Package-Less Liquid Phase Sensing Using Surface Acoustic Waves on Lithium Tantalate Oxide.

Surface acoustic wave (SAW) transducers propagating shear waves are compatible with sensing chemical compounds in a liquid phase. However, if the liquid surrounding the sensor possesses a higher permittivity than the piezoelectric substrate, then the interdigitated electrodes for converting the incoming electromagnetic wave to acoustic waves are susceptible to capacitive short-circuiting, leading to excessive insertion losses. By using high-permittivity lithium tantalate oxide (LTO), we demonstrate chemical sensing in water without the need for dedicated microfluidic packaging. Nevertheless, the gravimetric sensitivity of these package-less transmission Love-mode delay lines remains comparable to that of low-permittivity quartz when appropriately tuning the guiding layer of thin film to confine energy to the surface in a Love mode. We extend the transmission line gravimetric sensitivity measurement to a reflective delay line geometry for passive transducers that can be wirelessly probed. For instance, ground-penetrating radar (GPR) can be used for subsurface sensing, here targeting water pollution detection, operating in the 100-500-MHz range. This center frequency was selected as a tradeoff between penetration depth (lower frequency) and antenna size (smaller at higher frequency). Nonspecific binding of proteins detection is shown in the context of biosensing applications.

Degradation of Sub-Micrometer Sensitive Polymer Layers of Acoustic Sensors Exposed to Chlorpyrifos Water-Solution.

The detection of organophosphates, a wide class of pesticides, in water-solution has a huge impact in environmental monitoring. Acoustic transducers are used to design passive wireless sensors for the direct detection of pesticides in water-solution by using tailored polymers as sensitive layers. We demonstrate by combining analytical chemistry tools that organophosphate molecules strongly alter polymer layers widely used in acoustic sensors in the presence of water. This chemical degradation can limit the use of these polymers in detection of organophosphates in water-solution.

Subsurface H2S Detection by a Surface Acoustic Wave Passive Wireless Sensor Interrogated with a Ground Penetrating Radar.

Long-term monitoring of organic pollutants in the soil is a major environmental challenge. We propose to meet this issue by the development of a polymer dedicated to selectively react with H2S, coating surface acoustic wave transducers designed as passive cooperative targets with the compound, and probing their response using Ground Penetrating RADAR, thus providing the capability to monitor the presence of H2S in the subsurface environment. The selectivity is brought by including lead(II) cation in a reticulated polymer matrix which can be deposited as a thin layer on a surface acoustic wave sensor. We demonstrate a signal enhancement mechanism in which water absorption magnifies the signal detection, making the sensor most sensitive to H2S in an underground environment saturated with moisture.

Micro-nano-bio acoustic system for the detection of foodborne pathogens in real samples.

The fast and efficient detection of foodborne pathogens is a societal priority, given the large number of food-poisoning outbreaks, and a scientific and technological challenge, given the need to detect as little as 1 viable cell in 25 gr of food. Here, we present the first approach that achieves the above goal, thanks to the use of a micro/nano-technology and the detection capability of acoustic wave sensors. Starting from 1 Salmonella cell in 25 ml of milk, we employ immuno-magnetic beads to capture cells after only 3 h of pre-enrichment and subsequently demonstrate efficient DNA amplification using the Loop Mediated Isothermal Amplification method (LAMP) and acoustic detection in an integrated platform, within an additional ½ h. The demonstrated 4 h sample-to-analysis time comes as a huge improvement to the current need of few days to obtain the same result. In addition, the work presents the first reported Lab-on-Chip platform that comprises an acoustic device as the sensing element, exhibiting impressive analytical features, namely, an acoustic limit of detection of 2 cells/µl or 3 aM of the DNA target and ability to detect in a label-free manner dsDNA amplicons in impure samples. The use of food samples together with the incorporation of the necessary pre-enrichment step and ability for multiple analysis with an internal control, make the proposed methodology highly relevant to real-world applications. Moreover, the work suggests that acoustic wave devices can be used as an attractive alternative to electrochemical sensors in integrated platforms for applications in food safety and the point-of-care diagnostics.

Acoustic Transducers as Passive Cooperative Targets for Wireless Sensing of the Sub-Surface World: Challenges of Probing with Ground Penetrating RADAR.

Passive wireless transducers are used as sensors, probed by a RADAR system. A simple way to separate the returning signal from the clutter is to delay the response, so that the clutter decays before the echoes are received. This can be achieved by introducing a fixed delay in the sensor design. Acoustic wave transducers are ideally suited as cooperative targets for passive, wireless sensing. The incoming electromagnetic pulse is converted into an acoustic wave, propagated on the sensor substrate surface, and reflected as an electromagnetic echo. According to a known law, the acoustic wave propagation velocity depends on the physical quantity under investigation, which is then measured as an echo delay. Both conversions between electromagnetic and acoustic waves are based on the piezoelectric property of the substrate of which the sensor is made. Investigating underground sensing, we address the problems of using GPR (Ground-Penetrating RADAR) for probing cooperative targets. The GPR is a good candidate for this application because it provides an electromagnetic source and receiver, as well as echo recording tools. Instead of designing dedicated electronics, we choose a commercially available, reliable and rugged instrument. The measurement range depends on parameters like antenna radiation pattern, radio spectrum matching between GPR and the target, antenna-sensor impedance matching and the transfer function of the target. We demonstrate measurements at depths ranging from centimeters to circa 1 m in a sandbox. In our application, clutter rejection requires delays between the emitted pulse and echoes to be longer than in the regular use of the GPR for geophysical measurements. This delay, and the accuracy needed for sensing, challenge the GPR internal time base. In the GPR units we used, the drift turns out to be incompatible with the targeted application. The available documentation of other models and brands suggests that this is a rather general limitation. We solved the problem by replacing the analog ramp generator defining the time base with a fully digital solution, whose time accuracy and stability relies on a quartz oscillator. The resulting stability is acceptable for sub-surface cooperative sensor measurement.

Micro-Nano-Bio Diagnostic System for Food Pathogen Detection Revolutionizes Food Safety Management & Protects Consumers Health.

The development of integrated, fast and affordable platforms for pathogen detection is an emerging area where a multidisciplinary approach is necessary for designing microsystems employing miniaturized devices; these new technologies promise a significant advancement of the current state of analytical testing leading to improved healthcare. In this work, the development of a lab-on-chip microsystem platform for the genetic analysis of Salmonella in milk samples is presented. The heart of the platform is an acoustic detection biochip, integrated with a microfluidic module. This detection platform is combined with a micro-processor, which, alongside with magnetic beads technology and a DNA micro-amplification module, are responsible for performing sample pre-treatment, bacteria lysis, nucleic acid purification and amplification. Automated, multiscale manipulation of fluids in complex microchannel networks is combined with novel sensing principles developed by some of the partners. This system is expected to have a significant impact in food-pathogen detection by providing for the first time an integrated detection test for Salmonella screening in a very short time. Finally, thanks to the low cost and compact technologies involved, the proposed set-up is expected to provide a competitive analytical platform for direct application in field settings.

High-sensitivity open-loop electronics for gravimetric acoustic-wave-based sensors.

Detecting chemical species in gas phase has recently received an increasing interest mainly for security control, trying to implement new systems allowing for extended dynamics and reactivity. In this work, an open-loop interrogation strategy is proposed to use radio-frequency acoustic transducers as micro-balances for that purpose. The resulting system is dedicated to the monitoring of chemical compounds in gaseous or liquid-phase state. A 16 Hz standard deviation is demonstrated at 125 MHz, with a working frequency band in the 60 to 133 MHz range, answering the requirements for using Rayleigh- and Love-wave-based delay lines operating with 40-µm acoustic wavelength transducers. Moreover, this electronic setup was used to interrogate a high-overtone bulk acoustic wave resonator (HBAR) microbalance, a new sensor class allowing for multi-mode interrogation for gravimetric measurement improvement. The noise source still limiting the system performance is due to the analog-to-digital converter of the microcontroller, thus leaving open degrees-of-freedom for improving the obtained results by optimizing the voltage reference and board layout. The operation of the system is illustrated using a calibrated galvanic deposition at the surface of Love-wave delay lines to assess theoretical predictions of their gravimetric sensitivity and to compare them with HBAR-based sensor sensitivity.