Your browser doesn't support javascript.
loading
Show: 20 | 50 | 100
Results 1 - 2 de 2
Filter
Add more filters










Database
Language
Publication year range
1.
Chemosphere ; 349: 140880, 2024 Feb.
Article in English | MEDLINE | ID: mdl-38061564

ABSTRACT

In order to verify that coagulation as pre-treatment can reduce the temperature of the hot air used for direct contact evaporating the leachate concentrate (LC) and low-grade waste heat such as exhaust steam in the waste incineration plant can be used to evaporate the LC. The supernatants after coagulation using polymerized ferrous sulfate (PFS), polymeric-aluminum (PAC), polymeric silicate aluminum ferric (PSAF) and poly-aluminum ferric chloride (PAFC) as coagulants were further treated in a lab-scale direct contact evaporation system. The results showed that the best performance with removal efficiencies of COD and NH3-N of 58.70% and 29.09% was achieved after coagulation when PAFC dosage = 15 g/L, PAM dosage = 30 mg/L and initial pH of supernatant = 6. After coagulation, a large amount of the fulvic-like acid and aromatic heterocyclic compounds were removed and the degree of complexity and aromaticity of organics decreased. After direct contact evaporation, using PAFC as coagulant still was the best selection due to its lowest concentrations of COD and NH3-N (22 mg/L and 1.02 mg/L) in the condensate produced by this two-stage treatment when initial pH of supernatant was 6 during evaporation and the condensate produced by this two-stage treatment met the water quality standard for using as supplying water for circulating cooling water system when temperature of hot air used for heating LC was at low temperature (250 °C). The fulvic-like acid and aromatic heterocyclic compounds in the condensate continuously reduced. Phenol, adamantane, 1-isocyanato, phthalic anhydrid, tri(2-chloroethyl) phosphat, Heptadecane, 2-methyl, ginsenol and Octadecane, 2-methyl- in the condensate obviously decreased. The effect of four coagulants as pretreatment on reducing the temperature of hot air used for evaporating LC was ranked as PAFC > PFS > PAC > PSAF. PSAF was not recommended due to the large amount of NH3-N produced when using PSAF to treat the LC.


Subject(s)
Heterocyclic Compounds , Water Pollutants, Chemical , Aluminum , Water Pollutants, Chemical/analysis , Incineration , Aluminum Chloride , Organic Chemicals , Waste Disposal, Fluid/methods
2.
Environ Pollut ; 343: 123271, 2024 Feb 15.
Article in English | MEDLINE | ID: mdl-38160769

ABSTRACT

In order to utilize waste heat such as exhaust steam and hot air passing through air preheater in the waste incineration plant to heat air used for evaporating leachate concentrate (LC) by gas-liquid contact evaporation technology, hot air of 600 °C, 450 °C and 250 °C was used to evaporate LC in a laboratory-scale evaporator to obtain purified condensate used for supplying water for circulating cooling water system. The influence of pH, hot air temperature and evaporation rate on COD and NH3-N in condensate were investigated to identify the optimum operation of this technology. The results showed that COD concentration in condensate obviously decreased with increase in hot air temperature. Higher hot air temperature led to higher initial evaporation temperature, and evaporation rate of water was significantly greater than that of small molecular organic matter with lower boiling point than water with increasing hot air temperature. Reduction in contents of phenol, ketone and benzene was responsible for COD decreasing in condensate. COD in condensate decreased with increase in pH, as the amount of volatile organic matter such as fatty acids escaped from LC to condensate decreased. The pH had little influence on the DOM in condensate according to EEM spectra analysis. Evaporation rate had little influence on COD in the condensate water. NH3-N concentrations in condensate in all experimental groups were far away from the limit value (10 mg/L) in the water quality standard. Under the premise of meeting water quality standard, the lowest temperature (450 °C) of hot air was selected to save energy and use lower grade waste heat. Therefore, the optimum condition was 450 °C of hot air, pH = 7 of LC and CF = 10. At this condition, molecular weight of DOM in the condensate was smaller and humification degree and aromaticity of DOM were lower according to UV-visible absorption spectrum analysis.


Subject(s)
Incineration , Water Pollutants, Chemical , Filtration , Bioreactors , Hot Temperature , Osmosis , Water Pollutants, Chemical/analysis
SELECTION OF CITATIONS
SEARCH DETAIL
...