Incorporating germination-induction into decontamination strategies for bacterial spores.

Bacterial spores resist environmental extremes and protect key spore macromolecules until more supportive conditions arise. Spores germinate upon sensing specific molecules, such as nutrients. Germination is regulated by specialized mechanisms or structural features of the spore that limit contact with germinants and enzymes that regulate germination. Importantly, germination renders spores more susceptible to inactivating processes such as heat, desiccation, and ultraviolet radiation, to which they are normally refractory. Thus, germination can be intentionally induced through a process called germination-induction and subsequent treatment of these germinated spores with common disinfectants or gentle heat will inactivate them. However, while the principle of germination-induction has been shown effective in the laboratory, this strategy has not yet been fully implemented in real-word scenarios. Here, we briefly review the mechanisms of bacterial spore germination and discuss the evolution of germination-induction as a decontamination strategy. Finally, we examine progress towards implementing germination-induction in three contexts: biodefense, hospital settings and food manufacture. SIGNIFICANCE AND IMPACT: This article reviews implementation of germination-induction as part of a decontamination strategy for the cleanup of bacterial spores. To our knowledge this is the first time that germination-induction studies have been reviewed in this context. This article will provide a resource which summarizes the mechanisms of germination in Clostridia and Bacillus species, challenges and successes in germination-induction, and potential areas where this strategy may be implemented.

Comparison of sampling methods to recover germinated Bacillus anthracis and Bacillus thuringiensis endospores from surface coupons.

AIMS: In an attempt to devise decontamination methods that are both effective and minimally detrimental to the environment, we evaluated germination induction as an enhancement to strategies for Bacillus anthracis spore decontamination. To determine an optimal method for the recovery of germinating spores from different matrices, it was critical to ensure that the sampling procedures did not negatively impact the viability of the germinating spores possibly confounding the results and downstream analyses of field trial data. METHODS AND RESULTS: Therefore, the two main objectives of this study were the following: (i) development of an effective processing protocol capable of recovering the maximum number of viable germinating or germinated spores from different surface materials; and (ii) using a model system of spore contamination, employ this protocol to evaluate the potential applicability of germination induction to wide-area decontamination of B. anthracis spores. We examined parameters affecting the sampling efficiencies of B. anthracis and the surrogate species Bacillus thuringiensis on nonporous and porous materials. CONCLUSIONS: The most efficient extraction from all matrices was observed using PBS with 0·01% Tween 80 extraction buffer. The addition of a sonication and/or extended vortex treatment did not yield significant increases in spore or germinated spore recovery. SIGNIFICANCE AND IMPACT OF THE STUDY: Our data demonstrate that previous germination-induction experiments performed in suspension can be reproduced when Bacillus spores are deposited onto reference surfaces materials. Our proof of concept experiment illustrated that a germination pretreatment step significantly improves conventional secondary decontamination strategies and remediation plans.

Administration of an insulin powder to the lungs of cynomolgus monkeys using a Penn Century insufflator.

A powder formulation of live-attenuated measles vaccine is being developed for administration to the lungs. The safety and efficacy of the powder will be assessed by insufflation into cynomolgus monkeys. A Penn Century insufflator has been evaluated for powder dosing to the monkeys using an insulin formulation having similar physicochemical characteristics to the vaccine powder. Insulin pharmacokinetics were compared following dosing by powder insufflation, solution instillation into the trachea and subcutaneous injection. The insulin dosed to the lungs and trachea was more rapidly absorbed than that administered subcutaneously. Insulin bioavailability was greater from the inhaled powder than from the instilled solution. The findings confirm that the Penn Century device is suitable for vaccine powder dosing to the deep lung.

Modifying the release of leuprolide from spray dried OED microparticles.

A range of oligosaccharide ester derivatives (OEDs) have been designed as drug delivery matrices for controlled release. The synthetic hormone analogue, leuprolide, was encapsulated within these matrices using hydrophobic ion pairing and solvent spray drying. The particles produced modified the release of leuprolide in vitro (dissolution in phosphate buffered saline) and in vivo (subcutaneous and pulmonary delivery in the rat). Release rate was dependent on drug loading and could be manipulated by choice of OED and by combining different OEDs in different ratios. Leuprolide encapsulated in the OEDs retained biological activity as evidenced by elevation in plasma luteinising hormone levels following subcutaneous injection of leuprolide recovered from OED particles in vitro prior to in vivo administration.

Production of recombinant human serum albumin from Saccharomyces cerevisiae.

Human serum albumin has been constitutively expressed in a Saccharomyces cerevisiae brewing yeast. After cell growth and disruption the product was associated with the insoluble fraction and represented approximately 1% of total cell protein. After the cell debris was extensively washed, the albumin was solubilized with 8 M urea and 28 mM 2-mercaptoethanol in 50 mM sodium carbonate buffer, pH 10. The denatured albumin was refolded by dialysis and further purified by anion exchange and gel filtration chromatography. Losses of renatured material could be reduced, or higher protein concentrations used during refolding, if the denatured product was purified by cation-exchange chromatography in urea prior to refolding. Apart from an additional N-terminal N-acetyl methionine, the refolded product proved identical to human serum albumin derived from plasma when compared by a variety of physical, chemical, and biological analytical methods.

Refolding human serum albumin at relatively high protein concentration.

The conditions for refolding reduced and denatured human serum albumin (HSA) were investigated with a view to maximising the yield of native monomeric albumin. Refolding by dialysis was found to be preferable to dilution as a means of chaotrope (urea) and reductant (2-mercaptoethanol) removal. Dialysis of denatured HSA solutions containing 4-8 M urea and 14 mM 2-mercaptoethanol at pH 10.0 was found to be optimal for HSA refolding. The yield of monomeric HSA was maximal (94%) for dialysis in the presence of EDTA (1 mM) and sodium palmitate (20 microM). Using this protocol it was possible to refold HSA at concentrations in excess of 5 mg.ml-1 whilst maintaining a high recovery of native monomer. These results represent a considerable improvement on established methods of HSA refolding.

The identity of Escherichia coli bacterioferritin and cytochrome b1.

Two different procedures were used to prepare pure samples of 'cytochrome b1' (column chromatography) and 'bacterioferritin' (immunoprecipitation) from Escherichia coli K-12 strain CA265. Both were crystallized, and X-ray-crystallographic data were compared with those from the bacterioferritin of E. coli strain W3300 used as a standard. We conclude that 'cytochrome b1' and 'bacterioferritin' are identical.

Investigation of cadmium resistance in an Alcaligenes sp.

The mechanisms of metal resistance of a cadmium-resistant Alcaligenes sp. were studied. Growth in a defined medium was unaffected by cadmium at concentrations up to 0.1 mM, while at concentrations up to 2.5 mM, growth occurred after an extended lag phase. The increase in length of the lag phase was abolished by repeated subculturing at these higher concentrations. However, subculture in the absence of cadmium reversed the adaptation process. Plasmid DNA was not detected in adapted cells, suggesting that adaptation is not plasmid mediated. Increased sulfide production in response to cadmium was observed, although the levels were too low to account fully for cadmium resistance. Adaptation of cells to cadmium resulted in the appearance of a major new membrane protein (molecular weight, 34,500) whose presence was not dependent upon the method of membrane preparation. This protein was induced at cadmium concentrations of 0.1 mM and above, but below this level the protein was absent. The onset of growth at concentrations above 0.1 mM was coincident with the appearance of this protein, which was also induced by zinc (0.4 mM) but not by manganese or nickel. The protein was only solubilized by a sodium dodecyl sulfate-2-mercaptoethanol mixture. Similar solubility properties were shown by a second major membrane protein (molecular weight, 33,000). These two proteins proved to be similar by peptide-mapping experiments and amino acid analysis. The appearance of the 34,500-molecular-weight protein and its possible role in cadmium resistance are discussed.

Growth and adaptation of Saccharomyces cerevisiae at different cadmium concentrations.

The effect of 0, 5, 10 and 25 mg l-1 cadmium on the growth of Saccharomyces cerevisiae in defined medium has been investigated. It was found that the length of the lag phase increased with cadmium concentration and that metal uptake during the lag phase occurred only at a cadmium concentration of 25 mg l-1. However, metal uptake occurred at all cadmium concentrations during the exponential phase. The yeast was gradually adapted to cadmium by a series of subcultures which resulted in a decrease in the length of the lag phase. Adaptation also caused a reduction in the cadmium uptake during the lag phase at 25 mg l-1 cadmium but did not affect uptake during the exponential phase at any concentration. A single passage through cadmium-free medium partially reversed the adaptation process. Sulphide production was enhanced significantly when the yeast was grown in the presence of increasing cadmium concentrations. However, at 5 mg l-1 cadmium, adapted cells produced less sulphide than unadapted cells, whilst at 10 and 25 mg l-1 cadmium the production of sulphide was similar for adapted and unadapted cells.

Degradation of 4-Chlorobenzoic Acid by Arthrobacter sp.

A mixed population, enriched and established in a defined medium, from a sewage sludge inoculum was capable of complete mineralization of 4-chlorobenzoate. An organism, identified as Arthrobacter sp., was isolated from the consortium and shown to be capable of utilizing 4-chlorobenzoate as the sole carbon and energy source in pure culture. This organism (strain TM-1), dehalogenated 4-chlorobenzoate as the initial step in the degradative pathway. The product, 4-hydroxybenzoate, was further metabolized via protocatechuate. The ability of strain TM-1 to degrade 4-chlorobenzoate in liquid medium at 25 degrees C was improved by the use of continuous culture and repeated sequential subculturing. Other chlorinated benzoates and the parent compound benzoate did not support growth of strain TM-1. An active cell extract was prepared and shown to dehalogenate 4-chloro-, 4-fluoro-, and 4-bromobenzoate. Dehalogenase activity had an optimum pH of 6.8 and an optimum temperature of 20 degrees C and was inhibited by dissolved oxygen and stimulated by manganese (Mn). Strain improvement resulted in an increase in the specific activity of the cell extract from 0.09 to 0.85 nmol of 4-hydroxybenzoate per min per mg of protein and a decrease in the doubling time of the organism from 50 to 1.6 h.

The origin of the oxygen incorporated during the dehalogenation/hydroxylation of 4-chlorobenzoate by an Arthrobacter sp.

An Arthrobacter sp. has been shown to dehalogenate 4-chlorobenzoate yielding 4-hydroxybenzoate. Experiments with 18O indicate that, in the presence of cell-free extracts, the hydroxyl group which is substituted onto the aromatic nucleus during dehalogenation is derived from water and not from molecular oxygen. Dehalogenation therefore is not catalysed by a mixed-function oxidase; instead a novel aromatic hydroxylase is implicated in the reaction.

The effect of carbon dioxide on the production of an extracellular nuclease of Staphylococcus aureus.

The production of the extracellular nuclease secreted by Staphylococcus aureus (Foggi strain) was studied in a fermentor in an attempt to improve yield and allow large-scale production of the enzyme. In shake flask cultures, 600 units/mL of the enzyme were produced routinely. However, only 450 units/mL of the enzyme at best were obtained in a small-scale fermentor (3 L). The supplementation of the air supply to the fermentor with carbon dioxide [20% (v/v)] increased levels of enzyme in the culture medium to 770 units/mL. Subsequently, this result was reproduced in larger fermentors (10 and 150 L). The possible mechanisms of the effect of carbon dioxide upon the growth of Staphylococcus aureus (Foggi) and the production of the enzyme are discussed.

Partial purification of a low molecular weight inhibitor of epidermal DNA synthesis.

An attempt has been made to purify factors present in aqueous extracts of pig epidermis which inhibit epidermal cell proliferation. A lipophilic factor of low molecular weight (less than 10,000), has been shown to inhibit DNA synthesis as measured by the uptake of tritiated thymidine in mouse ear epidermis. Purification by alcohol precipitation, ethyl acetate extraction and silicic acid column chromatography produced a fifteen-fold increase in the specific activity of the inhibitory action. It seems likely that aggregation or absorption of this low molecular weight factor may explain the high molecular weight of epidermal cell proliferation inhibitors previously studied, as well as the difficulty in their characterization.

Properties of phage-receptor lipopolysaccharide from Pseudomonas morsprunorum.

Lipopolysaccharide (LPS) of Pseudomonas morsprunorum was extracted with hot phenol and purified by repeated centrifuging followed by either block electrophoresis or gel filtration. LPS from a virulent isolate exhibited specific phage inactivation (PI50 = 0.05 mug LPS ml-1), whereas LPS from an avirulent phage-resistant mutant did not. LPS was considered pure when a single band was detected following sodium dodecyl sulphate-cellulose acetate electrophoresis (pH 7.4). It was not phytotoxic when inoculated into cherry leaves at concentrations up to I mg ml-1, but produced weak chlorosis in bean and tobacco at 2 mg ml-1: no visible symptoms appeared after treatment with lower concentrations. The chemical composition of the LPS was partly determined.