ABSTRACT
The effect of particle size and oxidation degree of new carbon microfillers, based on coal pitch (CP) and petroleum pitch (PET) cokes, on the structure as well as thermal, mechanical, and electrical properties of the composites based on ultrahigh molecular weight polyethylene (UHMWPE) was investigated. The composites studied have a segregated structure of filler particle distribution in the UHMWPE matrix. It was found that composite with smaller CP grain fraction has the highest Young's modulus and electrical conductivity compared to the other composites studied, which can be the result of a large contribution of flake-shaped particles. Additionally, conductivity of this composite turned out to be similar to composites with well-known carbon nanofillers, such as graphene, carbon black, and CNTs. Additionally, the relationship between electrical conductivity and Young's modulus values of composites studied was revealed, which indicates that electrical conductivity is very sensitive to the structure of the filler phase in the polymer matrix. In general, it was established that the properties, especially the electrical conductivity, of the composites studied strongly depends on the size, shape, and oxidative treatment of CP and PET filler particles, and that the CP coke of appropriately small particle sizes and flake shape has significant potential as a conductive filler for polymer composites.
ABSTRACT
This work presents the results of a tribological examination of polymer matrix composites reinforced with carbon foams with different porosity. The application of open-celled carbon foams allows an easy infiltration process by liquid epoxy resin. At the same time, carbon reinforcement remains its initial structure, which prevents its segregation in polymer matrix. Dry friction tests, conducted under 0.7, 2.1, 3.5 and 5.0 MPa loads, show that higher friction load results in higher mass loss, but it strongly lowers the coefficient of friction (COF). The change in coefficient of friction is related to the size of the pores of the carbon foam. Open-celled foams with pores size below 0.6 mm (40 and 60 ppi), used as a reinforcement in epoxy matrix, allow to obtain COF twice lower than composite reinforced with 20 ppi open-celled foam. This phenomenon occurs due to a change of friction mechanisms. In composites reinforced with open-celled foams, general wear mechanism is related to destruction of carbon components, which results in solid tribofilm formation. The application of novel reinforcement, in the form of open-celled foams with stable distance between carbon components, allows the decrease of COF and the improvement of stability, even under a very high friction load.
ABSTRACT
The current status of knowledge regarding magnetic hybrid structures based on graphene or carbon nanotubes with various forms of iron oxides is reviewed. The paper starts with a summary of the preparation and properties of iron oxide nanoparticles, both untreated and coated with silica or polymer layers. In the next section, organic-inorganic hybrid materials obtained as a result of a combination of graphene or carbon nanotubes and iron chemical compounds are characterized and discussed. These hybrids constitute an increasing percentage of all consumable high performance biomedical, electronic, and energy materials due to their valuable properties and low production costs. The potential of their application as components of materials used in corrosion protection, catalysis, spintronics, biomedicine, photoelectrochemical water splitting and groundwater remediation, as well as magnetic nanoparticles in polymer matrices, are also presented. The last part of this review article is focused on reporting the most recent developments in design and the understanding of the properties of polymer composites reinforced with nanometer-sized iron oxide/graphene and iron oxide/carbon nanotubes hybrid fillers. The discussion presents comparative analysis of the magnetic, electromagnetic shielding, electrical, thermal, and mechanical properties of polymer composites with various iron oxide/graphene structures. It is shown that the introduction of hybrid filler nanoparticles into polymer matrices enhances both the macro- and microproperties of final composites as a result of synergistic effects of individual components and the simultaneous formation of an oriented filler network in the polymer. The reinforcing effect is related to the structure and geometry of hybrid nanoparticles applied as a filler, the interactions between the filler particles, their concentration in a composite, and the method of composite processing.
