Biocompatible Perovskite Nanocrystals with Enhanced Stability for White Light-Emitting Diodes.

Recently emerged lead halide perovskite CsPbX3 (X = Cl, Br, and I) nanocrystals (PNCs) have attracted tremendous attention due to their excellent optical properties. However, the poor water stability, unsatisfactory luminescence efficiency, disappointing lead leakage, and toxicity have restricted their practical applications in photoelectronics and biomedical fields. Herein, a controllable encapsulated strategy is investigated to realize CsPbX3 PNCs/PVP @PMMA composites with superior luminescence properties and excellent biocompatibility. Additionally, the synthesized CsPbBr3 and CsPbBr0.6I2.4 PNCs/PVP@PMMA structures exhibit green and red emissions with a maximal photoluminescence quantum yield (PLQY) of about 70.24% and 98.26%, respectively. These CsPbX3 PNCs/PVP@PMMA structures show high emission efficiency, excellent stability after water storage for 18 months, and low cytotoxicity at the PNC concentration at 500 µg mL-1. Moreover, white light-emitting diode (WLED) devices based on mixtures of CsPbBr3 and CsPbBr0.6I2.4 PNCs/PVP@PMMA perovskite structures are investigated, which exhibit excellent warm-white light emissions at room temperature. A flexible manipulation method is used to fabricate the white light emitters based on these perovskite composites, providing a fantastic platform for fabricating solid-state white light sources and full-color displays.

Transformation of crystal structure induced by the temperatures in carbon dots (CDs)-based composites with multicolor fluorescence for white Light-Emitting-Diode (WLED).

Regulation of the fluorescence through crystalizing from the matrix in the Carbon dots (CDs)-based solid-state materials has been verified to be one of the effective methods, yet there are not only challenges in preparing such materials efficiently, but also insufficient insight into their regulation mechanisms. Here, a one-pot solvothermal route to synthesize a series of CDs-based composites with crystalline matrix is reported. These crystals exhibited multicolor fluorescence with the feature of multi-peaks emissions with increasing temperatures from 140 ℃ to 220 ℃, in which the orange emitting O-CDs@PA and the yellow emitting Y-CDs@PA crystals obtained the FLQYs of 22% and 68% respectively due to relatively stable crystalline structures. After comparative analysis to both crystals in detail, the core and the groups associated with them on the interface between CDs and matrix were adjusted in size and species during structural transformation of the crystal matrix, which changes radically the energy band structures to influence fluorescent emitting of both crystals ultimately. In addition, the reasons resulting in higher FLQY for Y-CDs@PA were provided leveraging the schematic illustration presumed based on the PL properties of both crystals. Because of the optimal optical performances, these fluorescent materials promised to fabricate WLED devices and obtained a number of photometric parameters endowed these WLED devices with the feature of warm-white light.

Multicolor emissive sulfur, nitrogen co-doped carbon dots and their application in ion detection and solid lighting.

Multicolor emissive carbon dots (CDs) have potential applications in many fields such as photoelectric display, light-emitting devices, and bioimaging. Such CDs by heteroatom doping of nitrogen elements assisted with various solvents has achieved recently, yet generally low efficiency in red-light region. Herein, we developed a facile route to synthesize multicolor-emissive CDs governed by a solvothermal method of tetrahydrofuran solvent. The maximum emission locates at 432, 510, and 584 nm with the absolute FL QYs up to 21.1%, 11.0%, and 55.4% for selected B-CDs, G-CDs, and YG-CDs, respectively. By means of the analysis on their PL spectra, fluorescence lifetimes, and microstructures, the different graphitic degrees and surface states formed under the participation of S and N elements in as-prepared CDs determine the fluorescent color, and large sp2-conjugated domains within the YR-CDs is closely related to high QY. They, likewise, endow the YR-CDs with high sensitivity for ion detections of Ag+ and Fe3+, which was further illustrated to have different quenching mechanisms each other due to the affinity interaction with different surface groups of the CDs. High PL QYs of these CDs emission are beneficial to application in solid lighting, phosphors dried by these CDs solutions were mixed with PVP water solution to fabricate CDs/PVP films. The films exhibited stable fluorescence, and three phosphors were also mixed together in proportion to obtain white-light film with a CIE coordinates of (0.34, 0.34), which demonstrates that these CDs are potentially fluorescent nanomaterial in the solid-state lighting field.

One-pot synthesis of dual carbon dots using only an N and S co-existed dopant for fluorescence detection of Ag.

Luminescent carbon-based nanoparticles, named often as carbon dots (CDs), were synthesized from citric acid (CA) and guanidine thiocyanate (GITC) via an N and S co-doped hydrothermal procedure. In the present structure characterization, N and S elements could be sufficiently doped by means of the heteroatom or the functional groups bonded on the surface of CDs. The as-prepared CDs solution showed blue color fluorescence under ultraviolet excitation, yet the PL spectra exhibited a repetitive emission process from excitation-independent to excitation-dependent. In view of the triexponential feature of fluorescence lifetimes of CDs, one possibility was proposed to be co-existence of two types of CDs with different surface states. Additionally, the as-prepared CDs were used as a sensing probe for the detection of Ag+ taking into consideration of the possible interactions between Ag+ and various fluorophores attached to the CD surface. As expected, the changes of fluorescence intensities were linearly proportional to the different concentration ranges of Ag+, which suggests the complex nature of the quenching mechanism. And for the first time, the SCN group was found to accelerate the quenching of CDs towards Ag+, promising a new approach for efficient detection of Ag+ for the application in industrial pollutants.

High-Pressure Phases of a S-Based Compound: Dimethyl Sulfide.

The high-pressure behavior of dimethyl sulfide was investigated at room temperature by Raman scattering measurements with pressures up to 30.1 GPa. Phase transitions at 1.3, 3.6-5.8, and 17.2 GPa were found and evidenced by the frequency shifts, pressure coefficients, and changes in fwhm of related modes. These phase transitions were suggested to result from the changes in the inter- and intramolecular bonding of the material. Interestingly, the CH3 groups was compelled to be frozen in positions at a relatively low pressure, suggested by the disappearance of the relative modes softening. In addition, the appearance of lattice mode can also be found at a modest pressure, which makes it possible to gain a superiority for this compound to further investigate the superconductivity with high transition temperatures of bulk hydrogen.

Phase transformations and vibrational properties of coronene under pressure.

Both the vibrational and structural properties of coronene have been investigated upon compression up to 30.5 GPa at room temperature by a combination of Raman scattering and synchrotron x-ray diffraction measurements. The spectroscopic and crystallographic results demonstrate that two pressure-induced structural phase transitions take place at 1.5 GPa and 12.2 GPa where the high-pressure phases are identified as monoclinic and orthorhombic crystal structures with space groups of P2/m and Pmmm, respectively. A kink in the slope of the cell parameters as a function of pressure is associated with the disappearance of several internal Raman modes, which suggests the existence of structural distortions or reorganizations at approximately 6.0 GPa. Above 17.1 GPa, almost no evidence of crystallinity can be observed, indicating a possible transformation of coronene into an amorphous phase.

Structural and vibrational properties of phenanthrene under pressure.

The structural and vibrational properties of phenanthrene are measured at high pressures up to 30.2 GPa by Raman spectroscopy and synchrotron X-ray diffraction techniques. Two phase transitions are observed in the Raman spectra at pressures of 2.3 GPa and 5.4 GPa which correspond to significant changes of intermolecular and intramolecular vibrational modes. Above 10.2 GPa, all the Raman peaks are lost within the fluorescence background; however, upon further compression above 20.0 GPa, three broad peaks are observed at 1600, 2993, and 3181 cm(-1), indicating that phenanthrene has transformed into amorphous phase. Using X-ray diffraction, the structures of corresponding phases observed from Raman spectra are indexed with space groups of P2(1) for phase I (0-2.2 GPa), P2/m for phase II (2.2-5.6 GPa), P2/m+Pmmm for phase III (5.6-11.4 GPa) which has a coexistence of structures, and above 11.4 GPa the structure is indexed with space group of Pmmm. Although phenanthrene has transformed to a hydrogenated amorphous carbon structure above 20.0 GPa, these amorphous clusters still show characteristic crystalline behavior based on our X-ray diffraction patterns. Our results suggest that the long-range periodicity and the local disorder state coexist in phenanthrene at high pressures.

Pressure effect on structural and vibrational properties of Y-substituted BiFeO3.

The structural and vibrational properties of 5% Y-substituted BiFeO3 under pressure have been investigated using synchrotron x-ray diffraction (SXRD) and Raman scattering measurements. At a pressure below 30.3 GPa, distinct changes in the Raman spectra and SRXD pattern show evidence for one pressure-induced structural transition from the polar rhombohedral R3c phase to the nonpolar orthorhombic Pnma phase commencing at 3.6 and completed at 7.2 GPa, where there is a region of phase coexistence between the R3c and Pnma phases. At a higher pressure of 40.8 GPa, another phase transition from orthorhombic to cubic is observed accompanied by the insulator-metal transition. Our data do not suggest the pressure-induced re-entrance of ferroelectricity in the model multiferroic Bi0.95Fe0.05O3 in the pressure range studied.

Vibrational and structural properties of tetramethyltin under pressure.

The vibrational and structural properties of a hydrogen-rich group IVa hydride, Sn(CH(3))(4), have been investigated by combining Raman spectroscopy and synchrotron x-ray diffraction measurements at room temperature and at pressures up to 49.9 GPa. Both techniques allow the obtaining of complementary information on the high-pressure behaviors and yield consistent phase transitions at 0.9 GPa for the liquid to solid and 2.8, 10.4, 20.4, and 32.6 GPa for the solid to solid. The foregoing solid phases are identified to have the orthorhombic, tetragonal, monoclinic crystal structures with space groups of Pmmm for phase I, P4/mmm for phase II, P2/m for phase III, respectively. The phases IV and V coexist with phase III, resulting in complex analysis on the possible structures. These transitions suggest the variation in the inter- and intra-molecular bonding of this compound.

High-pressure study of tetramethylsilane by Raman spectroscopy.

High-pressure behavior of tetramethylsilane, one of the Group IVa hydrides, was investigated by Raman scattering measurements at pressures up to 142 GPa and room temperature. Our results revealed the phase transitions at 0.6, 9, and 16 GPa from both the mode frequency shifts with pressure and the changes of the full width half maxima of these modes. These transitions were suggested to result from the changes in the inter- and intra-molecular bonding of this material. We also observed two other possible phase transitions at 49-69 GPa and 96 GPa. No indication of metallization in tetramethylsilane was found with stepwise compression to 142 GPa.

Clinical patterns of obstructive sleep apnea and its comorbid conditions: a data mining approach.

OBJECTIVES: Obstructive sleep apnea often results in a wide range of comorbid conditions. Although some conditions have been clearly identified as comorbid, a full clinical pattern of associated diseases has not been systematically documented. This research aimed to reveal the full pattern of comorbid conditions associated with OSA by employing a data mining technique. METHODS: A large data repository (the New South Wales inpatient Data Collection) collected between 1999 and 2004 was mined, and all clinical diagnoses were coded with ICD-10-AM codes. RESULTS: A total of 60,197 cases (4% of total records) were identified as related to OSA (72.2% males, 27.8% females). OSA occurrence showed 2 peaks at 0-4 years and 55-59 years. A strikingly low occurrence was observed for the adolescent years. Conditions comorbid with OSA in adults by descending frequency were essential hypertension, obesity, hypercholesterolemia, type 2 diabetes, past or current tobacco use, and ischemic heart conditions. Obesity and OSA showed a similar time course of onset, with a latent period of 5 years for hypertension and type 2 diabetes and 15 years for chronic ischemic heart conditions. Comorbid conditions were predominantly of the cardiovascular, endocrine/metabolic and respiratory systems. The data also indicated OSA patients are high users of health services. CONCLUSIONS: The data mining technique confirms the prevalence of the disease, describes the age distribution patterns and time courses of disease development from obesity and OSAto comorbid conditions, and implicates possible interrelationships among these conditions and high cost of treating OSA patients.