ABSTRACT
Aqueous film forming foam (AFFF)-impacted asphalt and concrete may serve as potential secondary sources of per- and polyfluoroalkyl substances (PFAS) to the environment through surficial leaching. We aimed to understand the vertical distribution and surficial release of PFAS from AFFF-impacted asphalt and concrete cores collected from various locations (â¼10-70 m distance between samples). Among the PFAS analyzed, 6:2 FTS was observed as having the highest concentration in the surface layer (0 - 0.5 cm) of concrete (225 µg kg-1) and in the runoff from the concrete (2600 ng L-1). PFOS was detected at the highest concentration in the surface layer (0 - 0.5 cm) of asphalt (47 µg kg-1) and associated runoff (780 ng L-1). The total mass of PFAS released during three rainfall simulations accounts for a fraction of the total mass in the surface layer (0 - 0.5 cm), ranging from 0.10 - 9.8% and 0.078 - 2.4% for asphalt and concrete cores, respectively. Asphalt exhibited a higher release rate than concrete, demonstrated by the higher total release coefficient of PFAS (4 - 16 m-2) compared to that of concrete cores (1 - 5 m-2). These results suggested that, similar to concrete, AFFF-impacted asphalt may be a secondary source of PFAS to the environment.
ABSTRACT
Per- and polyfluoroalkyl substances (PFAS) within concrete pads impacted by historical firefighting training using aqueous film-forming foam (AFFF) may be potential secondary sources of PFAS due to surficial leaching. This study aimed to (i) characterize the effectiveness of two commercially available sealants (Product A and Product B) in mitigating leaching of five PFAS (e.g., PFOS, PFOA, PFHxS, PFHxA, 6:2 FTS) from concrete surfaces at the laboratory-scale, and (ii) develop a model to forecast cumulative leaching of the same five PFAS over 20 years from sealed and unsealed concrete surfaces. Laboratory trials demonstrated that both sealants reduced the surficial leaching of the five PFAS studied, and Product B demonstrated a comparatively greater reduction in surface leaching than Product A as measured against unsealed controls. The cumulative PFOS leaching from an unsealed concrete surface is estimated by the model to be about 400 mg/m2 over 20 years and reached asymptotic conditions after 15 years. In contrast, the model output suggests asymptotic conditions were not achieved within the modeled time of 20 years after sealing with Product A and 85% of PFOS was predicted to have leached (â¼340 mg/m2). Negligible leaching of PFOS after sealing with Product B was observed ( < 5 × 10-9 mg/m2). Results from modeled rainfall scenarios suggest PFAS leachability is reduced from sealed versus unsealed AFFF-impacted concrete surfaces.
