Subchondral trabecular structural changes in the proximal tibia in an ovine model of increased bone turnover.

Ovariectomized (OVX) sheep are now considered to be useful models for a variety of metabolic bone disorders. The specific aim of this study was to determine the effects of ovariectomy on the structural parameters and material density of the subchondral bone of the ovine tibial plateau as measured by microcomputed tomography (MicroCT). Twenty-three sheep were examined in this study; 10 of the sheep underwent ovariectomy (OVX), and the remainder (n=13) were kept as controls (CON). These animals were then sacrificed at 12 months post-operatively. Three-dimensional analyses were performed of osteochondral samples (15 mm deep) which were obtained from the medial tibial plateau using MicroCT. Bone volume fraction of the subchondral trabecular bone was reduced in the ovariectomized sheep as compared to control animals (0.439 vs. 0.483, P=0.038). Trabeculae were also significantly thinner in the OVX group (0.220 vs. 0.252 mm, P=0.010), with reduced connectivity density (7.947 vs. 11.524 mm(-3) , P=0.014). There was a trend towards lower numbers of individual trabeculae present in the OVX group as compared to controls, but this did not reach significance (2.817 vs. 3.288 mm(-1) , P=0.1). There was also increased trabecular separation in the OVX group, which again fell short of significance (0.426 vs. 0.387 mm, P=0.251). There was no difference in hydroxyapatite concentration (HA) between the two groups (929 vs. 932 mgHA cm(-3) , P=0.687). In conclusion, significant alterations of the trabecular architecture under the tibial plateau were observed following 12 months of oestrogen-deficiency in this ovine model. Despite these marked morphological and structural density differences, the material densities were equal in the two groups.

On the fit of statistical and the k-C* models to projecting treatment performance in a constructed wetland system.

The objective of this study was to assess the suitability of statistical and the k-C* models to projecting treatment performance of constructed wetlands by applying the models to predict the final effluent concentrations of a pilot field-scale constructed wetlands system (CWs) treating animal farm wastewater. The CWs achieved removal rates (in g/m(2).d) ranging from 7.1-149.8 for BOD(5), 49.8-253.8 for COD and 7.1-47.0 for NH(4)-N. Generally, it was found that the statistical models developed from multiple regression analyses (MRA) were stronger in predicting final effluent concentrations than the k-C* model. However, both models were inadequate in predicting the final effluent concentrations of NO(3)-N. The first-order area-based removal rate constants (k, m/yr) determined from the experimental data were 200.5 for BOD(5), 80.1 for TP and 173.8 for NH(4)-N and these indicate a high rate of pollutant removal within the CWs.

Performance evaluation and prediction for a pilot two-stage on-site constructed wetland system employing dewatered alum sludge as main substrate.

Dewatered alum sludge, a widely generated by-product of drinking water treatment plants using aluminium salts as coagulants was used as main substrate in a pilot on-site constructed wetland system treating agricultural wastewater for 11 months. Treatment performance was evaluated and spreadsheet analysis was used to establish correlations between water quality variables. Results showed that removal rates (in g/m(2)d) of 4.6-249.2 for 5 day biochemical oxygen demand (BOD(5)), 35.6-502.0 for chemical oxygen demand (COD), 2.5-14.3 for total phosphorus (TP) and 2.7-14.6 for phosphate (PO(4)P) were achieved. Multiple regression analysis showed that effluent BOD(5) and COD can be predicted to a reasonable accuracy (R(2)=0.665 and 0.588, respectively) by using input variables which can be easily monitored in real time as sole predictor variables. This could provide a rapid and cheap alternative to such laborious and time consuming analyses and also serve as management tools for day-to-day process control.

The effects of estrogen deficiency and bisphosphonate treatment on tissue mineralisation and stiffness in an ovine model of osteoporosis.

While much research has been dedicated to understanding osteoporosis, the nature of mineral distribution and the mechanical property variation in diseased bone is poorly understood. The current study aimed to determine the effect of estrogen deficiency and bisphosphonate therapy on bone tissue properties using an ovine model of osteoporosis. Skeletally mature animals (4+ years) were divided into an ovariectomy group (ovx, n=20) and a non treatment control group (control, n=20). A zoledronic acid treated group was also included in which animals were estrogen deficient for 20 months prior to receiving treatment (Zol, n=4). Half of the control and ovx groups were euthanized 12 or 31 months post-operatively and all Zol animals were euthanised at 31 months. Individual trabeculae were removed from the proximal femur and were analysed at specific locations across the width of the trabeculae. The mineral content was measured using quantitative backscatter electron imaging and the modulus was measured using nanoindentation. The spatial distribution of tissue modulus and mineral content in bone from ovariectomised animals was similar to control. However, ovariectomy significantly reduced the overall mineral content and tissue modulus relative to the control group after 12 months. Interestingly, significant differences were not maintained 31 months post-OVX. Treatment with zoledronic acid increased the mineral content and tissue modulus relative to both the ovariectomised and control groups. Zoledronic acid was also found to alter the mineral and modulus gradients normally associated with healthy bone tissue. The current study provides evidence that both estrogen deficiency and zoledronic acid therapy significantly alter mineral content and the mechanical properties of trabecular tissue.

Biomechanical properties across trabeculae from the proximal femur of normal and ovariectomised sheep.

The elastic behaviour of trabecular bone is a function not only of bone volume and architecture, but also of tissue material properties. Variation in tissue modulus can have a substantial effect on the biomechanical properties of trabecular bone. However, the nature of tissue property variation within a single trabecula is poorly understood. This study uses nanoindentation to determine the mechanical properties of bone tissue in individual trabeculae. Using an ovariectomised ovine model, the modulus and hardness distribution across trabeculae were measured. In both normal and ovariectomised bone, the modulus and hardness were found to increase towards the core of the trabeculae. Across the width of the trabeculae, the modulus was significantly less in the ovariectomised bone than in the control bone. However, in contrast to this hardness was found not to differ significantly between the two groups. This study provides valuable information on the variation of mechanical material properties in healthy and diseased trabecular bone tissue. The results of the current study will be useful in finite element modelling where more accurate values of trabecular bone modulus will enable the prediction of the macroscale behaviour of trabecular bone.

Biomechanical comparison of the pullout properties of external skeletal fixation pins in the tibiae of intact and ovariectomised ewes.

The pin-bone interface is the least stable component of the external skeletal fixator. Concerns exist regarding the ability to obtain adequate implant purchase in poor quality bone. Consequently, reduced bone quality has been viewed as a contra-indication for the use of external skeletal fixators. The aim of this study was to investigate the holding power of two different fixator pin designs in bone from entire and ovariectomised sheep. Thirty-two aged ewes were divided into two groups. Group 1 were controls, and Group 2 were ovariectomised (OVX). The ewes were sacrificed 12 months post-ovariectomy and five pairs of tibiae were harvested from each group. The holding power of cortical and cancellous fixator pins was assessed at five standardised locations on each tibia. An increase in mean cortical thickness was noted in the OVX group. The holding power of cancellous fixator pins was superior to that of cortical pins, irrespective of whether or not ovariectomy had been performed. Cancellous pins had an increased holding power in post ovariectomy bone compared to control bone. Cortical pin performance was not affected by ovariectomy. There was a lack of correlation between the incidence of insertional fractures of the far cortex and implant holding power. The results raise questions over the effectiveness of ovariectomy in establishing osteopaenic bone suitable for assessing implant performance, hence further investigations are warranted.

An avian model of limb deviation induced by periosteal surgery.

A model of limb deviation induced by hemi-circumferential periosteal stripping of the distal tibiotarsus of domestic chicks is described. This model has been developed to study the effects of periosteal stripping on the cellular, mechanical, vascular, and biochemical status of the immature bone and growth plate. It is hoped that such studies may further elucidate the mechanisms involved in altered bone growth following periosteal stripping techniques which are used in human and equine orthopaedics for the management of leg length discrepancies and angular limb deformities respectively (Auer and Martens 1980, Warrell and Baker 1987). Hemi-circumferential periosteal stripping of the left distal tibiotarsus of 28-day-old chicks resulted in significant change in metaphyseal-diaphyseal angle with time, compared to both the controls and the untreated right legs (P<0.0001). This model of limb deviation developed rapidly and consistently, and the procedures were well tolerated by the birds over the short survival time (maximum 28 days).