Combined monitor for direct and indirect measurement of biofouling.

Biofouling is one of the most important problems associated with heat exchangers, leading to a loss of thermal performance in their cycle. To maintain them in optimum working condition, biofouling must be kept under control and, to do so, instrumentation is required for its monitoring. The development of the biofouling layer can be qualitatively followed, but only during maintenance shutdown periods is it possible to attain a quantitative assessment. The CMDIMB [Combined Monitor for Direct and Indirect Measurement of Biofouling] was conceived as a means of discovering the evolution of the frictional resistance (f) and the heat transfer resistance (R(f)) of a fluid because these are variables that indirectly define the biofouling deposited in the tubes of a seawater-cooled heat exchanger. They likewise serve to directly indicate its mass and thickness according to the total solid matter adhered over time. The results obtained allowed the values of the variables taken by the CMDIMB to be extrapolated to the heat exchanger that was set up in parallel. The CMDIMB is proposed as a highly useful tool for directly and indirectly monitoring biofouling growth in heat exchangers that do not possess the necessary instrumentation to monitor this phenomenon.

Optimisation of biocide dose as a function of residual biocide in a heat exchanger pilot plant effluent.

Biofouling is one of the most serious problems facing numerous industrial processes. In the case of a heat exchanger unit, biological deposits adhering to the inside surface of its tubes reduce heat transfer and, thus, the thermal performance of the cycle. Control of this phenomenon is proving fundamental for both land and marine equipment to operate in optimum working conditions. Hence, it is necessary to apply antifouling methods capable of keeping surfaces free of any kind of biofouling. This paper reports on the behaviour resulting from use of the flow inversion method vs that obtained by using various chemical treatments. The study compares the effectiveness of certain chemical treatments (Na hypochlorite, peracetic acid and a compound formed by Na bromide + Na hypochlorite) for removing a biofouling film that has already formed on the inside surfaces of tubes in a heat exchanger pilot plant. The paper also addresses the issue of optimising the concentration of biocide dose as a function of the residual biocide in order minimise the environmental impact caused by effluent from industrial plants. The results indicate that it is possible to eliminate a biofilm formed on the inside surfaces of tubes by the use of intermittent doses of chemical treatments at low concentrations and over long application times. Furthermore, once the stabilisation phase is reached 6 d after starting the treatment, it is possible to maintain the conditions achieved using only 20% of the initial dosage.