Sorption of 2,4-dinitroanisole (DNAN) on lignin.

The present study describes the use of two commercially available lignins, namely, alkali and organosolv lignin, for the removal of 2,4-dinitroanisole (DNAN), a chemical widely used by the military and the dye industry, from water. Sorption of DNAN on both lignins reached equilibrium within 10 hr and followed pseudo second-order kinetics with sorption being faster with alkali than with organosolv lignin, i.e. k2 10.3 and 0.3 g/(mg x hr), respectively. In a separate study we investigated sorption of DNAN between 10 and 40 degrees C and found that the removal of DNAN by organosolv lignin increased from 0.8 to 7.5 mg/g but reduced slightly from 8.5 to 7.6 mg/g in the case of alkali lignin. Sorption isotherms for either alkali or organosolv lignin best fitted Freundlich equation with enthalpy of formation, deltaH0 equaled to 14 or 80 kJ/mol. To help understand DNAN sorption mechanisms we characterized the two lignins by elemental analysis, BET nitrogen adsorption-desorption and 31P NMR. Variations in elemental compositions between the two lignins indicated that alkali lignin should have more sites (O- and S-containing functionalities) for H-bonding. The BET surface area and calculated total pore volume of alkali lignin were almost 10 times greater than that of organosolv lignin suggesting that alkali lignin should provide more sites for sorption. 31P NMR showed that organosolv lignin contains more phenolic -OH groups than alkali lignin, i.e., 70% and 45%, respectively. The variations in the type of OH groups between the two lignins might have affected the strength of H-bonding between DNAN and the type of lignin used.

Underpotential deposition of hydrogen on benzene-modified Pt(111) in aqueous H2SO4.

The Pt(111) electrode is modified by an overlayer of C6H6 (ads) upon its cycling in the 0.05-0.80 V range in aq H2SO4 + 1 mM C6H6. The C6H6 (ads) overlayer significantly changes the underpotential-deposited H (H(UPD)) and anion adsorption, and cyclic-voltammetry (CV) profiles show a sharp cathodic peak and an asymmetric anodic one in the 0.05-0.80 V potential range. The C6H6 (ads) layer blocks the (bi)sulfate adsorption but facilitates the adsorption of one monolayer of H(UPD). Cycling of the benzene-modified Pt(111) in benzene-free aq 0.05 H2SO4 from 0.05 to 0.80 V results in a partial desorption of C6H6 (ads) and in a partial recovery of the CV profile characteristic of an unmodified Pt(111). The peak potential of the cathodic and anodic feature is independent of the scan rate, s (10 < or = s < or = 100 mV s(-1)), and the peak current density increases linearly with an increase of the scan rate. Temperature variation modifies the peak potential and current density but does not affect the charge density of the cathodic or anodic feature. Temperature-dependent studies allow us to determine the thermodynamic state function for the H(UPD) adsorption and desorption. Delta G degrees(ads)(H(UPD))assumes values from -4 to -12 kJ mol(-1), while has values from 9 to 14 kJ mol(-1). The values of delta Delta G degrees (delta Delta G degrees = delat Delta G degrees(ads) + delta Delta D degrees(des)) decrease almost linearly from 6 kJ mol(-1) at theta(H(UPD) --> 0 to 0 kJ mol(-1) at theta(H(UPD) --> 1. The nonzero values of delta Delta G degrees testify that the adsorbing and desorbing H(UPD) adatoms interact with an energetically different substrate. The lateral interactions changed from repulsive (omega = 29 kJ mol(-1) at theta(H(UPD) --> 0) to attractive (omega = -28 kJ mol(-1) at theta(H(UPD) --> 1) as the H(UPD) coverage increases. The values of delta S degrees(ads)(H(UPD)) increase from 19 to 56 J K(-1) mol(-1), while those of delta S degrees(des)(H(UPD)) decrease from 45 to -30 J K(-1) mol(-1) with an increase of H(UPD) coverage. The values of delta H degrees(des)(H(UPD)) and delta H degrees(des)(H(UPD)) vary from 0 to 27 kJ mol(-1). The Pt(111)-H(UPD) surface bond energy at the benzene-modified Pt(111) electrode falls in the 191-218 kJ mol(-1) range and is weaker than in the case of the unmodified Pt(111) electrode in the same electrolyte.