is then more appropriate.
ABSTRACT
A single crystal chemical vapor deposition diamond-based microdosimeter prototype featuring an array of micro-sensitive volumes (µSVs) and surrounded by a so-called guard ring (GR) electrode has been fabricated using various microfabrication techniques available at Diamond Sensors Laboratory of CEA, Saclay. The GR microdosimeter was irradiated by a raster scanning method with 2 MeV proton microbeams. The charge transport properties of the GR sensor were determined with sub-micron spatial resolution by measuring the charge collection efficiency (CCE), the µSV geometry, and the pulse-height spectra. The response of the microdosimeter showed a well-defined and homogeneously active µSV. Appropriate biasing of the µSV structures led toward a full CCE for protons with lineal energies of â¼46 keV/µm. This shows the GR microdosimeter's great potential for applications in microdosimetry in clinical beam conditions.
Subject(s)
Diamond , Proton Therapy/instrumentation , Radiometry/instrumentation , Electrodes , VolatilizationABSTRACT
The most remote isotope from the proton dripline (by 4 atomic mass units) has been observed: ^{31}K. It is unbound with respect to three-proton (3p) emission, and its decays have been detected in flight by measuring the trajectories of all decay products using microstrip detectors. The 3p emission processes have been studied by the means of angular correlations of ^{28}S+3p and the respective decay vertices. The energies of the previously unknown ground and excited states of ^{31}K have been determined. This provides its 3p separation energy value S_{3p} of -4.6(2) MeV. Upper half-life limits of 10 ps of the observed ^{31}K states have been derived from distributions of the measured decay vertices.
ABSTRACT
This article reports on the development of thin diamond detectors and their characterization for their application in temporal profile measurements of subnanosecond ion bunches. Two types of diamonds were used: a 20 µm thin polycrystalline chemical vapor deposited (CVD) diamond and a membrane with a thickness of (5 ± 1) µm etched out of a single crystal (sc) CVD diamond. The combination of a small detector electrode and an impedance matched signal outlet leads to excellent time response properties with a signal pulse resolution (FWHM) of τ = (113 ± 11) ps. Such a fast diamond detector is a perfect device for the time of flight measurements of MeV ions with bunch durations in the subnanosecond regime. The scCVD diamond membrane detector was successfully implemented within the framework of the laser ion generation handling and transport project, in which ion beams are accelerated via a laser-driven source and shaped with conventional accelerator technology. The detector was used to measure subnanosecond proton bunches with an intensity of 108 protons per bunch.
ABSTRACT
Ion stopping experiments in plasma for beam energies of few hundred keV per nucleon are of great interest to benchmark the stopping-power models in the context of inertial confinement fusion and high-energy-density physics research. For this purpose, a specific ion detector on chemical-vapor-deposition diamond basis has been developed for precise time-of-flight measurements of the ion energy loss. The electrode structure is interdigitated for maximizing its sensitivity to low-energy ions, and it has a finger width of 100 µm and a spacing of 500 µm. A short single α-particle response is obtained, with signals as narrow as 700 ps at full width at half maximum. The detector has been tested with α-particle bunches at a 500 keV per nucleon energy, showing an excellent time-of-flight resolution down to 20 ps. In this way, beam energy resolutions from 0.4 keV to a few keV have been obtained in an experimental configuration using a 100 µg/cm2 thick carbon foil as an energy-loss target and a 2 m time-of-flight distance. This allows a highly precise beam energy measurement of δE/E ≈ 0.04%-0.2% and a resolution on the energy loss of 0.6%-2.5% for a fine testing of stopping-power models.
ABSTRACT
Small diamond detectors are useful for the dosimetry of high-energy proton beams. However, linear energy transfer (LET) dependence has been observed in the literature with such solid state detectors. A novel synthetic diamond detector has recently become commercially available from the manufacturer PTW-Freiburg (PTW microDiamond type 60019). This study was designed to thoroughly characterize four microDiamond detectors in clinical proton beams, in order to investigate their response and their reproducibility in high LET regions. Very good dosimetric characteristics were observed for two of them, with good stability of their response (deviation less than 0.4% after a pre-irradiation dose of approximately 12 Gy), good repeatability (coefficient of variation of 0.06%) and a sensitivity of approximately 0.85 nC Gy(-1). A negligible dose rate dependence was also observed for these two microDiamonds with a deviation of the sensitivity less than 0.7% with respect to the one measured at the reference dose rate of 2.17 Gy min(-1), in the investigated dose rate range from 1.01 Gy min(-1) to 5.52 Gy min(-1). Lateral dose profile measurements showed the high spatial resolution of the microDiamond oriented with its stem perpendicular to the beam axis and with its small sensitive thickness of about 1 µm in the scanning profile direction. Finally, no significant LET dependence was found with these two diamond dosimeters in comparison to a reference ionization chamber (model IBA PPC05). These good results were in accordance to the literature. However, this study showed also a non reproducibility between the devices in terms of stability, sensitivity and LET dependence, since the two other microDiamonds characterized in this work showed different dosimetric characteristics making them not suitable for proton beam dosimetry with a maximum difference of the peak-to-plateau ratio of 6.7% relative to the reference ionization chamber in a clinical 138 MeV proton beam.
Subject(s)
Proton Therapy/methods , Radiation Dosimeters/standards , Diamond/chemistry , Diamond/radiation effects , Linear Energy Transfer , Proton Therapy/instrumentation , Proton Therapy/standards , Radiometry/instrumentation , Radiometry/methodsABSTRACT
Previously unknown isotopes (30)Ar and (29)Cl have been identified by measurement of the trajectories of their in-flight decay products (28)S+p+p and (28)S+p, respectively. The analysis of angular correlations of the fragments provided information on decay energies and the structure of the parent states. The ground states of (30)Ar and (29)Cl were found at 2.25(-0.10)(+0.15) and 1.8±0.1 MeV above the two- and one-proton thresholds, respectively. The lowest states in (30)Ar and (29)Cl point to a violation of isobaric symmetry in the structure of these unbound nuclei. The two-proton decay has been identified in a transition region between simultaneous two-proton and sequential proton emissions from the (30)Ar ground state, which is characterized by an interplay of three-body and two-body decay mechanisms. The first hint of a fine structure of the two-proton decay of (30)Ar*(2(+)) has been obtained by detecting two decay branches into the ground and first-excited states of the (28)S fragment.
ABSTRACT
Fetal ovarian cyst is diagnosed at the rate of one per 2,500 live births and its behaviour in utero may range from spontaneous resolution with no further consequences to torsion, necrosis, and to the necessity of surgical treatment in the postnatal stage. Ovarian cyst torsion in a fetus results in the loss of its reproductive function in adult life. The authors present a case of spontaneous resolving fetal ovarian cyst. The lesion was diagnosed during an ultrasound scan in 30th week of pregnancy. An ultrasound scan performed two weeks later revealed symptoms of cyst torsion; the lesion was 5.7 cm in diameter, heterogeneous, and had a normoechogenic inside. A subsequent ultrasound exam showed a lesion with a diameter of 2.16 cm. An ultrasound exam of the newborn's abdominal cavity performed on the second day showed that the cyst was six mm in diameter. However, the cyst did not show on an ultrasound scan made on the fourth day.
Subject(s)
Fetal Diseases/diagnostic imaging , Ovarian Cysts/diagnostic imaging , Ultrasonography, Prenatal , Adult , Female , Humans , Infant, Newborn , Pregnancy , Pregnancy Trimester, Third , Remission, SpontaneousABSTRACT
Recent developments of new therapy techniques using small photon beams, such as stereotactic radiotherapy, require suitable detectors to determine the delivered dose with a high accuracy. The dosimeter has to be as close as possible to tissue equivalence and to exhibit a small detection volume compared to the size of the irradiation field, because of the lack of lateral electronic equilibrium in small beam. Characteristics of single crystal diamond (tissue equivalent material Z = 6, high density) make it an ideal candidate to fulfil most of small beam dosimetry requirements. A commercially available Element Six electronic grade synthetic diamond was used to develop a single crystal diamond dosimeter (SCDDo) with a small detection volume (0.165 mm(3)). Long term stability was studied by irradiating the SCDDo in a (60)Co beam over 14 h. A good stability (deviation less than ± 0.1%) was observed. Repeatability, dose linearity, dose rate dependence and energy dependence were studied in a 10 × 10 cm(2) beam produced by a Varian Clinac 2100 C linear accelerator. SCDDo lateral dose profile, depth dose curve and output factor (OF) measurements were performed for small photon beams with a micro multileaf collimator m3 (BrainLab) attached to the linac. This study is focused on the comparison of SCDDo measurements to those obtained with different commercially available active detectors: an unshielded silicon diode (PTW 60017), a shielded silicon diode (Sun Nuclear EDGE), a PinPoint ionization chamber (PTW 31014) and two natural diamond detectors (PTW 60003). SCDDo presents an excellent spatial resolution for dose profile measurements, due to its small detection volume. Low energy dependence (variation of 1.2% between 6 and 18 MV photon beam) and low dose rate dependence of the SCDDo (variation of 1% between 0.53 and 2.64 Gy min(-1)) are obtained, explaining the good agreement between the SCDDo and the efficient unshielded diode (PTW 60017) in depth dose curve measurements. For field sizes ranging from 0.6 × 0.6 to 10 × 10 cm(2), OFs obtained with the SCDDo are between the OFs measured with the PinPoint ionization chamber and the Sun Nuclear EDGE diode that are known to respectively underestimate and overestimate OF values in small beam, due to the large detection volume of the chamber and the non-water equivalence of both detectors.